2. You mix 20g of potassium nitrate with 100mL of water at 20°C. Describe the solution in terms of saturation. 3. There is more dissolved oxygen in the ocean the at greater depths when compared to dissolved oxygen at the surface. Using Henry's Law, descril this observation.

Q: Explain different ways to induce recrystallization.

A: Recrystallization is a process in which the previously formed crystal were dissolved in a suitable…

Q: An aqueous solution of ethyl alcohol is made by transferring 12.3 mL of liquid ethyl alcohol to a…

A: Since we know that  %(V/V) = (volume of solute /volume of solution )×100%

Q: Part IlI: Determination of Saturated Solutions

A:

Q: A 1.37 M aqueous solution of citric acid (H3C6H5O7) has a density of 1.10g/cm^3. What is the mole…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: The dry mass of a piece of textile is 1.4 grams. After 2 minutes of soaking in water the wet mass of…

A:

Q: to one of the followin

A: Cefuroxime is an antibiotic and is a type of second generation cephalosporin and used for treatment…

Q: Solubility of Ca(OH)2 in 0.25M KCI Answer the concentrations and solubility in 3 significant figure.…

A: From the standardization of HCl data,  average molarity of HCl = 0.198 M  We can find the [OH-] by…

Q: Commercial bleach is usually 5% solution of hydrochloric acid. true or false

A: Commercial bleach is usually 5% solution of hydrochloric acid. This statement is true or false…

Q: In a chem lab, you have in stock a 10% saline solution and a 50% saline solution. However, you need…

A: We have To determine how much of each saline solution to mix, we can create equations based on the…

Q: Five different solutions were prepared in the laboratory. One was prepared by dissolving 7.1g of…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Prepare 50ml of approximately 1000ppm Mn stock solution from MnCl2*4H2)

A: mole =massmolar massppm = mgL1000 mg = 1.0 g

Q: A solution that has not reached the limit of solute that will dissolve in it is said to be…

A: There are two types of solution on basis of the addition of more amount of solute-  1- saturated…

Q: 16. A child takes 15 mg of elemental iron PO BID. How many milliliters of ferrous sulfate 500…

A:

Q: Use a Venn diagram to compare mechanical mixtures and solutions.

A: Venn diagram to compare mechanical mixtures and solutions is shown in the step below.

Q: Ratio of peppermint water to make 60ml? What is the stepwise procedure for preparation of…

A:

Q: 2- How can you prepare 500ml of 5% NaOH solution ?

A:

Q: Which of the following would result in an incorrect value for the density of the acrylic slug using…

A: There are various reasons for error in density: mass change, temperature, etc.

Q: which method we are going to use in ipecac syrup define and explain this method.

A: Ipecac is commonly made from alcohol extraction of the plants Cephaelis acuminata and Cephaelis…

Q: is In the school laboratory, a usually used as fractionating column. The glass called as beads serve…

A: A fractional distillation is used to seperate volatile compounds having their similar boiling point,…

Q: Two metals X and Y are mutually soluble in all proportions in the liquid state, but are completely…

A: We have find out answer by drawing binary X-Y phase diagram.

Q: mg of metroprolo

A:

Q: I think you weren't able to finish the solution?

A:

Q: 11) How many milligrams of tetrhydrozoline HCI would be used in preparing the following…

A: Percent of tetrahydrozoline HCl = 0.05%Volume of the solution = 15 mLmilligrams of tetrahydrozoline…

Q: Stock solution (a) A volume (V₂) containing the desired moles of solute (M,) is measured from a…

A: As we know , Moles the solute remains same on dilution but volume of the solution increases.…

Q: 2. What total dilution would you need to produce a 2 mM sample from a 100 mM stock solution?

A: M1 x V1 = M2 x V2

Q: 1) 500 ml of .50 M NaC1 from 2.0 M original stock solution?   2) 2.0 L of .20M MgS04 from .50 M…

A:

Q: A prescription calls for 120 mL of 10% codeine solution. Your stock solution of codeine is 50%…

A: Given: Volume of final solution = 120 mL Concentration of final solution = 10 % And concentration of…

Q: Determine how to make a sufficient amount of 3% by weight H202 from 30% by weight solution

A: The mass of solute requires for 3% and 30% percent by weight solution are determined as,

Q: Cells allow  ______to diffuse slowly but freely across the cell membrane to generate a membrane…

A:

Q: What volume of a 2.5mM extraction solution would you need to obtain a final concentration of 200μM…

A: Given: Molarity of original solution, M1 = 2.5 mM = 2.5×10-3 M Molarity of final solution, M2 = 200…

Q: a mixture containing only water and salt must be boiled to seperate the salt from water true or…

A: Yes the above statement is TRUE. But the above boiling must be done in a distillation flask.

Q: Solubility of gases in water with _____ pressure, _____       ( Please type answer note write by…

A: Solubility of gases in water with _____ pressure, _____

Q: Matter is defined as ....... إجابتك Felite is إجابتك

A: 2. The term matter refers to anything that occupies space and has mass—in other words, the “stuff”…

Q: Prepare serial dilutions of 0.08M potassium chloride and 0.08M SLS from the stock solutions…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: How can we remove hardness from water? write any one method

A: The hardness of water are  two types: 1.Temporary Hardness :The presence of magnesium and calcium ,…

Q: 3. Give the molar concentration of HCI with a specific gravity of 1.18 and 37.0% (w/w) purity…

A:

Q: 1. How does the increase in solute concentration affect the conductivity of that solution?

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: A pipette is used to deliver specific volume of solution. Which type of pipette would you use to…

A: Two common types of pipettes used are volumetric pipettes and micropipettes.

Q: What is an analytical balance?

A:

Q: How would i convert 0.01 ng per microliter to mililiters.

A: In general concentration of a solution is expressed with units like ng(Nanogram)/Microliter or,…

Q: Use the References to access important values if needed for this question. An aqueous solution of…

A: The mass of iron(II) bromide is = 3.92 g The mass of water is = 17.7 g The weight/weight percent of…

Q: A 1mL solution contains a 20X diluted sample. How do you make a spike solution that contains 100uL…

A: To make a spike solution containing 100 μL of the standard and 900 μL of the diluting liquid, you…

Q: If you have 155 mL solution of a 0.762 M FeCl, solution, how many grams of FeCl, are contained in…

A: Fill in blanks as shown on problem

Solutions

Solutions can be considered as homogeneous mixtures which contain two or more than two chemical substances. The chemical substance which is the greater part is defined as solvent. And the chemical substance that is dissolved in a solvent is referred to as solute. Solution chemistry plays an important role in chemistry since it supports many commercial applications of solutions.