3-28 A 1.8-m' rigid tank contains steam at 220°C. One-third of the volume is in the liquid phase and the rest is in the vapor form. Determine (a) the pressure of the steam, (b) the quality of the saturated mixture, and (c) the density of the mixture. Steam 1.8 m' 220"C FIGURE P3-28

3-28 A 1.8-m' rigid tank contains steam at 220°C. One-third of the volume is in the liquid phase and the rest is in the vapor form. Determine (a) the pressure of the steam, (b) the quality of the saturated mixture, and (c) the density of the mixture. Steam 1.8 m' 220"C FIGURE P3-28

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Marks) QIA) A cylinder has a thick piston initially held in position by a pin. The cylinder contains carbon dioxide at 200 kPa 50 mm and temperature of 20 °C. The metal piston has a density of 8000 kg/m³. The pin is now removed allowing the piston 100 mm Pin اد فیا Pin to move at a constant temperature. Show that the piston will move upward when the pin is removed. At what pressure the piston will rest against the stops? I. 100 mm CO2 II. Final k-100 mm-
onal Assignh Q56. The water in a tank is pressurized by air, and the pressure is measured by a multifluid manometer as shown in the Figure. The atmospheric pressure is 85.6 kPa. Determine the air pressure in the tank if h, = 0.1 m, h2 = 0.2 m, and ha = 0.35 m. Take the densities of water, oil, and mercury to be 1000 kg/m², 850 kg/m², and 13,600 kg/m², respectively. Oil а. 130 КРа Air b. 44 MPa с. 310 КPа Water d. 44 kPa е. 130 MPа Mercury
A rigid tank contains superheated water vapour at 300 kPa. When the tank is cooled, the superheated water vapour starts to condense at a temperature of 125°C. Determine the pressure and specific volume of the water at 125°C when the condensation process starts (kPa; m'/kg). Determine the temperature of the superheated water vapour (°C). Clearly show all calculations. Sketch the process on a properly labelled temperature versus specific volume (T-v) diagram with respect to saturation lines. i. ii. iii.
At the pressure of P=0.1MPa, the saturation temperature of water is Tsat=100 ºC, the specific volume of the saturated liquid water is vf=0.001043 m3/kg, and the specific volume of the saturated vapor water is vg=1.6720 m3/kg. (3) Please match regions shown in the diagram with correct names.
Water in a 5-cm-deep pan is observed to boil at 98oC.At what temperature will the water in a 40-cm-deep pan boil?Assume both pans are full of water. Use 1000 kg/m3 as the density of water. Please give your answer in oC. You will need to assume that phase change only takes place on the bottom surface of the pan. Please start by finding the atmospheric pressure for the 5-cm-deep case. Then find the pressure at the bottom of the deeper pan.
Determine the pressure, specific volume, and internal energy of water at 25 C and a quality of 70%
(40 pts) A rigid container is filled with 400 kg of argon gas at 500 K. The volume of the container is 6.32 m³. Determine the pressure in the tank, using i) the van der Waals equation, and ii) the Beattie-Bridgeman equation.
Water is kept in a closed container at 100 KPa pressure and at 99.6oC temperature, find out whether the water is in pure liquid form or pure vapor form or in mixed form. Use Cardan’s method. You can refer to your notes to check various formulas
2-30 The water in a tank is pressurized by air and the pressure is measured by a multifluid manometer as shown in Fig.P2-30. Determine the gage pressure of air in the tank if h₁-0.2 m, h₂-0.3m, and h₂ =0.4m. Take the densities of water, oil and mercury to be 1000 kg/m³, 850 kg/m³ and 13600 kg/m³, respectively. Oil Air Water FIGURE P2-30 Mercury
A rigid tank contains water at a pressure of 200 kPa. The volume of the tank is 2 m^3. The mass of liquid in the tank is 0.5643 kg and the mass of vapor in the tank is 2.2572 kg. In the question that follows, select the answer that is closest to the true value. What is the quality of the water in the tank?
A rigid tank contains 15kg of water at 75 degrees celcius. if 3kg the water is in the vapor form and the rest is in the liquid form, determine (a) the pressure in the tank and (b) the volume of the tank
Figure (a) below shows a U-shaped tube containing an amount of mercury. The left arm of the tube has cross-sectional area A1 of 10.7 cm2, and the right arm has a cross-sectional area A2 of 5.40 cm2. In both arms, the mercury is at the same level, as shown. In figure (b) below, 100 g of water is poured into the right arm of the tube and sits atop the mercury, all of it within the right arm. The mercury level in the right arm has been displaced downward, and the mercury level in the left arm has been displaced upward from its original level by a distance h. The density of mercury is 13.6 g/cm3, and the density of water is 1.00 g/cm3. (a) What is the length (in cm) of the column of water in the right arm of the U-shaped tube? ___cm (b) What distance h (in cm) does the mercury rise in the left arm? ____cm