(25b/a)(s+a) (s+b)(s²+4s+25)" 3.5 and 4.0. which value of b will have a minimal effect upon the pure second-order transient Given the transfer function G(s) = Let a = 3 and b = 3.01, 3.1, 3.3, response?

Q: 3. I don't have a driving licence. I can't drive you there.If I. driving licence, I could drive you…

A:

Q: Describe the job of the Board of Electrical Engineering in one sentence. Note: The Board of…

A: It is asked to describe the job of the Board of Electrical Engineering in one senctsen.

Q: Question (1): With proper example and circuit diagram briefly explain the following theorems.  (i)…

A: The evaluation of electrical circuits containing different circuit components and power sources…

Q: What is sub station

A: A power station is to provide electricity to a huge number of people. Different customer’s power…

Q: 1.verify (Kc) and (KUL)) ?

A:

Q: Can we replace the Fossil Fuels? How?

A: Can we replace the Fossil Fuels? How?

Q: Please read the following questions carefully and then elaborate on cach of 1-Describe wireless…

A: Some technical challenges that a wireless communication faces are  i)multipath propagation…

Q: Give examples of 3 sensors and 3 actuators which can be used in your smart house. Label the sensors…

A: given that 3 examples of sensors and actuators needs to provided which is used in making of smart…

Q: A high voltage transmission line transmitting 10 MW of power operates at a voltage of 105 KV…

A:

Q: What is the maximum number of 15 ampere lighting circuits required if the dwelling has an occupied…

A: Refer the table 220.12 from the NEC, the minimum load requirements for the dwelling load unit is,

Q: What is a FET

A: The modern day devices have enabled us an easy life. The devices have various electronic components…

Q: Question 5- Power Network, Frequency & Connected Load a) In the UK and many other countries, there…

A: The legal requirement to maintain the voltage and frequency with permitted tolerances is due to the…

Q: Inverting Op-Amp R₁ R₁ Vo R2 R4 998.48m V R2 R3 9.9844 R1 R4 2.1244 out of phase A(gain) A(gain)…

A:

Q: What is the difference between passive and active buzzer?

A: A passive buzzer requires an ac signal to make a sound. A passive buzzer does not generate a tone by…

Q: Q4: Write the following compound words in the correct form as (one word, two words, or hyphenated):…

A: AirportFossil fuelCheck-in

Q: Make a circuit that controls two LED's with a single switch; plus one of the LED's is controlled by…

A: Since you have posted multiple questions, according to guidelines, we will solve only the first…

Q: QI\ Define standard of measurement and explain categories that standard of measurement classified to…

A: Here we will define standard of measurement and we will also explain the categories of standard of…

Q: Q21 Fill in the following blanks (Answer 5 only) 1.Switches in terms of number of contacts and…

A: Power system transfers power from the source end to the load end. Protection of the power system is…

Q: 1. Define two (2) types of Power Electronics application with diagram and gives one for each types.…

A:

Q: Write a paragraph about your hopes and ambitions. In about 100 words

A: Hope and ambitions are the most important part of any human which can include the happiness of…

Q: d) None of these. 5. Materials which easily allow the passage of electric current are known as: a)…

A: Answer 2- The power is defined as a rate of doing work.  So, option (c) is correct.   Answer 4- An…

Q: P-channel MOSFET is basically a following device. a. voltage operated O b. low-frequency operated O…

A: MOSFET is controlled by the application of GATE pulse .  GATE pulse controls the conduction state of…

Q: Which of the following is an example of analog data? a.The number of pens in your pencil case.…

A:

Q: Look at the photo and answer the questions

A:

Q: V1 Op-amp V; = 0 Rf R1 R1 Fig. 3.11 (a) Non-inverting amplifier (b) Equivalent circuit with virtual…

A:

Q: Show the following units in scientific notation. e.g ) Five Kilometre (km) = 5 x 103 m 1) One…

A: Consider solving the problem by using the second notation (which decides the exponential power of…

Q: Can you please further explain this section.

A:

Q: A protective put can be used for risk management.   A. TRUE B. FALSE

A: ANSWER      TRUE          A protective put can be used for risk…

Q: Hi for case 3 is explain on which question ? either (a) positive or negative or for question (b) pls…

A:

Q: In an electrical system, each of the service entrance conductors has an area of 750 kcmil. The size…

A: Given: In an electrical system, each of the service entrance conductors has an area of 750 kcmil.

Q: Still confused about how you calculated the current. Could you please elaborate a little? thank you

A:

Q: please tell me a similar app to solve engineering questions?

A: Bartleby is the best app Bartleby is the best app

Q: b) With sketch of diagram, show the number of resistor and switched would be required to implement…

A:

Q: Which one of the following is the definition of slurry? a. Water only b. Animal waste (Dung) only c.…

A: definition of slurry

Q: can you please help me on a home work question. havent worked with this stuff in 47 years

A:

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.