3' Deep Trench&Backfill To Here oVolume of Trench100'Plan View of Wall1'-A3-A1'6' Deep Trench-3) Calculate the volume of trench excavation from the sketch above.C.F. (ft³) =Varies3' to 6⁰C.Y. (yd³)1

All details are given in the figure belowNeed to findVolume of tench

Answered: 3) Calculate the volume of trench…

Engineering

Civil Engineering

3) Calculate the volume of trench excavation from the sketch above.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Information shown in light of successive cross sections between i Find the total volume of…

Q: 7. From the following cross-section notes for a road grading work. -3.2 +1.2 +1.2 +2.8 X1 3.5 X2 The…

Q: The junctions of the square grid shown below were levelled to determine the volume of excavation…

Q: The cross-section notes shown below are for a ground excavation for a 12m wide roadway. STA 20+8200…

Q: Develop an earthwork summery tabulating excavation, embankment and mass ordinates given the…

A: Earthworks is the main advance for your home; as it is the finished underpinning of your home and…

Q: which will be excavated for a roadway having a ba of ten meters: Station Station 116 154 10+ 10+ 3.0…

Q: Information obtained when drilling at a site would include: The type of soil present at the site…

A: Drilling is indeed the procedure of entering the earth and removing rocks from different depths…

Q: URVEYING #1

A: Given- Width of road (w)=9 mSide slope (n)=1.5:1

Q: Problem no. 7: At station 10+010, a rectangular trench was measured and found to be 9.4 m wide by…

Q: The areas in cut of two points of level sections that are 75m apa are 36sqm and 72sqm. Side slope is…

Q: A mine survey is being conducted from a benchmark located at the coordinate position of N 8300, E…

A: Given: coordinate position of benchmark (say o) = N 8300, E 2400And distances of points a, b, c with…

Q: From the given cross section of the proposed municipal road, it is required to determine the volume…

Q: A 120mx120m lot is divided into 9 equal sections. Find the volume (m3) to be excavated if the ground…

A: The following sketch shows the figure of the sections and corner points.

Q: Define the limit for horizontal displacement of a excavation?

A: The process of excavation means loosing the soil and taking out the materials to the required depth…

Q: The cross-section notes shown below are for a ground excavation for a 12m wide roadway. STA 23+8500…

A: To Determine the cross sectional area at STA 23+8500.

Q: QUESTION 14 The distribution of 12 spot heights with a regular 15m spacing covering a rectangular…

A: Given data:- Spacing covering of a rectangular area is 15 m Height of horizontal plane is 15 m…

Q: for cut is 1:1 and for fill is 1.5:1. Determine the area of cut of the section. -3.2 +1.2 +1.2 +2.8…

Q: Determine the volume to be cut or filled from the site using Griid formula.

Q: Determine the volume of excavation works required, assuming that Erika does not allow a quantity…

A: Given Equilateral Traingle : Volume = Area * Length = 1/2 * 6* 4*4 = 48 yd^2

Q: Baseline 4,21 0m 6,85 m 6,31 5 6,80 Offsets South Offsets North 3,54 6 4,80 12,83 12 7,93 13 7,15 15…

A: A baseline is given in the above figure. Some offsets are given on both sides of baseline. We have…

Q: Explain about the Dewatering Shallow Excavations.

A: Dewatering of shallow excavation: The application of dewatering of shallow excavations and ditches…

Q: The given data of a proposed road is tabulated below. The free haul distance is 50m and the cost of…

A: The volume of the overhauled material is measured by multiplying the overhaul distance by the cubic…

Q: Shown below is a trapezoidal area which will be excavated and used as borrow pit. It has been laid…

A: Given data:- The given elevation is 50m.

Q: Put a true or false mark in front of each of the following sentences A. The cost of soil…

A: A. The cost of soil investigations ranges from 10% to 15% of the total cost of implementing the…

Q: An earthwork excavation project required digging soil from stations A (3+56), B (4+94) to C (11+82).…

A: The area at station A = The space at station B = The space at station C = Soil swell factor =

Q: Problem no. 7: At station 10+010, a rectangular trench was measured and found to be 9.4 m wide by…

Q: what is Soil Survey and Sampling-testing "regarding excavation preparation and process"?

A: Soil survey is the process of classifying the soil types and other soil properties in a given area…

Q: 1. What is the difference between an excavation and a trench?

Q: Give a summary on Geophysical methods of soil exploration ?

A: Solution: A geophysical investigation has been performed in order to evaluate the effectiveness.…

Q: Excavation, removal and dumping of earth are one of the frequent works in engineering survey. The…

Q: Define the various methods of soil exploration techniques?

