it at its side, as26) A container has a vertical tube, whose inner radius is 24.00 mm, connectedshown in the figure. An unknown liquid reaches level A in the container and level B in the tube-level A being 5.0 cm higher than level B. The liquid supports a 20-cm high column of oil,between levels B and C, whose density is 570 kg/m3. The mass of the oil is closest to20 сmA15.0 cmA) 210В) 410С) 620D) 820E) 1000

Given, the inner radius of the vertical tube is r=24mm=24×10-3m height from point B to A is hu=5cm…

Answered: 26) A container has a vertical tube,…

Similar questions

6. Please help answer this question, thank you so much!! :)
6) A liquid is flowing through a 57.0 cm ^ 2 The pipe is then reduced to 16.5 cm ^ 2 speed of the liquid is measured to be 6.05 m/s . What was the speed of the liquid in the larger pipe?
An object hangs from a spring balance. When submerged in water the object weighs one-half what it weighs in air. If, when submerged in an unknown liquid with density px, the object weighs three- fourths what it weighs in air, what is the density of the unknown liquid? OPwater OPwater ○ 2pwater O none of these 3 4Pwater Pwater
1) Pistons are fitted to two cylindrical chambers connected through a horizontal tube to form a hydraulic system. The piston chambers and the connecting tube are filled with an incompressible fluid. The cross-sectional areas of piston 1 and piston 2 are A1 and A2, respectively. A force F1 is exerted on piston 1. Rank the resultant force F2 on piston 2 that results from the combinations of F1, A1, and A2 given from greatest to smallest. If any of the combinations yield the same force, give them the same ranking. (Use only ">" or "=" symbols. Do not include any parentheses around the letters or symbols.) F1 = 5.0 N; A1 = 0.9 m2; and A2 = 1.8 m2 F1 = 2.5 N; A1 = 0.9 m2; and A2 = 0.45 m2 F1 = 2.5 N; A1 = 1.8 m2; and A2 = 3.6 m2 F1 = 5.0 N; A1 = 0.45 m2; and A2 = 1.8 m2 F1 = 5.0 N; A1 = 0.45 m2; and A2 = 0.9 m2 F1 = 2.5 N; A1 = 1.8 m2; and A2 = 0.9 m2 2) A bicycle tire pump has a piston with area 0.43 in2. If a person exerts a force of 22 lb on the piston while inflating a tire,…
1.
A liquid-filled tube called a manometer can be used to measure the pressure inside a container by comparing it to the atmospheric pressure and measuring the height of the liquid. Such a device (filled with water) is shown in the figure, measuring the pressure inside a balloon filled with an unknown gas. The water level on the side of the manometer which is open to the air is 22.3 cm higher than on the side connected to the balloon. a) Find the gauge pressure in the balloon, in units of Pa. Recall the density of water is 1000 kg/m3. b) Find the absolute pressure in the balloon, in units of Pa.
You come across an open container that is filled with two liquids. Since the two liquids have different densities, there is a distinct separation between them. Water, which has a density of ?w=1.00×103 kg/m3ρw=1.00×103 kg/m3, fills the lower portion of the container to a depth of 0.221 m0.221 m. The fluid that is floating on top of the water is 0.342 m0.342 m deep. If the absolute pressure on the bottom of the container is 1.049×105 Pa1.049×105 Pa, what is the density, ?lρl, of the unknown fluid? The acceleration due to gravity is ?=9.81 m/s2g=9.81 m/s2 and atmospheric pressure is ?0=1.013×105 PaP0=1.013×105 Pa.
A hollow plastic cube of side length 80 cm is held below the surface of a lake by a cord anchored to the bottom of the lake. The cube has a mass of 85 kg and the density of the lake water is 1025 kg/m. a) What is the buoyant force exerted on the cube by the lake water? b) If the top surface of the cube is 25.4 m below the surface of the lake, what is the gauge pressure at the top surface of the cube? P. = 1.013 x 10 Pa. atm c) What is the force on the top face of the cube? Note the top face will have a square cross section and the length of the side is 80 cm.
You place an open bottle filled with olive oil (density 880 kg/m^3) in a container filled with water so that the surfaces of both liquids are at the same level. The bottle has a hole in it 18cm below the surface that is initially closed with adhesive tape, as shown in (Figure 1). Determine the vertical distance Δh between the oil surface and water surface after the tape is removed and the equilibrium is reached. Assume that the volume of water is much greater than the volume of olive oil, so that the decrease in the water level is negligible.
E 6. A spherically shaped balloon has a radius of 13 m, and is filled with helium. How much extra mass can a cargo lift, assuming that the skin and the cargo of the balloon have a mass of 1100 kg? Neglect the buoyant force on the cargo volume itself. (The density of air is 1.29 kg/m3 and the density of helium is 0.179 kg/m³) kg MAR 2 27 96 5 G 6 tv MacBook Air H & 7 N 8 J A 9 M K P zoom BUT by r 04 M vauies or ne puffer
help A concrete block with a density of 6550 will sink in water, but a rope suspends it underwater underwater (that is, its completely underwater, not touching the bottom of the lake, and isn't moving. It measures 63 cm x 20 cm x 15 cm, and has a density of 6550 kg/m3. The density of water is 1000 kg/m3 Find the tension in the rope. Hint: Buoyancy problem - similar to the last problem, but add a rope pulling up.