2.Compute the maximum force P that can be applied by the machine operator, if the shearing stress in the pin at B is 4000 psi and the axial stress in the control rod at C is 5000 psi. The diameters are 0.25 inch for the pin, and 0.5 inch for the control rod. Assume single shear for the pin at B.

Q: 1. The link acts as part of the elevator control for a small airplane. If the attached aluminum tube…

A: Given data: F=600 Ndi=25 mmt=5 mm Need to determine the maximum shear stress in the tube.

Q: Please solve this question in detail. You have to add the free body diagram.

A:

Q: Solve Problem for the maximum shear stress within regions AC and BC, and the angle of twist f of end…

A: Considering Section AC, Maximum Shear Stress: Considering Section BC, Maximum Shear Stress:

Q: Problem 1: What is the shear stress at point A if the internal shear, V, is 147 kN? 0.2 m 0.2 m 0,2…

A:

Q: A shaft with a diameter d = 25 mm must transfer a torque of 23 Nm by using a key joint. The key has…

A:

Q: A 6" diameter pulley attached to a 1" diameter shaft of 2" length is supporting a load of 2000 lb.…

A:

Q: Compute the outer and inner diameter of the hollow circular rod when it is subjected to an axial…

A: Given data as per question Axial pull = 350 KN Allowable stress = 125 N/mm2 Thickness of rod = 10 mm…

Q: Page 428. Sample Problem 6.1.Solve this problem completely;but replace theapplied point-forceon the…

A: The cross section dimension are The I of the section is 8.63*10-6 m4 The centroid location from top…

Q: The "C" clamp shown in the following figure has a rectangular cross section at location "a-a" with a…

A:

Q: In Problem 1, determine the required        diameter of the pin at A if the allowable…

A:

Bending Moment

In general, we can define the bending moment as the reaction induced when a certain amount of load or force is applied to an element which makes it bend.