3 - 6" wide d= 18" - 0" Figure 2.5.4 - Question 4 Inside perimeter Outside perimeter Centreline

Q: Find the area and put in square feet

A:

Q: Calculate the bearing of a line joining the SW corner of the NE ¼, of the NE ¼ of Section 29 and the…

A: To find the bearing of a line joining the SW corner of the NE ¼, of the NE ¼ of Section 29 and the…

Q: Figure 2.5.3 - Qu Inside perimeter Outside perimeter Centreline

A:

Q: Show the quadrants of a circle and within the circle show  S 30° W

A:

Q: Only Draw profile with appropriate scale

A: To draw the profile to the given levelling

Q: 0 89' - Multiply 53/4" X 132'-7" 2'-9" X 59' 1" - 3 81'-8 1/4' "1 X 35' - 1/2" 95'-5" x 93'-5"

A: 4. 95′−5′′×93′−5′'95′−5′′Convert 5 inches to feet: 5÷12=512=0.4167So, 95+0.4167=95.4167…

Q: PROBLEMS, DETERMINE To ALL FOR AFD, SFD, THE AND BMD MAKING SURE SHOW AU WORK REQUIRED To OBTAIN…

A: We will find reactions at A and D and draw FBD to solve

Q: V5-4. For the 50-foot grid shown in Fig. 5-12, redraw, and sketch all one-foot contour lines. the…

A: Calculations of the distances of the points from the lower levels

Q: If the resultant of the loads shown passes through point B, determine the equivalent force-couple…

A: For resultant of the load to pass through point B. Reaction force at A (RA) = 0

Q: Problem No. 4 Given below is the technical description of a lot F. lines Distances (m) bearings S…

A:

Q: PROBLEM 3 THE BUILDING IN FIG. P1.1 IS USED FOR LIGHT STORAGE SPACE. THE SLAB IS 250 MM. THICK. THE…

A:

Measuring site work, Excavation and Piling

Bid drawings typically include very little material about the precise requirements of site work operations, measuring site work and excavation work differs from measuring most other works on a construction project. The actual site work conditions are not provided and also the dimensions of the excavations are not known during the pre-construction phase. The precise measurement of the excavation and backfill of the earth material and topsoil is important for a contractor to decide upon the total cost required for the process. All the works should be carried out under OSHA (Occupational Safety and Health Administration) standards to ensure the safety of the workers.