20 29. The time required to irrigate a strip of area 0.203 hectare by a stream discharge of 0.043 cumec, for an average depth of 6.35 cm to the field is (assume average rate of infiltration to be 5 cm/h) (a)2.75 hour (approx.) (6)1.30 hour (approx.) (c) 1.5 hour (approx.) (d) 1.90 hour (approx.) A $11

Q: Design the dimension of aquic sand filter in a water purification project that serves acity with a…

A:

Q: Determine the greatest dissolved-oxygen deficit and the minimum dissolved-oxygen concentration…

A:

Q: 2. During a 10 hour rainfall, precipitations in Table are observed. Table: Precipitations (mm) hour…

A:

Q: A field was supplied with water from an irrigation tank at a rate of 120 lit/sec to irrigate an area…

A: Rate of irrigation = 120 lit/secArea = 2.5 hecDuration of irrigation = 8 hrRunoff loss = 800 m3To…

Q: Ex 9-3: land is planted by crop of consumptive use 14 m³/donum/day, minimum limit of sprinkling rate…

A:

Q: Estimate the storage change (ft) for this lake during the month.

A: Evaporation Evaporation is one of the process in hydrologic cycle in which water from different…

Q: 1. On January 1, a lake with a surface area of 10,000 hectares has a water surface elevation of…

A: Given data - Surface area of lake = 10000 hac Water surface elevation at starting = 50.15m Avg…

Q: Q- Find the maximum area that can be irrigated, when the tube well is discharging at the rate of…

A:

Q: Given an initial infiltration capacity f0 of 2.9 in/hr and a time constantk of (0.28 /hr), the…

A:

Q: Find the time required to irrigate a strip of an area of (120 X 15) m² by a stream of discharge of…

A:

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.