# 3 (25 pts) Determine the reactions at B & E and draw the shear and bending-moment diagrams for the beam and loading shown. 8 kips 10 kips 12 kips C D 6 ft- 4 ft -10 ft- 5 ft

Q: 4 kN/m 2 kN/m B A -3 m - 1.5 m

A:

Q: The figure shows a cantilever beam carrying a uniformly distributed load of 4 kN/m and a point load…

A: Shear force at any cross-section of the member is equal to the algebraic sum of concentrated point…

Q: 4. Draw the complete shear and bending moment diagrams. -2 m- 15 kN] 20 kN.m 10 kN/m -2 m- B

A:

Q: The steel beam with given support condition and section is being loaded as shown. (a) Draw shear…

A:

Q: If the moment M = 750 Nm and the distributed load wo = 0.5 kN/m, you are required to: a) Determine…

A: The values are M=750 Nm, wo=0.5 kN/m

Q: 1. For the beam shown below, compute the reactions at the supports and draw the shearing force and…

A: Given:Find:the support reactions and the shear force and bending moment diagram.

Q: For the overhang beam with the cross-section and the applied loads shown, (a) sketch the FBD of the…

A: Givenoverhanging beam  as shown below

Q: Given the beam below (beam AB), determine the reactions in A and B, th shear force diagram and the…

A: Given: F= 66 kN q=56 kN/m L=10 m TO determine: Reaction force  To draw: Shear force and bending…

Q: For the 80-mm shaft subjected to two concentrated forces shown, the journal bearings forces. Address…

A:

Q: 2. For the 20 meter beam shown, there is a roller at "A" (Ay = 52 kN; it is acting upward), and a…

A: For the 20 meter beam shown, there is a roller at "A" (Ay= 52 KN; it is acting upward), and a pin…

Q: Draw the shear and moment diagrams for the beam shown. After you have the diagrams, answer the…

A: