3/ A 3 kg particle starts from rest and moves a distance of 4 m in 2 sec under he action of a single constant force. find the magnitude of the force ? Q4/ A 6 kg object undergoes an acceleration of 2 m/sec² . a- What is the magnitude of the resultant force acting on it ? b- If this same force is applied to a 4 kg object, what acceleration will it

3/ A 3 kg particle starts from rest and moves a distance of 4 m in 2 sec under he action of a single constant force. find the magnitude of the force ? Q4/ A 6 kg object undergoes an acceleration of 2 m/sec² . a- What is the magnitude of the resultant force acting on it ? b- If this same force is applied to a 4 kg object, what acceleration will it

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Question 1: Consider the system below. At the moment shown, all three blocks are at zero velocity (Fig.1). At the same time a a force (F) of 10N is applied as shown to the grey Black (G). Each block has a mass of 1Kg. Shortly after the force, F, is applied, calculate the following: A. What is the acceleration of the red Block R, with respect to the ground (assume ground is the inertial frame). B. What is the acceleration of the red Block R, with respect to Block B. C. What is the acceleration of the blue Block B, with respect to the inertial Frame (ground). D. What is the acceleration of the grey Block G, with respect to the inertial Frame (ground). E. What should have been the magnitude of force F, such that block R would not move at all with respect to the ground. B 30° G Figure 1: Three-block setup
a.) What is the angle, measured relative to the positive x-axis, of the load's acceleration? (The correct answer is: -10.219 degrees) Just need the steps to get there b.) Three horses pull and guide a 132 kg payload down a river, exerting the forces shown in the figure, with F1 = 29 N, F2 = 38 N, F3 = 58 N, θ1 = 30°, and θ2 = 60°. What is the magnitude of the payload's acceleration? (The correct answer is: 0.7861 m/s^2)Just need the correct steps to get there
n engineer is designing a spring to be placed at the bottom of an elevator shaft. If the elevator cable breaks when the elevator is at a height H above the top of the spring, calculate the value that the spring constant k should have so that passengers undergo an acceleration of no more than 9.0g when brought to rest. Let N be the total mass of the elevator and passengers. Spring constant k that the spring should have so that passengers undergo an acceleration of no more that 9.0g
Two blocks connected by a string are pulled across a horizontal surface by a force applied to one of the blocks, as shown below. The coefficient of kinetic friction between the blocks and the surface is 0.25. If each block has an acceleration of 2.0 m/s2 to the right, what is the magnitude F of the applied force?
help! please write the complete solutions. Thumbs-up willl be given! DYNAMICS OF RIGID BODIES! A subway car leaves station A; it gains speed at the rate of 4ft /s2 for 6 s and then at the rate of 6ft /s2 until it has reached the speed of 48 ft/s. The car maintains the same speed until it approaches station B; brakes are then applied, giving the car a constant deceleration and bringing it to a stop in 6 s. The total running time from A to B is 40s. Determine the distance between stations A and B.
5.) A man is about to throw a stone by rotating his fully extended arm. If the stone moves at v = 2 due to the motion of his arm, what is the magnitude and vector equation of acceleration in for the stone if the man's arm is 550 mm long?
Three horses pull and guide a 132 kg payload down a river, exerting the forces shown in the figure, with F, = 29 N, F, = 38 N, F = 58 N, 0, = 30°, and 0, = 60°. What is the magnitude of the payload's acceleration? F2 Answer: What is the angle, measured relative to the positive x-axis, of the load's acceleration? Answer: Choose...
1. (bold type indicates a vector) An object of mass m = 10 kg may rotate in a vertical plane about the fixed point P under the action of gravity. The distance d from the point P to the center of mass C is d = 0.5 m. The moment of inertia Ie about the center of mass C is unknown. The object starts at rest in the position shown and is then released. At the instant of release the acceleration of the center of mass is measured to be a, = (-5 m/sec²)j (i.e., downward). Use the given information to determine the moment of inertià I, about the center of mass. Use g = 10 m/sec?. gravity w go P (f ixed)
A newly discovered light positively charged particle has a mass of m and charge q. Suppose it moves within the vicinity of an extremely heavy (fixed in place) particle with a positive charge Q and mass M. When the light particle is xi distance from the heavy particle, it is moving directly away from the heavy particle with a speed of vi. a) What is the lighter particle's speed when it is xf away from the heavy particle? (Consider the Newtonian Gravitation acting between the two charged particles. Ignore the effects of external forces)
A uniform rod of mass M = 2.3 kg and length L = 0.2 m, lying on a frictionless horizontal plane, is free to pivot about a vertical axis through one end, as shown. The moment of inertia of the rod about this axis is given by 1/3 ML2. If a force F = 7 N, q = 47° acts as shown, what is the resulting angular acceleration (in rad/s2) about the pivot point?
Q3 A-A race car accelerates uniformly from 18.5 m's to 46.1 m's in 247 seconds. Determine the acceleration of the car and the distance traveled. B-A feather is dropped from rest on the moon from a height of 1.40 meters. The acceleration of gravity on the moon is 1.67 m/s. Determine the time for the feather to fall to the surface of the moon.
A 2.0 kg object is moving to the right with a speed of 1.0 m/s when it experiences the force shown in the graph at right. What are the object’s speed and direction after the force ends? Paste the completed Bar Chart below. 1. identify the system 2. draw a quick sketch of the initial state of the object(s) 3. do a momentum bar chart