2.26 For the inclined-tube manometer of Fig. P2.26 the pres- sure in pipe A is 0.8 psi. The fluid in both pipes A and B is water, and the gage fluid in the manometer has a specific gravity of 2.6. What is the pressure in pipe B corresponding to the differential reading shown? 3 in. 1 AL Water 8 in. 30⁰ FIGURE P2.26 SG=2.6 Water T 3 in.

Q: A compound shaft consisting of a steel segment and an aluminum segment is acted upon by two torques…

A:

Q: The force of F = 55 lb acts along the edge DB of the tetrahedron shown in (Figure 1). Figure 8 ft 10…

A:

Q: What is the position vector Ao in ft.

A: Given: Required: Position vector AO

Q: What is the shear modulus of the material whose shear stress–strain relationship is shown in Figure…

A: (a) It is required to determine the shear modulus using SI units. Here,  is the shear stress, and…

Q: calculate the following for the I -Beam: mass, normal stress, von mises stress, strain, factory of…

A:

Q: 1.7 Find the primary dimensions of each of the following terms. pV2 dA, where p is fluid density, V…

A:

Q: An experiment on an ideal gas was conducted at a temperature of 170 degrees Fahrenheit [F] and a…

A:

Q: Part A Determine the mass moment of inertia of the thin plate about an axis perpendicular to the…

A: Mass per unit area = 27 kg/m2

Q: For a given stress tensor the minimum principal stress is 50 20 200 20 40 unit.

A:

Q: in the equation below what is the appropriate unit for modulus elasticity (E) if the equation is to…

A: given, d = deflection (m) P = applied force (N) L = length of bar (m) A = cross sectional area of…

Q: Given the following principal stress tensor, what is the resulting tensor if we apply a rotation of…

A:

Q: E A В F 3 in. 2 in. G -2 in.

A: The force G does not cause any torque at D when resolved. It only creates a moment 2G and a direct…

Q: Q1) Three bars each made of different materials are connected together and placed between two walls…

A:

Q: Where does the value for yc in step two come from?

A: Since the unit weight of the concrete for the beam is not given in the problem. Usually the unit…

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?