2.35 For the circuit shown in Figure 2.29, convert the voltage sources to equiv- alent current sources and write nodal equations in matrix format using bus 0 as the reference bus. Do not solve the equations. 0.02 0 2 0.10 0.10 j.5N j.5N ーi19 Esi = 1.0 /30° V Es2 = 1.0 /0° V HI

Ip Ep=40 V f = 60 Hz N₂= 20- N₁ = 120 Find the maximum flux om om = Find the magnitude of the induced secondary voltage Es Es = units + Is Es units If the coefficient of coupling (k)= 0.75, determine the magnitude of the induced secondary voltage Es Esk=0.75 = units

4. Would you parallel a delta-delta (A - A) 3-phase transformer bank with a delta-wye (A - Y) bank, assuming their output and input terminal voltages are equal? Justify your answer by superimposing their separate vector diagrams. (Hint solve the short circuit current at the secondary for %Z = 5%) Ans. Isc=518% of secondary current

Construct the circuit in Figure 1 in the Circuit JS simulator. Note that the voltage source is given in RMS. Within Circuit JS while defining the max voltage of the voltage source include “rms” after the number to tell Circuit JS that this is a rms value. Also note that there are additional parameters when instantiating a transformer in Circuit JS. Leave these at the default values. Additionally, transformers may have problems simulating in Circuit JS.  Answer the following: 1. From the simulation results, determine the power dissipated in R2 and compare to the expected value from the previous section.2. Change the transformer ratio (“Ratio” as a fraction when you “Edit…” the transformer component) to the value calculated in the previous section to provide maximum power transfer in R2. Note: In Circuit JS, Transformer Ratio = Primary/Secondary.3. Rerun the simulation, calculate the power dissipated in R2 and compare to the expected value from the previous section.4. Change the…

Please solve thiss questionnnnn

1-Adiust the function generator to give (10 v p.p )(170) Hz.

Briefly describe the trade-offs between ripple adders and adders with carry look-ahead.

The question is in the picture below.

figure the S-parameters for an ideal transformer with turn ratio N = N1:N2 where N1 is the no.of turns of the primary winding and N2 is the no. of turns of the secondary winding.