2.Find the minimum work done per Kg of air in a cycle according to the following processes: a. Isothermal expansion from state 1 to state 2. b. Constant volume compression from state 2 to state 3. c. Constant pressure compression from state 3 to the initial state. Data: P1= 350 KPa V1 = 1 m3 /Kg T3 = 16500 C d. Represent the work on a p-V diagram.

Q: of 2 kg in a closed system undergoes three processes in series: Process 1-2: isochoric process from…

A: Given data p1 = 1 bar, V1= 4 m^3 P2 = 2 bar V3 = 2 m3 V4 = 1 m3 Mass of gas (m) = 2 kg

Q: Air is compressed in a piston-cylinder assembly from p₁ - 10 lb/in², T₁-500°R, V₁-9 ft³ to a final…

A:

Q: Sketch the processes on a p-v diagram and determine the work per unit mass of air, in kJ/kg

A:

Q: An oil pump operating at steady state delivers oil at a rate of 11 lb/s through a 1-in-diameter exit…

A:

Q: Q1: (A) kg of air is compressed causing its temperature to increase from 25K° to 100K°. If the…

A: Given dataTemperature of the air is increasing from 25K to 100KSpecific heat of air Cp(T) =…

Q: Air is compressed in a piston-cylinder assembly from p₁ = 25 lb/in², T₁ = 500°R, V₁ = 9 ft³ to a…

A:

Q: Sketch the two processes in series on a p-v diagram. Assum- ing ideal gas behavior, determine (a)…

A: for solution refer below images.

Q: Q.5: A piston/cylinder contains water with quality 75% at 200 kPa. Slow expansion is performed while…

A:

Q: One-quarter Ibmol of oxygen gas (O₂) undergoes a process from p₁ = 20 lb/in², T₁ = 500°R to p2 = 150…

A:

Q: Initially contains Air: P1 = 30 lbf/in^2 T1 = 540 °F V1 = 4 ft^3 Second phase of process involving…

A: Given    Work done, W = 1 Btu   Heat energy, Q = 12 Btu Find   Energy Balance (Internal Energy, U)

Q: 4. Considering the Typical Energy Balance for gasoline engine, @ atmospheric condition of 1.013 bar…

A: Introduction: A four-stroke engine sometimes known as a four-cycle engine is a type of internal…

Q: Create an isothermal process that takes a gas/thermodynamic system from a Pi, Ti, Vi to a state…

A:

Q: In a piston-cylinder assembly, there is initially a pressure of 300 kPa, a temperature of 150oC and…

A: Given that, Initial pressure of air inside a cylinder, P1=300 kPa,Initial temperature of air inside…

Q: As shown in the figure, Refrigerant 22 enters the compressor of an air conditioning unit operating…

A:

Q: A closed system of 2 kg of alr initially at a pressure of 5 bar and temperature 227° C expands…

A: Given that,       m=2 kg, p1=5 bar=500 kPaT1=227°C=227+273=500 Kp2=2 bar=200 kPa,  law of process is…

Q: 2. A piston-cylinder arrangement initially contains Argon at 0.95 bar, 67 and at a volume of 0.10…

A:

Q: Air is compressed in a piston-cylinder assembly from p₁=10 lb/in², T₁ = 500°R, V₁ = 9 ft³ to a final…

A:

Q: a- A piston cylinder maintaining gas at 137kpa , 16°C, and the volume is 0.2 m3. The gas is…

A: Dear student,                     In this post, there are three different problems but according to…

Q: 4. A cylinder contains 0.12 m³ of air at 1 atm and 90 °C. The air is compressed to a volume of 0.03…

A: Consider a gas having initial state of PressureP1, TemperatureT1 and VolumeV1 is undergone a…

Q: One-quarter Ibmol of oxygen gas (O2) undergoes a process from p1 = 20 lbę/in?, T1=500°R to p2 = 150…

A:

Q: Air is compressed in a piston-cylinder assembly from p₁ = 25 lb/in², T₁ = 500°R, V₁ = 9 ft³ to a…

A:

Q: A piston-cylinder device contains 3.2 kg of air initially at 300 kPa and 227 °C (State 1). The air…

A: The mass of air is The initial pressure is The initial temperature is The volume at state 2 is The…

Q: Air occupies a 0.5-m' tank. It starts at a pressure of 5 bar and a temperature of 300 K. Energy…

A:

Q: The figure belows shows three components of an air-conditioning system, where T3 = 105°F and m3 =…

A:

Q: One-quarter Ibmol of oxygen gas (O₂) undergoes a process from p₁ = 20 lbf/in², T₁ = 500°R to p2 =…

A:

Q: is compressed in a piston-cylinder assembly from p₁ = 25 lbg/in², T₁ = 500°R, V₁ = 9 ft³ to a final…

A: Given-To find-work and heat transfer in Btu

Q: Q2: : Which statements are true for source of requirements and which are false? If false, please…

A: Solution:

Q: Air occupies a 0.5-m' tank. It starts at a pressure of 5 bar and a temperature of 300 K. Energy…

A:

Q: Q1 a- A piston cylinder maintaining gas at 137kpa , 16°C, and the volume is 0.2 m3. The gas is…

A:

Q: One-quarter Ibmol of oxygen gas (O2) undergoes a process from p1 = 20 lbę/in?, T1 = 500°R to p2 =…

A:

Q: Initially contains Air: P1 = 30 lbf/in^2 T1 = 540 °F V1 = 4 ft^3 Second phase of process involving…

A: Given   Final pressure, P2 = 20 lbf/in2 = 137.9 kPa    Final volume, V2 = 4.5 ft3 = 0.127 m3     Gas…

Q: Please consider steam that entered a device at 1 MPA and 400 C and exited at 2.4 MPa and 300 C. Let…

A:

Q: Steam enters a turbine with a pressure of 30 bar, a temperature of 440 C, and velocity of 160 m/s.…

A: Note: As per our guidelines we are supposed to answer only the first 3 sub-parts. Kindly repost…

Q: find the work done in the whole process in kJ. Draw the P-V diagram for the cycle.

A:

Q: A particular substance undergoes a mechanically reversible process, expanding m an initial state of…

A: Giveninitial pressure P1=60barinitial volume V1=0.002m3final pressure P2=20barfinal volume…

Q: Solve par d,e,f

A: d) 0.0455 kg/se) Waste heat transferred 8.3674 kw    Compressor work input 2.9687 kW…

Q: Identify the Enthalpy of State 1 to 4 (h1, h2, h3 and h4)

A: It is asked to find the enthalpy at each state points

Q: A system consists of 2 kg, of carbon dioxide gas initially at state 1, where p₁ = 1.5 bara, T₁ =…

A: Given: Mass, m = 2kg P1 = 1.5bara T1 = 400K To find: a) ∆u12b)  ∆u23c) ∆u31d) Thermal efficiency

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.