[2.53] A rod consisting of two cylindrical portions AB and BC is restrained at both ends. Portion AB is made of brass (Es =105 GPa , ab= 20.9 x 106 /°C) and portion AB is made of aluminum (E,=72 GPa , a,= 23.9 x 10-6 /°C). Knowing that the rod is initially unstressed, determine (a) the normal stresses induced in portions AB and BC by a temperature rise of 42°C, (b) the corresponding deflection of point B.

Q: Problem 2. Two rods connected at B are restrained at points A and C. The section AB is steel and Es…

A:

Q: (a) A steel cylinder of 60 mm inner radius and 80 mm outer radius is subjected to an internal…

A: Note: As per the bartleby guidelines only three subpart will be solved at a time for remaining…

Q: The 250 x 250 x 1.100-mm oak [E = 12 GPa] block (2) shown is reinforced by bolting two 7 x 250 x…

A:

Q: 2.47 The rigid block of mass M is supported by the three symmetrically placed rods. The ends of the…

A: To find : The largest allowable value of M. Given : The length of copper rod is lcu=160 mm. The…

Q: A steel shaft of diameter 50 mm and length 1.2 m (E = 210 GPa and v = 0.3) is loaded with multiple…

A:

Q: as is subjected to a static eccentric force of F=25 kN in the plane of the welds. The allowable…

A: Given:- l1=350mm l2=200m d1=37.5mm d2=75mm

Q: An aluminium pipe is rigidly clamped to the face of a concrete building. On a hot day the face of…

A:

Q: A standard tension test is used to determine the properties of an experi-mental plastic. The test…

A: Given data Tensile force, P = 800 lb. The diameter of the specimen, d =5/8 in. Length of a…

Q: 1. Three vertical wires each 4.5m long hang in the same vertical plane from a horizontal ceiling and…

A:

Q: HOMEWORK Determine the required cross sectional areas of all the remaining members of the given…

A: Determine the required cross sectional areas of all the remaining members of the given truss shown,…

Q: 1. The normal strains of a solid under a uniaxial stress of 60MPa are and. When the solid is subject…

A: Given:The normal strains are given below;The uniaxial stress, The hydrostatic stress,

Q: Problem 2. Three loads are applied to the short sectional dimensions of the post are shown in Fig…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.