29 29. The voltage applied across an electric: press was reduced by 50%. The powerconsumcd by thc press will bc reduccd by: (Solution)50%75%25%60%

Given Voltage across electric press was reduced by 50% . Voltage, V2 = 0.5 V1 where V1 is voltage…

Answered: 29. The vollage applied across an…

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter12: Batteries And Other Sources Of Electricity

Section: Chapter Questions

Problem 12RQ: 12. How is the A-hr capacity of a lead-acid battery determined?

See similar textbooks

Similar questions

ANSWER THE QUESTION
Question (2) A controlled half-wave rectifier has a 240 V rms 60Hz ac source, The load a is R=30 Ohm resistor (a) Determine the delay angle such that the average load current is 2.5A (b) Determine the power absorbed by the load (c) Determine the power factor.
Example 35: A full wave rectifier used 220V, with firing angle 10 total resistance load 5 KO, inductance 2.34 H,and frequency 60Hz, Draw and caleulate: (a) Voc and Inc (b) VDCMao (c) V. (d) Veims Example 35: Repeat example 35 and firing angle 30°. Example 37: Repeat example 35 for FWD and firing angle 60°.
1. The reverse bias diodes a. D1 only b. D2 only c. Everything d. None 2. The close circuit is a. R1 and D1 side only b. R2 and D2 side only c. Everything d. None
iv. Find the average voltage over Load. v. Find the maximum current passing over diodes. vi. Find the peak inverse voltage (PIV) over the diodes. vii. Find the minimum fuse current rating for the primary coil. ,Da 5:1 120 V ms RL=10k2 R1 ell lelll
Breakdown strength of the gases experiment the current will be increased by a. Cathode produced electrons b. Anode attraction c. Free electrons d. Additional electrons
Determine the current flowing through resistor R2. (assume Zener voltage is 3 volts and Diode forward voltage is 0.7V)
Determine the voltage across the resistor R1. (assume LED forward voltage is 2.1 volts and Diode forward voltage is 0.7V)
Determine the voltage across the resistor, the current in the resistor, and the output voltage in figure 1 and figure 2. Plot these waveforms with proper ac cycle phase alignment. 1SR154-400 is a silicon rectifier 1 ampere diode. Indicate the peak values as per calculation.
i need the answer quickly
In the circuit shown in Figure 3 used for full-wave rectification, which of the diodes is connected incorrectly? O a. D4 O b. D₁ O c. D₂ O d. D3 z D4 D₁ D3 D₂ Figure 3. Rectification Circuit
The primary voltage on the transformer in Figure 2–46 (p. 96) is 120 V rms and NP : NS = 15:1. Diode voltage drops are 0.7 V. (a) What should be the value of RL if the average current in RL must be 0.5 A? (d) Is it alright to measure with an oscilloscope both the input and output waveforms at the same time in Figure 2-46? Why or why not?

SEE MORE QUESTIONS

Recommended textbooks for you

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Electricity for Refrigeration, Heating, and Air C…

Mechanical Engineering

ISBN:

9781337399128

Author:

Russell E. Smith

Publisher:

Cengage Learning

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Electricity for Refrigeration, Heating, and Air C…

Mechanical Engineering

ISBN:

9781337399128

Author:

Russell E. Smith

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

29. The vollage applied across an electric press was reduced by 50%. The power consumcd by thc prcss will bc rcduccd by: (Solution) 50% /5% 25% 60%