250 kN 40 kN/m 20 kN/m I (m) 1 2.5 5 Figure.1: Simply supported beam Your tasks are as follows: 1- Construct free-body diagram (FBD) to show the reactions forces and moments, equivalent force distributed load. 2- Show FBD for each required section/cut and the internal forces and moments.

Q: What is the part’s over all length?_______________________ 6. Whatisthe part’s over all…

A: considering the detailed drawing of an object to find out the answers of the given questions.

Q: Statics; working

A:

Q: Figure shows a heat exchanger designed to cool 5250 kg/h of an ethyl alcohol solution (Cp = 3810…

A:

Q: how do you solidify and cool in a metal casting process manufacturing

A:

Q: Sheet Forming Processes; V-Bending of Sheets is more expensive than Edge Bending. (T or F) In Metal…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: I have three parts that need to be answered pertaining to the print provided below.   What size…

A: The size of the print provided in the title box is C.Hence the correct answer is C.

Q: In general, Fair Use allows small sections of a work to qualify for copying so long as the entire…

A: Given:

Q: What is the maximum thickness dimension allowed on the part?

A:

Q: What is the slenderness ratio?

A:

Q: 1. Explain how Jominy test results can be used to validate a particular steel grade for a specific…

A: Note: Since you have asked multiple question, we will solve the first question for you. If you want…

Q: Name 3 types of fits?

A: The different types of fits are : 1) Clearance fit 2) Interference fit 3) Transition fit

Q: what happened with the 10 in the first equation?

A:

Q: Define deformation process

A: Deformation process is the secondary manufacturing process.

Q: How were the areas for part 2 found?

A: Given Data and to find: How the areas are calculated?

Q: Describe the method of sections?

A: Method of section In this method we deal with the non-concurrent forces. Here, we get three…

Q: Which of the following is a suitable process for creating a hollow 3D shaped component?

A: Option a is correct.

Q: I have three parts that I need answered pertaining to the print provided below.   What material is…

A: To find the material specified for the part in the drawing, refer Title Block of the drawing.

Q: An engineer first draws a circle in a plane and uses a tool to convert the circle to a disk that is…

A: SolidWorks is a 3D parametric design software that is used to design all sorts of 2D and 3D parts…

Q: The Sleeve Bearing Problem A machinist had pressed a new prelubricated, porous sintered bronze…

A: There may be following reasons of bearing failurePoor finishing on the bearing surface after…

Free Body Diagram

The system of forces acting on a body tends to either rotate it or make the body undergo motion. In general, when an external agent exerts a force on a body, the body undergoes translational motion and rotational motion. The body has six degrees of freedom under the influence of that force. Here, three degrees of freedom are from the translational motion while the other three are from the rotation motion. However, sometimes the bodies are not allowed to undergo any motion and are fixed, under such conditions the body is said to be constrained.