2.84 1.25 0.78 130.50 2.00 -0.50 1.50 01.25 0.60 0.60 1.14 PUDA 32 Drill 0.54 1.00 0.38 0.78 RO 20 1.50 0.22 0.78 0.28 25 Drill 2 Holes 4.50 0.40

Q: Given the top and front view create a section view.

A: Find Create a section view using the given top and front views.

Q: (Compute) What is line OA's direction cosine angle, in degrees, from the y-axis (θy)? Note that…

A: The cosine angle between two vectors  is as followes,

Q: Need auxiliary views of this drawing

A: This question is based on the concept of engineering drawing.

Q: If the part was cut by this plane, what would the resulting remaining face look like?

A: Section planes in SketchUp cut a model along a plane so you may look within it without altering…

Q: The front and top views are given. Use this to create the missing side view. Note the front view is…

A: The required missing side view for A and B and the missing lines for C are drawn below.

Q: Identify the following sectioning views (a, b, and c). a O Removed, Revolved and Removed O All…

A:

Q: pr... below. 5) Sketch the appropriate sectional view on the front view of the part

A: Given:To find:Sectional view on the front view.

Q: Directions: Draw an isometric view of the following orthographic views. Views most be properly…

A: Draw an isometric view of the following orthographic views.Views most be properly aligned attached.…

Q: Given the front, top and side views of the drawing add the missing lines (center, object, and…

A:

Q: A hammer is balanced at the point "A", close to the metal part. If this hammer is then cut along the…

A: Consider the diagram shown below for the hammer with the center of masses for each side.

Q: y Side 3 Side 1 8.0 Side 4 Side 2

A: Plz mention what to do?

Q: Given the multiview projection of the solid, draw the isometric view. HRP FRP F DA FRP PRP

A: Given the multiview projection of the solid, draw the isometric view.

Q: Why cos(60 if I don't see that angle in the figure

A: This question can be solved by labelling angles.

Q: Draw an orthographic(three-view drawing) of the four objects including front, top, and right views

A:

Q: what is the ybar distance(distance from bottom edge of triangle to centroid)?    options:   40/3…

A: Given, Right-angled triangle of, Base, b=20 in Height, h=9 in

Q: Top View Front View Right side View

A: according to the given details in the question, the Drawing of the figure is shown below. as…

Q: 1. Draw top, front and right side views of the bracket as shown in Fig.

A: Required Front view, Top view and Right hand side view are drawn using third angle method of…

Q: Shade in the surfaces that will appear in the front, top, and right side views. Estimating the…

A:

Q: Q1: Use scale (1:1), draw the front, top & side views of shape shown below. (50 M)

A: Orthographic Projection It is a form of presenting a three-dimensional object into Two dimensional.…