25- The circuit below is a signal conditioner for an LDR (light dependent resistor) sensor. By changing Vin and Rf user can adjust the output voltage for a required range. The resistance of LDR according to the change of luminance/illumination is given in the formula. Vin = -2mV, Rf=10Kohm. If the luminance/illumination is equal to the last 3 digit of your student number in terms of unit lux, what will be the output voltage in terms of mV. Rf Resistance (n) LDR Dark Daylight Sunlight 10 in Vout 104 -lux ohm 10000 RL 10 Illumination (LUX) 10 10

Q: Betz limit applies to O a. solar cells O b. heat engines O c. wind turbines O d. generator

A: Belz limit is the maximum efficiency of wind turbine.

Q: A Moving to another question will save this response. Question 4 For decimal numbers the base is…

A: Decimal number - It can be defined as a number whose whole number part and fractional part is…

Q: What is the difference between the pins under number 1 and the pins under number 4, and mention when…

A: The difference between pin 1 and pin 4 is the transmitting ability (information) to external…

Q: V1 120 V R1 20 R2 R3 + v2 110 V R4 32 0 R5 10Ω R6 20

A: KIRCHOFF'S CURRENT LAW:- The algebraic sum of every current entering and leaving the node has to be…

Q: Please chose one a1101101 b10101 c110010 d1o101001 e110101

A: The given number is  (365)16 Although, binary equivalent of  3 , 6  and 5,  contaning 4 digits is…

Q: く Match the following numbering systems (Decimal to Octal): 08 09 14 15

A:

Q: Given F(a, b, c, d) = m(0, 3, 5, 7, 8, 9, 10, 11, 13) The implicant table is partially filled for…

A: Given:Partially filled implicant table for logic fucntion, To find:Essential prime implicants and…

Q: why is it saying that 0.3636 is wrong

A:

Q: please answer asap

A: This is the simple integration question which solved by using by-parts technique with the rule of…

Q: ess each of the following in Engineering Notation using the proper pr D. D0015 V F00,000 W 6,000,000…

A: The following are the engineering notations for the given parameters

Q: Question 5 Express 0.000000001 W as nW O 10 nW O 1 nW O 100 nW 0.01 nW

A: Expression of power is given 0.000000001 W.

Q: Single pool and double pool. Switch symbols are shown as

A: In this question, we need to write a symbols of single pool and double pool.

Q: Use nodal analysis to find V₁ in the circuit in the figure. Round-off to 3 decimal place. Do not…

A: To find V1 in the circuit

Q: is 32 ME IS 39. 36 2/3. If each CE had been one year older, each ME 6 year older and each ME 6 years…

A:

Q: In any order of the decimal numbering system can there be 15 elements? True or false, please justify…

A: False  15 elements are not present in decimal number system

Q: -. Determine 1₁ and 12

A:

Q: Divide the two numbers: 10.25m by 2.2u. (Note: u= micro) Select one: O a. 1.94M O b. None of these O…

A: Given First number is 10.25m Second number is 2.2u (u=micro)   On dividing both numbers…

Q: 1.5L 1-5A 1.55L Reg = ?? %3D

A:

Q: Complete the table: Show complete and neat solution. Round off answers up to the 4th decimal place.

A:

Q: Convert the circuit from star Y connection to delta A connection for the following circuit 302 102…

A: Apply the formula for star-delta conversion,

Q: Convert (11010001.0111)2 into Oct.

A:

Q: 3. Determine the total impedance and the total current. 400 20/30°V -jsn j30n SA ÚJA

A: The given problem is from circuits. The detailed solution is given in the next steps.

Q: Determine the mathematical model of the electrical system given below using Lagrange law.

A: The polar opposite of the parallel RLC circuit is the series RLC circuit.. While the given current…

Q: Q1 :A. write the code and state the name for the following signals 15 Clock 1O1 0 • 111 0 0 10 Data

A: Line code is used for data transmission over a transmission line. There are different types of line…

Q: (iii) 110001.1102x 1011.0012 (iv) 1011011010.102 by 11012

A: Given, Two set of two binary numbers. (1) multiplication of two binary numbers      Result is…

Q: Find Vo, l1 and l2. Write your answer with unit with space in between. Round off to 2 decimal…

A:

Q: 12 15 16 None of the other answers are true

A:

Q: > FIND THE TOTAL POWER OF THE CHT. R 朝 عي 22 03 章 本 2/2 册 2 级 ¥102

A: Given data: Input current to the circuit, I = 3 A Resistor network as follows,   To find: Power of…

Q: Convert the following numbers with the indicated bases to decimal: (b) (179)12 (d) (354)6 (a)…

A:

Q: In any order of the decimal numbering system can there be 15 true or false elements? Thank you very…

A: False For Any numbering system we have  If the base value is "x" say then it must have x no of…

Q: What is the basic principle of an electric motor and generator?

A:

Q: What is the pitch of the thread called out by the thread note illustrated below? 9/16 -9/16-12UNC-2A…

A: Thread note is given it is asked to find the pitch of the thread

Q: В A

A:

Q: Determine the value of R1 Hint: Don't overthink this one. Hilt R1 = PR2 V1 12V i7.3607mA R1 PR1+ REV…

A:

Q: What is the per unit voltage of an electrical network, given an applied voltage of 150260 V and a…

A: In this question we will find per unit voltage with given data...

Q: 3. A balanced delta-connected load is connected across a balanced 3-phase, 120 V, 60 Hz, 3-wire…

A:

Q: Pt = Pt = P+ = Pt Pr G+ x Gr > (4nd)² 1x106 (00X100 x/0.112 1x 10-6 4X3.14 X 600² 10000 x 0.1…

A:

Q: 1. Determine R- and IT. 302 2 362 20s2 10oV 252 $362 1o2

A: Determine equivalent resistance and total current for the given circuit.

Q: How can i get I1 in  Q.b

A: It is given that: Voltage=3200 VPower=12000 kWFrequency=50 HzPole=12R1= 0.697 Ω R2= 0.328 Ω Rm1=226…

Q: In order to select the chip shown, A19-A14 must be set to B A13 A0 A19 32K×4 A14 En A15 CS 1011 0B…

A: In the chip circuit, the enable pin (En) is active high enable which means “1” is given to the…

Q: 1. Express the following numbers in decimal (a) (DABA.B)6 (b) (1011.1001)2

A: Express the following numbers in decimal. a. DABA.B which is in hexa decimal notation  b. 1011.1001…

Q: Count

A: In this we have to write 0 to 25 decimal numbers to hexadecimal numbers..

Q: Attempt in Progress In the circuit of the figure & = 183 kV, C = 7.20 µF, R1 = R2=R3 1.02 M2. With C…

A: Given, resistance capacitance combinational circuit where R1=R2=R3=1.02mega ohms and E= 1.83 kilo…

Q: Consider the circuit shown below. Select the nodes from the list that are supernodes. VI V5 3222 4ix…

A: to find super nodes in the given circuits

Q: Pese chose oe a1101101 b10101 c1100110 d10101001 e1101001

A: We need to convert given hexadecimal formate to binary .

Code Conversion

The method or technique used to convert code from one format to another is termed code conversion. Code conversions are most commonly used in computers, digital electronics, microprocessors, etc.