3) Coarse screening of families 4) Fine screening 5) Final selection or Identification 6) Re-iterations II. Explain the code : 100S75

Q: Always L.L. is greater than P.L. and Always for any fine sample P.L. is greater than 4%   Question…

A: Liquid limit : Liquid limit is a water content at which the transformation takes place from plastic…

Q: A certain type of thread is manufactured with a mean tensile strength of 78.3 kg and a standard…

A:

Q: The CT values for inactivation of E. coli is given in the following table: Log removal CT (mg/L.min)…

A: Disinfection to achieveConcentration of disinfection, To find: The removal time for disinfection.It…

Q: How does the Split barrel samplers different from standard split spoon?

A: A split barrel sampler may be described as a steel sampling tool which is used to collect soil…

Q: A BOD analysis was conducted on a raw sewage sample. 300 mL of sample was placed in a 300 mL BOD…

A:

Q: The calculated availability for a subsystem that has a reliability rating of 98%, a mean time…

A: Mean time between failure = 10000 hr  Mean time to repair= 2 days  Required: Availability

Q: Calculate total solids (a), volatile solids( b) and fixed solids (c) from sample 2. Input answers in…

A: Sample 2 :1)Sample size (V) = 100 mL2)Tare mass of evaporating dish (M1) = 22.6445 g 3) Mass of…

Q: In L.L. test a minimum of three trials with values of N ~ .... are required 10 to…

A: The Liquid Limit (LL) test is a laboratory test that is performed to determine the liquid limit of a…

Q: Compute individual percent retained, cumulative percent retained and percent passing. 2. Make a…

A: Sieve size wt. retained % retained wt. passing % passing % retained GS % passing Cumulative wt…

Q: Use the same data as in problem 1 except that the standard deviation of the entire population is…

A: Since mentioned that the standard deviation of the entire population is known to be 1.2 MPa, can use…

Q: particulate sample in an air stream is represented by the following weight percent distribution:…

A:

Q: Prob-5 Hospital workers who are routinely involved administrative radioactive tracer to patients are…

A: Given; Sample size n = 28 sample mean x bar = 5.145 sample std dev s = 0.7524

Q: What are the components of a POCT sample cartridg

A: POCT sample cartridges typically consist of several components that allow for the collection,…

Quantity takeoff

Quantity takeoffs (QTO) are precise estimates of the materials and labor costs required to finish a construction project. During the pre-construction phase, an estimator prepares them, breaking down the project into smaller, more manageable parts that are easier to evaluate. These measurements are used to prepare a construction scope bid. Estimators examine the drawings, specifications, and models to figure out different quantities and their costs. Since, the components, their quantity, and price are all included in the model, quantity take-off can be done automatically using Building Information Modelling (BIM). The time taken for completing a construction project can be reduced by the use of quantity takeoff. These takeoffs are also called material takeoffs and construction takeoffs.