270 lb/ft Where is the point of zero shear located from support A? а. 5.0 m b. 4.5 m A B с. 4.0 m d. 5.5 m 3 ft 6 ft R1 R2

Q: Find roller support reaction

A: Given data : Point load =3 KN Point load=4 KN Point load=3 KN   To find : Roller support reaction

Q: 4 m 4 m 4 m | 4 m | 4 m | 4 m K J 6 m M |N H 60°- EQ P 60° 30° 30° 6 m D R 25 kN 25 kN 6 m C 6 m T 6…

A: compute the force in member FJ

Q: For the truss loaded as shown, determine the equation for the line of action of the stand-alone…

A:

Q: w= 16 kN/m P 64 kN M = 20 kN-m acting clockwise on the end of the 6.1 meters cantilever beam,…

A:

Q: Replace the distributed loading by an equivalent resultant force and specify where its line of…

A: Consider the following free body diagram as follows: Converting uniformly distributed loads to point…

Q: y 30 15 kN-m 3 kN B A 1.4 kN -1.2 m- 1.8 m 1.8 m

A:

Q: A cantilever beam under a state of loading is shown below, determine the horizontal reaction at G?…

A: Consider the figure,

Q: A) draw the free body diagram to prove its statically determinate and find the reaction forces at…

A: Find: A) draw the free body diagram to prove its statically determinate and find the reaction forces…

Q: Find the moment under the point load C?

A:

Q: Determine the force in the cables needed to support the 450-lb crate as showin in (Figure 1) Hint:…

A: Given weight of W = 450 lbIt is asked to determine the forces in the cables.

Q: 5 kN 20 kN/m B. -211 3 m

A:

Q: determine the maximum bending moment (kN-m)

A:

Q: 24 kN 5 kN 16 KN 16 kN 26 50 kN-m 100° В 35° A 1.6 m 2.2 m 2.4 m |1.2 ml 2.6 m A terrible driver has…

A:

Q: B) 35 kN A -3m B 48kN/m 9 m со 55 kN-m

A:

Q: 6 klft 24 k-ft 7 K8' →K5'5' → T CHOOSE THE OPTIMAL TO SUPPORT THE LOADS. A WIDE FLANGE BEAM

A: Given simply supported beam with loading conditions and it is asked to choose the optimal wide…

Q: Will rate immediately. Need ASAP a. which of the ff gives the maximum shear in the beam? b. which of…

A:

Q: Determine fixed support reaction . I will upvote Give fast answer

A: FBD :

Q: draw the load and moment diagram of the beam and find the: *Maximum Moment *Moment at point 2 *…

A: The following points may be noted  If at a point ordinates of SFD suddenly changes, then at that…

Q: Problem Statement Based on Problem 5-11 from the textbook. Determine the reactions at the supports.…

A:

Q: st 1.5 kN 1 kN 4 m

A: solution first find the reactions at the supports consider ∑Fy=0 and consider  ∑Fx=0 Py+Ty=3KN…

Q: O2 A |B C| 1.5 m--1.5 m 1.5 m -|

A:

Q: d the

A: Draw free body diagram From the above figure At point C, tanθ=21θ=tan-12θ=63.435o

Q: Determine the normal force, shear force, and moment at point C.

A: Consider the equilibrium of forces in vertical direction.

Q: ading on its bottom surface is trapezoid determine the intensity w, and then dra d moment diagrams…

A:

Q: 2-A distributed load is shown below. Simplify this complex load to a single force and a single…

A:

Q: Name four zero force members in the Figure. 6 kN 900 N- 2 m 2 m SE B.

A: Given- Trus s diagram with different loads

Q: A beam PQ is supported at its ends and loaded as shown. Draw the shear force and bending moment…

A:

Q: Determine the maximum shear

A:

Q: Drow the shear and bending diagram

A: Given: A simply supported beam with two side overhang beam loaded as shown in the figure. To draw:…

Q: compute the force in member LP

A: To Determine Force in member LP.

Q: KN/M B Jom.

A:

Q: a) Replace the distributed loading by equivalent resultant forces. (THIS MEANS YOUR MUST REDRAW THE…

A:

Q: H.W 4 Determine the equivalent resultant force of the system and specify its location measured from…

A: To find resultant and it's location from A

Q: 9o = 5F/b 2F 3bF 4F – 26 -- 26 + b--- 26 t 26 →

A: Solution;

Q: 1.50 in. 0.75 in. B A To 6.0 in. -15.0 in.-

A:

Q: 1 kN F 1 kN J B C E G 5 kN 5 kN 5 kN 1 kN D 1 kN I K -6 panels @ 5 m = 30 m- 1 kN h=8m LA 12.…

A:

Q: 2. A simply supported beam, 10 meters long, has a 2-m overhang beyond the right support. A uniform…

A: Given:- Simply supported beam L= 10 meters The 2-meter overhang from the right support Beam carries…

Q: A beam is loaded with a uniformly distributed load between the two roller supports and a single load…

A: Given:- To find:- 1. FBD and degree of determinacy 2. Shear forces and Bending Moment for each…

Q: 10K 12K 10K 20K. 15K 7K 1. Solve for the resultant of the six loads on the truss shown The loads are…

A:

Q: Based on the following figure determine the vertical reaction at the hinge type support for the…

A: To determine:the vertical reaction at the hinge