2.4 Three forces are concurrent at point 0, and the tension in cable T = 5,000# with the slope as shown Determine the magnitudes necessary for T2 and T such that the resultant force of 10 k acts vertically down the axis of the pole. Scale: 1" = 2,000#. %3D %3D TSancy

Q: The cable supports the uniform load of Wo=600 lb/ft. Calculate the following: Calculate the location…

A: To find out the,  a) minimum tension in cable A and B b) inclination of tangent line at A C)…

Q: ET Find the tensile stress Jab in cable AB

A: Given data :

Q: The horizontal bar is supported by two cables AC, AB, and the ball-and-socket joint at O. Calculate…

A: Solution - Given, F=3867N

Q: PROR 166 AP Cable sling 32° 32° Clevis 2.0 m Steel plate (2.5 x 1.2 x 0.1 m)

A:

Q: 3) The cable shown below is supported by two pins at A and B. The maximum cable tension due to the…

A: Given data:- The maximum cable tension due to applied forces is, T= 1200 lb

Q: 1-35 The anchor shackle supports a cable force of 600 lb. If the pin has a diameter of 0.25 in.,…

A: Given Shear load, Diameter of pin, d=0.25 in.

Q: Problem 4: The beam shown is 4-ft long and 0.1-ft wide. The beam is carrying a distributed pressure…

A:

Q: L & Beam AB ~ Wall b Shear release اسم spring SA, S₂ = ? B k = 48 EI L³

A:

Q: A cable supports three vertical loads as shown in If the maximum tension in the cable is 50 kN,…

A: To determine the length of the cable, first we will have to calculate the vertical distances…

Cables

Cables are collections of wires, alternatively referred to as a cord, connector, or plug. They are one or more wires covered in a plastic covering that allows for the transmission of power or data between devices. The earliest use of recognizable electrical cable was the early commercialized telegraph lines. These were iron-made and tedious to produce and install cabling.