3. A 50-ton, 6-m diameter hemispherical dome on a level surface is filled with water as shown in figure. An engineer claims that be can left this dome by attaching a long tube to the top and filling it with water. So, the required height of water h in the tube to lift the dome is the weight of the tube and water therein. . Ignore a) 0.47 m b) 7.4 m c) 3.765 m d) 0.935 m 5ọ ton Water 6 m

3. A 50-ton, 6-m diameter hemispherical dome on a level surface is filled with water as shown in figure. An engineer claims that be can left this dome by attaching a long tube to the top and filling it with water. So, the required height of water h in the tube to lift the dome is the weight of the tube and water therein. . Ignore a) 0.47 m b) 7.4 m c) 3.765 m d) 0.935 m 5ọ ton Water 6 m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A 1.5m square tank, 3m tall is drained by a 25mm-diameter orifice located at its bottom. If the tank is initially filled with water, how deep is the water in the tank after 45 minutes? Assume C=0.62
A piezometer is placed in a field at a depth of 20 ft below the ground surface. The pressure head is 21 ft and a reference line for the gravitational head is assumed to be 10 ft from the bottom end of the piezometer. What is the hydraulic head? Answer should be 31ft
.
A cylindrical tank with a large diameter is filled with water to a depth D = 0.416 m. A hole of cross-sectional area A = 7.83 cm? in the bottom of the tank allows water to drain out. (a) What is the rate at which water flows out, in cubic meters per second? (b) At what distance below the bottom of the tank is the cross-sectional area of the stream equal to one-half the area of the hole? (a) Number i Units (b) Number i Units
An open, clean glass tube (0 = 0) is inserted vertically into a pan of water. The surface tension of water is 7.34 x 10-2 N/m. What tube diameter is needed if the water level in the tube is to rise one tube diameter (due to surface tension)?
Q3: A right circular cone has the radius of the base and the height which at a given instant (to) are r =25cm and h=35 cm, respectively. If (h) is increasing at a rate of 2 cm/ sec and (r) is increasing at a rate of 1 cm/ sec. Find the rate at which the volume of the cone changes.
Consider a large cubic ice block floating in seawater. The specific gravities of ice and seawater are 0.92 and 1.025, respectively. If a 15-cm-high portion of the ice block extends above the surface of the water, determine the height of the ice block below of the surface. Sea Ice block W FB
A hollow cylinder 1.72-m in diameter and 6-m long weighs 3,046 N. How many cubic meters (m3) of metal weighing 102 kN/m3 must be placed inside the cylinder such that 1.1 m. of the cylinder is protruding above the liquid surface? The hollow cylinder is submerged in a liquid that has a specific gravity of 2.7. Round off to four decimal places.
The components of the velocity field is given as u = 0.2 + 0.9x + 0.8y v = -0.5 + 0.9x – 0.9y Calculate the acceleration at point x,y=(0,1) Is this flow field rotational or irrotational? Show. Is this flow compressible or incompressible? Show.
A conical tank is inclined with an angle of 60°. A hole with radius 2-in was opened at the bottom. If initially the tank is full to a height of 9 ft, how long will the tank drain? Consider a coefficient of contraction, 0.6.