24. •• The 1.0 kg block in Figure EX7.24 is tied to the wall with a ropề. It sits on top of the 2.0 kg block. The lower block is pulled to the right with a tension force of 20 N. The coefficient of kinetic friction at both the lower and upper surfaces of the 2.0 kg block is Hk = 0.40. a. What is the tension in the rope attached to the wall? b. What is the acceleration of the 2.0 kg block? Figure EX7.24 1.0 kg 20 N 2.0kg

24. •• The 1.0 kg block in Figure EX7.24 is tied to the wall with a ropề. It sits on top of the 2.0 kg block. The lower block is pulled to the right with a tension force of 20 N. The coefficient of kinetic friction at both the lower and upper surfaces of the 2.0 kg block is Hk = 0.40. a. What is the tension in the rope attached to the wall? b. What is the acceleration of the 2.0 kg block? Figure EX7.24 1.0 kg 20 N 2.0kg

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter5: Newton's Laws Of Motion

Section: Chapter Questions

Problem 72PQ: A block of ice (m = 15.0 kg) with an attached rope is at rest on a frictionless surface. You pull...

See similar textbooks

Similar questions

In the figure, is the tension in the rope between the ceiling and Superhero the same as the tension in the rope between Superhero and Trusty Sidekick? A. Jimmy: "Yes, of course it is the same. It's a single rope with a single tension force on both ends. Booyah!" B. Emmy: "I think they are different. The tension in the space between Superhero and Trusty Sidekick only has to hold up Trusty Sidekick, but the tension above Superhero has to hold up both Superhero and Trusty Sidekick. C. Timmy: "Wouldn't your, 'both ends' be the end on the ceiling and the end at Trusty Sidekick? How can you have a different 'both ends' for the space between Superhero and Trusty Sidekick? Wouldn't that only work if they had two different ropes? Or if the rope breaks? The rope clearly holds, so the tension force must be the same everywhere along the rope. " D Figure 438 Superhers and Tunty Sickick hang mess on a pe as they try to figure out what to do next Will the tension the the same everywhere in the p
Hello, I would need help with this question.
A 50 kg lamp is suspended by cables as shown. Determine the tension developed in cables OA, OB, and OC.
Finish the solution of the problem. Find the tension T in the rope.
When an object falls freely under the influence of gravity there is a net force mg exerted on it by the Earth. Yet by Newton’s third law the object exerts an equal and opposite force on the Earth. Does the Earth move? Explain.
5.72 .• Block A in Fig. P5.72 weighs 60.0 N. The coefficient of static friction between the block and the surface on which it rests is 0.25. The weight w is 12.0 N and the system is in equilibrium. (a) Find the friction force exerted on block A. (b) Find the maxi- mum weight w for which the system will remain in equilibrium. Figure P5.72 A 45.0°
Two blocks are supported by a pulley along an incline as shown. The lower block B has a weight of 30 lbs and the higher block A has a weight of 20 lbs. Assume that there is friction between the blocks with Hs = 0.15 and assume no friction between block Band the incline. Determine the angle z for which motion is impending. 201b 301b A Tension in block A as a function of z can be written as TA %3D Tension in block B as a function of z can be written as Tây Thus, impending motion is at z = degrees.
Chris, a recent physics major, wanted to design and carry out an experiment to show that an objects mass determines its inertia. He used an ultrasound device to measure acceleration of a low-friction cart attached to a hanging block to provide the same force on the cart during each run (Fig. P6.76A). Chris varied the mass of the cart by varying the number of lead rods placed in it. Chris used Newtons second law Fx=FT=Max to predict his results. He reasoned that because FT is the same for each run, the carts acceleration should be inversely proportional to its mass: ax=FTM=constantM(1) Chriss goal was to show that his data fit Equation (1). He decided to analyze his results by plotting ax as a function of 1/M; Equation (1) predicted that he should get a straight line, passing through the origin with a slope equal to the tension (red line in Fig. P6.76B): Chris ran several trials for each run, averaged his results and estimated the error. He then plotted his data (green line in Fig. P6.76B). Chris was excited to see that he correctly predicted that the data fell along a straight line: ax=(0.27N)1M(0.048m/s2) According to the straight-line fit to the data, the slope of the line is 0.27 N, which was close to the weight of the hanging mass and therefore close to the tension in the string. Chris, though, was disappointed to see that the line had a negative intercept. Mathematically, as M, 1M0. Chris was confused because he believed that as the mass increased, the carts acceleration should approach zero. He was quite sure that he did not discover some new property of inertia or mass. After convincing himself that he was not being careless in the laboratory and that his data were correct, he started to search for an explanation for the discrepancy between his prediction and his data. Help Chris find an explanation. FIGURE P6.76 A. Chriss experimental apparatus. B. Chriss prediction (red line) and experimental results (green line).
Figure P7.45 shows a picture of American astronaut Clay Anderson experiencing weightlessness on board the International Space Station. a. Most people have the misconception that a person in a spacecraft is weightless because he or she is no longer affected by gravity. Show that this premise cannot be true by computing the gravitational field of the Earth at an altitude of 200 km the typical altitude of a spacecraft in orbit. Compare this result with the gravitational field on the surface of the Earth. b. Why would astronauts in orbit experience weightlessness even if they are experiencing a gravitational field (and therefore a gravitational force)?
Give reasons for the answers to each of the following questions: (a) Clan a normal force be horizontal? (b) Can a normal force be directed vertically downward? (c) Consider a tennis ball in contact with a stationary floor and with nothing else. Can the normal force be different in magnitude from the gravitational force exerted on the ball? (d) Can the force exerted by the floor on the hall be different in magnitude from the force the ball exerts on the floor?
What is the direction of the force exerted by the car on the passenger as the car goes over the top of the amusement ride pictured in Figure 6.33 under the following circumstances: (a) The car goes over the top at such a speed that the gravitational force is the only force acting? (b) The car goes over the top faster than this speed? (c) The car goes over the top slower than this speed?
A block of ice (m = 15.0 kg) with an attached rope is at rest on a frictionless surface. You pull the block with a horizontal force of 95.0 N for 1.54 s. a. Determine the magnitude of each force acting on the block of ice while you are pulling. b. With what speed is the ice moving after you are finished pulling? Repeat Problem 71, but this time you pull on the block at an angle of 20.0.