21. Protocol responsible forbreaking data being sent across a connection into small packets, and then reassembling these when they arrive at their destinatic

Q: Routing refers to determining the route taken by packets from source to destination, and is…

A: Routing refers to determining the route taken by packets from source to destination and is…

Q: Suppose end system A wants to send a large file to end system B. At a very high level, describe how…

A: Introduction: Packets: A Network Packet is the fundamental unit of information transmitted over a…

Q: The word for the physical route a communication takes from sender to recipient is path.

A: The medium through which a person  communicates i.e. communication travels is known as the channel.…

Q: Checksum is used by various protocols on the Internet, but not at the one of TCP / IP Explain.

A: Standard Internet Protocols such as IP, TCP and UDP use the Internet checksum. This value is used to…

Q: 1. A router receives a packet with destination address (222.186.114.16) how how it finds the network…

A: In order for a router to find the network and subnetwork address for a given packet, it must first…

Q: 11. TCP receiver window: O is an internal trasmitter parameter O is a 32-bit number O is related to…

A: TCP receiver window: It communicates with sender about the number packets need to be send through…

Q: 4. Compare and contrast byte-stuffing and bit-stuffing. Which technique is used in byte-oriented…

A:

Q: Q: In a structured overlay network, messages are routed according to the topology of the overlay.…

A:

Q: datagra

A: Dear Student, The answer to your question is given below -

Q: Most IP datagram reassembly algorithms have a timer to avoid having a lost fragment tie up…

A: Find Your Answer below

Q: It is possible to classify protocols that operate on networks according to the levels of the.

A: Introduction: This article divides protocols into layers according to the OSI model. Despite the…

Q: Assembly instructions

A: Given :- In the above question, a statement is mention in the above given question    Need to write…

Q: Most IP datagram reassembly algorithms have a timer to avoid having a lost fragment tie up…

A: IP Datagram Reassembly Algorithm: There will be two phases to the algorithm's explanation. In the…

Q: Suppose a computer sends a packet at the network layer to another computer

A: Let suppose a system sends a packet to another system somewhere in Internet at the network layer.…

Q: For NAT Network Address Translation Scenario: Jenny Bello is a small business owner selling and…

A: We need to answer questions related to private IPv4 address.

Q: puter Science: True or False. "With no persistent connections between browser and origin…

A: "With no persistent connections between browser and origin server, it is possible for a single TCP…

Q: ACK packets don't need to be consecutively numbered for what reason?

A: Given: The reason for this is because ACK packets do not need sequence numbers.

Q: What are the benefits of dividing a single logical message into a number of fixed packets and…

A: Intro A method of transferring the data to a network in form of packets is called packet switching.…

Q: To begin, what exactly is the function of a router?   2) What is a data packet, and how is it…

A: Introduction: Network of Computers: A computer network is a computerized media communications…

Q: Most IP datagram reassembly algorithms have a timer to avoid having a lost fragment tie up…

A: please check the solution below

Q: A technique for identifying and correcting errors in received data at different layers of a protocol…

A: Introduction: This question explains about A technique for identifying and correcting errors in…

Q: What is the reason why ACK packets don't need to be sequentially numbered?

A: Given: We learned that the sender need sequence numbers so that the receiver can determine if a data…

Q: It is theoretically feasible for two hosts to communicate with one another by sending packets back…

A: Multiple packets may be delivered between two hosts over a single network connection when data is…

Q: Most IP datagram reassembly algorithms have a timer to avoid having a lost fragment tie up…

A: The receiver will have no record left of fragments with this identifier, so it will buffer it,…

Q: Most IP datagram reassembly algorithms have a timer to avoid having a lost fragment tie up…

A: Find your Answer below

Q: A connection between two hosts is capable of carrying several packets at the same time. I would…

A: In computer networking, a host is a device or computer system that is connected to a network and…

Q: The phrase "physical path" refers to the actual route taken by a communication from sender to…

A: Messages are sent from sender to recipient via a physical path that follows a set of rules/protocols…

Q: Most IP datagram reassembly algorithms have a timer to avoid having a lost fragment tie up…

A: The fourth and final fragment is considered by the receiver as a new datagram. This fragment is…

Q: Before a packet can be transmitted to a host or router, it must first go via two levels of…

A: Switching of packets: Packet switching is a way of arranging data transferred across a digital…

Q: What is a random access technique and what are its two protocols?

A: Determine random access mechanism and identify two protocols in this category. Random Access…

Q: TCP session sends 50 packets per second over an Ethernet Local Area Network (LAN). Each packet…

A: TCP session sends 50 packets per second over an Ethernet Local Area Network (LAN). Each packet…

Q: Compare and contrast byte-stuffing and bit-stuffing. Which technique is used in byte-oriented…

A: Answer: We need to write the differences between the byte-stuffing and bit-stuffing . so we will see…

Q: Suppose the router receives a Protocol Data Unit greater than the next hop's Maximum Transmission…

A: Suppose the router receives a Protocol Data Unit greater than the next hop's Maximum Transmission…

Q: Please define random access method and identify the two protocols that fall under this umbrella.

A: Random access method refers to a way of sharing a communication channel where all devices have equal…

Q: Two transport-layer protocols offer services that certain applications may make use of (UDP or TCP).…

A: Layer 3 or Network layer uses IP or Internet Protocol which is a subset of the protocol that manages…

Q: In certain cases, applications may make advantage of services provided by both of these…

A: If the devices are directly connected to one another, then the discussion will utilise TCP. When two…