3. A 30-mm-diameter copper rod is 1 m long with a yield strength of 70 MPa. Determine the axial force necessary to cause the diameter of the rod to reduce by 0.01 percent, assuming elastic deformation. Check that the elastic deformation assumption is valid by comparing the axial stress to the yield strength.

Q: Hi, can you now work on subparts D and E?

A: Calculate the net-specific workFor adiabatic process From the first law of Thermodynamics

Q: Draw the top, the front, and the right-side orthographic views of the objects shown. Indicate when…

A: Solution: Note: Dear Student! As per our guidelines, we are only allowed to answer three sub-parts…

Q: Your design of process must start from a raw product and ends on the final finished product. Clearly…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: For a particular process, suppose the bottle neck cycle time is 40, and the raw processing time is…

A:

Q: 14. What is the difference between unidirectional and bidirectional associativity? 15. Define an…

A: 14.      The bidirectional associativity that exists across all of these environments means that any…

Q: Karl Knapps, Inc., has received the following orders:                                        The…

A: Here, Capacity required=Order size×(minutes required  for each unit in a order size)Over or under…

Q: 8 - A robot is used for loading and unloading of parts to automated flexible machines. Loading time…

A: Write the given data. tmachine=15 min        C1=30 TL/hour        C2=40 TL/hour Here, tmachine is…

Q: 3- Consider the precedence relationship between the activities of an assembly line. Knowing that the…

A: Write the expression of the sum of the performance of the cycle. Understand that the cycle time (T)…

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.