A: Various methods of soil exploration techniques: 1.open excavation:For exploring shallow depths a pit…

Q: Problem Solving: The following data are cross-section notes of the ground which will be excavated…

Q: What is open excavation and why do we need to conduct soil exploration prior to design of any in…

A: An excavation is said to be open if its width is greater than or equal to its depth. Soil…

Q: From the following cross-section notes, complete the table below. Use prismoidal method. Road bed…

Q: The areas in cut of two points of level sections that are 75m apart are 36sqm and 72sqm. Side slope…

Q: Given the following cross-sections notes. It is required to determine the earthwork volume on a…

A: We have to determine volume by using end area method corresponding given data.

Q: Problem no. 7: At station 10+010, a rectangular trench was measured and found to be 9.4 m wide by…

A: Given

Q: A 120mx120m lot is divided into 9 equal sections. Find the volume (m3) to be excavated if the ground…

A: A Mean area method is a way of calculating points in a system area with the correct calculation.…

Q: FUNDAMENTALS OF SURVEYING 1) What is called the unwanted excavated materials for disposal out of…

A: 1. Waste is the unwanted excavated material which comes when earth is dug out for construction…

Q: A barrow pit 3cm×5cm if the plan has sunk by 4% find the srinkage factor

Concept explainers

Measuring site work, Excavation and Piling

Bid drawings typically include very little material about the precise requirements of site work operations, measuring site work and excavation work differs from measuring most other works on a construction project. The actual site work conditions are not provided and also the dimensions of the excavations are not known during the pre-construction phase. The precise measurement of the excavation and backfill of the earth material and topsoil is important for a contractor to decide upon the total cost required for the process. All the works should be carried out under OSHA (Occupational Safety and Health Administration) standards to ensure the safety of the workers.

Question

3' Deep Trench
&
Backfill To Here o
Volume of Trench
100'
Plan View of Wall
1'
-A
3
-A
1'
6' Deep Trench-
3) Calculate the volume of trench excavation from the sketch above.
C.F. (ft³) =
Varies
3' to 6⁰
C.Y. (yd³)
1

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given Data

VIEW

Step 2: Introduction

VIEW

Step 3: calculation of tench volume

VIEW

Solution

VIEW

Step by step

Solved in 4 steps with 7 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Measuring sitework, excavation and piling

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

I need the answer as soon as possible
What is the volume of the cut (m3) using the prismoidal correction formula?
Solve full accurate specifics answer no guideline answer ok Just accurate 1. What is the difference between solving problems using numerical method and analytical method? 2. What are the 2 types of root finding? 3. What are the different methods under 2 types of root finding?
The areas in cut of two points of level sections that are 75m apart are 36sqm and 72sqm. Side slope is 3H:2V and base width is 10m. Determine the Volume of excavation using the PRISMOIDAL METHOD and correct the computed volume using the formula for PRISMOIDAL corrections.
The following data are cross-section notes of the ground which will be excavated for a roadway having a base width of ten meters: Station 122 10+ Station 179 10+ 3.0 2.1 2 2.6 2.75 3.4 6.1 0 5.3 6.5 7.1 Determine the volume of excavation by end-area method (in m³)
8. List three methods of sheeting an excavation (Sketch each of them)
Q3: Figure (3) represent the plan of an area to be excavated, which have been leveled in the form of a square and triangle grid the surface levels are shown beside each point, the grid squares are 20 m on a side, and the required formation level is 20.00 m above datum .Compute the amount of excavation in cubic meters. 28.11 28.24 27-58 2769 27-32 20.00 2763 20.00 Figure (3) 20.00 87.76
The areas in cut of two points of level sections that are 75m apart are 36sqm and 72sqm. Side slope is 3H:2V and base width is 10m. Determine the Volume of excavation using the PRISMOIDAL METHOD and correct the computed volume using the formula for PRISMOIDAL corrections. Please answer in 3 decimal places and provide figure
A 120mx120m lot is divided into 9 equal sections. Find the volume (m3) to be excavated if the ground surface is to be leveled to elevation 10m. The elevations of the ground surface at each corner are as follows: A = 19.2m B = 15.3m C = 16.9m D = 19.5m E = 17.2m F = 17.6m G = 16.2m H = 15.1m I = 17.2m J = 18.6m K = 18.2m L = 17.5m M = 18.8m N = 17.1m O = 16.2m P = 17.9m Round your answer to 3 decimal places.
What are the practical limitations to information provided by soil borings and cone penetration tests?
It is required to determine the earthwork volume on a portion of road construction grading work based on the following croSs section notes: Station 7+460 +0.32 +0.60 +1.92 +1.52 +1.32 4.14 3.5 3.5 6.14 Station 7+500 +2.70 +3.20 +1.60 +1.20 +2.4 8.9 3.5 3.5 8.3 The base of the road is 7.0m and the side slopes are 2:1. All units are in meters. Determine the area of the first station. Determine the area of the second station. Compute for the volume of excavation using end area method. 8:40 pm | 29°C AD) ENG 02/10/20