2.41 In the circuit shown in the image below, if R₁ = 68 Q and R₂ equivalent resistance Req = 50 , determine resistance R in Q. Rea 30 Ω www. Your Answer: 10 Ω Answer R₁ 12 Ω R R₂ 12 Ω Please pay attention: the numbers may change since they are randomized. Your answer should keep 1 place after the decimal point. = 13 22, and the

Q: Thanks for your helping

A: It is our pleasure that you get what you were looking for.

Q: What is the voltage drop across RC, VC, in volts?  (Enter the number, not the units.)

A: Given circuit is -

Q: A PV module has been tested using a steady-state solar simulator, and the following I-V and P-V…

A: To extract the maximum power from the PV, there are multiple MPPT controllers are used nowadays P…

Q: fca) = Th 2. 2.

A: See attachment

Q: Q-01 (What is called Buck Converter & What is called Boost Converter?)  give two examples for each.

A: Explanation: The buck converter is a ubiquitous DC-DC converter that correctly converts an excessive…

Q: do you have any other method to solve this problem??

A: In the given circuit,we need to find above mentioned parameters.

Q: Whale and Kanmuro are two islands located in the Chimera archipelago. These two are separated by a…

A:

Q: For each of the following, determine which specific material is used and what specific properties…

A: Cell phone batteries(smartphones):   They are durable and both have been in we source of fuel and…

Q: What information is contained in the specification K, 10,000

A: Kp stands for the position error constant for the step input function.  here, Kp = 10000

Q: Can we replace the Fossil Fuels? How?

A: Can we replace the Fossil Fuels? How?

Q: Grateful a little help with this homework thanks.

A:

Q: Based on the computed TEC (Thevenins Equivalent Circuit), What is the voltage across the load R3, in…

A: In this question,  We need to determine the voltage across the resistance R3  in Volt.  We are…

Q: Give examples of 3 sensors and 3 actuators which can be used in your smart house. Label the sensors…

A: given that 3 examples of sensors and actuators needs to provided which is used in making of smart…

Q: the truth table above for the original or simplified equation? I need both if possible. Sorry for…

A: Here one of the expert directly written the output F values.So For  your understanding purpose i am…

Q: Numerical answer: A 14-bit DAQ device is used to measure a voltage range of +-8 Volts. What is the…

A: For the given Digital to Analog converter specifications the value of resolution needs to be…

Q: Numerical answer: A 14-bit DAQ device is used to measure a voltage range of +- 8 Volts. What is the…

A: Resolution is the smallest change in the DAQ voltage due to transition of LSB bit.If there are n…

Q: Could you explain this question in details, please. Embedded System (Electrical & Electronic…

A: we need to explain the meaning of Embedded System and its subpart.

Q: Q) In measurement system, which of 1 point the following static characteristics are desirable? *…

A: Accuracy is the degree of closeness of the measurement and sensitivity is the how output is reacts…

Q: Don't use ai to answer I will report your answer Solve it Asap with explanation... What is a wind…

A: We should separate what a wind rose is and its importance in wind energy analysis in more…

Q: What is the primary focus of materials science? A) Studying the behavior of gases B) Investigating…

A: The main goal of material science is to comprehend the composition, behaviour, and structure of…

Q: What are the Rules in Performing Laboratory experiments in the Electrical Engineering Laboratory?…

A: It's vitally important to take safety precautions when working with electricity. Safety must not be…

Q: 1. Define two (2) types of Power Electronics application with diagram and gives one for each types.…

A:

Q: Could you answer this question in details and giving examples if possible. Thanks a lot.  - Explain…

A: we need explain Arbitration in CAN BUS.

Q: Determine Reg in Ohms at the (a,b) terminals for the following circuit. Round your answer to the…

A:

Q: P-channel MOSFET is basically a following device. a. voltage operated O b. low-frequency operated O…

A: MOSFET is controlled by the application of GATE pulse .  GATE pulse controls the conduction state of…

Q: where is the value of 10/sqrt(2) coming from?

A:

Q: where did the 100 come from? Thank you.

A: In the given solution Xc<<1.5k Where Xc is  reactance of the coupling capacitor .

Q: Give brief answer only. Define DPST along with it's symbol and uses.

A: DPST switch: Definition with symbol? Uses?

Q: Describe the job of the Board of Electrical Engineering in one sentence.

A: The solution is given

Q: Electronic Measurements and Instrumentation(EMI) subject. Provide handwritten answer. WRITE THE…

A:

Q: 200 200 20 0.53

A:

Q: Explain the benefits of using analogue and digital electronic devices/systems, using the following…

A: Telephones:Analog: Analog telephone systems transmit voice signals as continuous electrical signals.…

Q: Which of the following is an example of analog data? a.The number of pens in your pencil case.…

A:

Q: V1 Op-amp V; = 0 Rf R1 R1 Fig. 3.11 (a) Non-inverting amplifier (b) Equivalent circuit with virtual…

A:

Q: With the help of schematics, briefly describe, how a telephone set works.

A:

Q: Draw bread board connection diagram for full adders along with tables and pin configuration of ICs…

A: Full adder truth table: Thus, Sum, S=X⊕Y⊕Cin and Carry, Cout = (X*Y) + ((X⊕Y)*Cin) So, the circuit…

Q: Describe what a maintenance work order in electrical engineering should contain.

A: Electrical maintenance is one of the most important thing which keeps the system healthy,durable and…

Q: 3. In the circuit below find V (x) for t > 0 if i(0) = 6A. 6 H ell 10Ω 0.5i Vx 40 2 +

A: Source Transformation- Source transformation is a method in which the supply source in any…

Q: 3. With the help of a solar panel name plate, explain each and every parameter displayed in it in a…

A: Solution3 - Generally, a solar panel nameplate contains the following parameters - 1. Maximum…

Q: Could you answer this question in details and giving examples if possible. Thanks a lot.  - Explain…

A: The Controller Area Network (CAN bus) is a standard automotive bus system designed to allow…

Q: An experiment consists of making a A. Not all above B. Expectation value C. Probability 1 D.…

A: An experiment consists of making a  A. Not all above B. Expectation value C. Probability 1 D.…

Q: Question 4 What do you do to an asynchronous counter to let it count from 1 to 13? (Handwriting…

A: The solution is given below

Q: Music can be sampled without permission of the licensor in cases of hip-hop songs True or False?

A: No, we can't sample music without permission, no matter how short or long or which type of cases of…

Q: can you please help me on a home work question. havent worked with this stuff in 47 years

A:

Q: Can you please further explain how you used the ID equation to find the solution? Thank you

A: ID=IDSS1-VasVP2from figureIDSS=6.5mAVP=-5Vand Vas=Va-VsVas=0-Vs=-Vsalso ID=VsRs=0.1 Vs mANow put…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.