23. If the specific weight of liquid is 8.0 KN/m^3, its density is * 815.50 kg/m^3 8.16 kg/m^3 815.50 g/m^3 815.50 g/cm^3 24. A liquid has a dynamic viscosity of 4.8 x 10^-4 lb-sec/ft^2 weighs 54 lb/ft^3. Its kinematic viscosity in the SI is * 2.66 x 10^-2 m^2/s 2.66 x 10^-1 m^2/s

23. If the specific weight of liquid is 8.0 KN/m^3, its density is * 815.50 kg/m^3 8.16 kg/m^3 815.50 g/m^3 815.50 g/cm^3 24. A liquid has a dynamic viscosity of 4.8 x 10^-4 lb-sec/ft^2 weighs 54 lb/ft^3. Its kinematic viscosity in the SI is * 2.66 x 10^-2 m^2/s 2.66 x 10^-1 m^2/s

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Water from a reservoir flowing through a pipe with a diameter of 600mm at 1.80m/s is completely stopped by a closure of a valve situated 150m from the reservoir. The pipe has a thickness of 20mm. The modulus of elasticity of the pipe is 1.40x1011 Pa. The bulk modulus of water is 2.20x10 Pa. Assume that the pressure increases at a uniform rate and there is no damping of the pressure wave. Which of the following most nearly gives the water hammer pressure assuming instantaneous closure?
Calculate the friction drag on a plate (length 0.8 m and width 0.3 m) up to the point at which the boundary layer flow changes from laminar to turbulent. The water is flowing from both sides of the plate at a rate of 3 m/s. (u = 9 × 104 Pa-s ; critical Reynolds number Rec = 5 x 105)
Air is flowing over a smooth plate with a velocity of 10 m/s. The length of the plate is 1.2 m and width is 0.8 m. If laminar boundary layer exists upto a value of Re = 2 x 105, then find the maximum thickness of laminar boundary layer if the kinematic viscosity of air is 0.15 stokes.
Fluid Mechanics Last fall, researchers using a manned submarine discovered coral reefs at unprecedented ocean depths of 1/2 mile, of the coast of South Carolina. Find the hydrostatic pressure at that depth. Find the fractional changes in density (drho/rho) and in volume (dV/V) for the seawater at that depth. The density of seawater at the surface of the ocean is 1025kg/m3, and the bulk modulus of elasticity of seawater is 2.34*109 Pa.
A sound wave is observed to travel through a liquid with a speed of 1290 m/s. The specific gravity of the liquid is 1.5. Determine the bulk modulus for this fluid. EN = N/m²
Civil Engineering In the figure below, calculate the seepage from the bottom of the pond and the head at the interface between the two materials? 8 m 3 m K=1x 105 m/s S, = 0.12 1m K=1x 10° m/s S=1 x 105 Om
A cylindrical shell, 0.8 m in diameter and 3 m long is having 10 mm wall thickness. If the shell is subjected to an internal pressure of 2.5 N/mm², determine (a) change in diameter (b) change in length and (c) change in volume. Take E = 200 GPa and Poisson's ratio = 0.25.
Figure Q.3 shows a liquid reservoir that is density stratified. The top layer has thickness b and uni- form density pt. The middle layer has thickness d and a linearly varying density given by Pt (") (h - b) Pb - Pt P(h) = Pt+ d p(h) for (b Pt. Figure Q.3. Use the information provided above and in Figure Q.3 to derive the gauge pressure distribution for the liquid in the reservoir.
The ocean's pressure at a depth of 9.9 km is 79.09 MPA. Recognizing that the unit volume weight of the ocean on the surface is 10,909 kN / m3, the modulus of elasticity for the pressure change between the surface of the ocean and a depth of 9,9 km is 2,909 GPa; a) find the change in specific volume between the surface and the depth of 9.9 km of the ocean. b) find the specific volume at a depth of 9.9 km. c) find a unit volume weight at a depth of 9.9 km.
When a pressure of 2×10^4 kN/m² is applied to 50 litres of a liquid, its volume is decreased by 0.5 litre. The bulk modulus of liquid in N/m² is
The ocean's pressure at a depth of 9.9 km is 7a,bc MPa. Recognizing that the unit volume weight of the ocean at the surface is 10,abc kN /m^3, the modulus of elasticity for the pressure change between the ocean surface and a depth of 9,a km is 2,abc GPa; a) find the change in the specific volume between the surface and the 9,a km depth of the ocean. b) find a specific volume at a depth of 9,a km. C) find a unit volume weight at a depth of 9,a km.