2. You have a solution that contains 4.0g of oxalic acid dissolved in 100 mL of water. This solution is placed in a separatory funnel, and then 100 mL of diethyl ether is added to the separatory funnel and an extraction is performed. (Diethyl ether and water are immiscible solvents.) Use the following constants to calculate how much oxalic acid is in each solvent after the extraction. Solubility of oxalic acid in water = 9.5 g / 100 mL Solubility of oxalic acid in ether = 16.9 g/100 mL

2. You have a solution that contains 4.0g of oxalic acid dissolved in 100 mL of water. This solution is placed in a separatory funnel, and then 100 mL of diethyl ether is added to the separatory funnel and an extraction is performed. (Diethyl ether and water are immiscible solvents.) Use the following constants to calculate how much oxalic acid is in each solvent after the extraction. Solubility of oxalic acid in water = 9.5 g / 100 mL Solubility of oxalic acid in ether = 16.9 g/100 mL

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

When 25.0 mL of a 4.26×10-4 M manganese(II) sulfate solution is combined with 18.0 mL of a 9.60×10-4 M ammonium sulfide solution does a precipitate form? fill in the blank 1 (yes or no)? For these conditions the Reaction Quotient, Q, is equal to ?
This is the amount of solute (in grams) required to make a liter of saturated solution Solubility Molar solubility Molal solubility Normal solubility
A 1.00 liter solution contains 0.35 M nitrous acid and 0.45 M potassium nitrite. If 0.110 moles of barium hydroxide are added to this system, indicate whether the following statements are true or false. (Assume that the volume does not change upon the addition of barium hydroxide.) A. The number of moles of HNO, will decrease. - B. The number of moles of NO," will increase. vC. The equilibrium concentration of H30* will remain the same. •D. The pH will remain the same. "E. The ratio of (HNO2] / [NO,] will remain the same. please explain each than give answer
you would like to remove cadmium ions from a waste stream using precipitation. The final concentration of cadmium needs to be less than 0.001 mg/L. identify a chemical that could be used to precipitate cadmium out of solution to meet this goal. Show calculations and prove if it can be calculated.
Assume the solubility product of Mg(OH)2 is 1.3 x 10 at a certain temperature. What minimum OH concentration must be attained (for example, by adding NaOH) to decrease the Mg2+ concentration in a solution of Mg(NO3), to less than 1.2 x 10-10 M. 3/2 x 10 M (Enter your answer in scientific notation.) Next > < Prev 18 of 20 **** .*****
You look at the solubility of Ca(OH)2 in water (Ksp = 4 x 10–10). You wait until the system reaches equilibrium and then add Cr(C2H3O2)3. (Ksp = 6.7 x 10–31 for Cr(OH)3). Would affect do you think would occur to the solubility? (increase, decrease, stay the same) Show this through a calculation (Note: Two equilibria must be considered).
From the solubility data given, calculate the solubility products for the following compounds. (a) SrF₂, 7.3 × 10-² x 10 g/L: x 10 Enter your answer in scientific notation. (b) Ag3PO4, 6.7 × 10-³ g/L: Enter your answer in scientific notation.
1. Copper oxides are a product of the oxidation of copper that often form on the inside of copper pipes transporting water and serves to protect the pipes against corrosion. They are toxic. At a pH above 8, these oxides are virtually insoluble in water. As the pH of the water flowing drops below 7, the solubility of these oxides increases, and the layer begins to dissolve. Based on this knowledge, and the data collected in your lab, what implications does this have on toxic metal pollutants or other pollutants in our drinking supply when the water flowing is acidic? Would this problem become better or worse if the water flowing through the pipes was hot? 2. The chemical obtained from red cabbage that acts as a pH indicator is a pigment called anthocyanin. Based on your results, do you think anthocyanin is a useful indicator? Why or why not?
When 18.0 mL of a 2.45×10-4 M manganese(II) bromide solution is combined with 22.0 mL of a 5.02×10-4 M ammonium sulfide solution does a precipitate form? fill in the blank 1 (yes or no)For these conditions the Reaction Quotient, Q, is equal to .
Each of the insoluble salts below are put into 0.10 M hydrochloric acid solution. Do you expect their solubility to be more, less, or about the same as in a pure water solution ?
What is the molar solubility of a saturated solution of magnesium hydroxide, Mg(OH)2, in water? The Ksp of Mg(OH)2 is 1.2x10-11. 1.4x10-4 1.8×10-4 3.6x10-4 3.4x10-6
To 200 ml of a solution containing 0.002 mol of aluminium chloride and 0.001 mol of calcium chloride is slowly added solid sodium phosphate (assuming no change in volume). How many grams of sodium phosphate must be added to precipitate as much of one ion as possible, while the other ion just doesn't precipitate? What percentage of the ion that will precipitate first is left in the solution at that moment?