2. WITHOUT S HEAR MOMENT 6QUATIONS, DRAW S HEAR MOMENT DIAGRAMS, WRITING a.) 10 KN/m im R2 R, b.) 100N 120 N/m 120 N 2 m 2 m 2m R,

Q: Draw sheer diagram and bending moment diagram.

A:

Q: Atx = 120 mm, V= i N, M= i N-m Atx = 400 mm, V= i N, M= i N-m

A:

Q: 9) Draw the shear force and bending moment diagrams. A 8 kN/m 1.5 m- 1.5 m 6 kN

A:

Q: Part A Draw the shear diagram Given the beam and its corresponding free-body diagram, draw the shear…

A: Part A- Draw the shear diagram.Given the beam and its corresponding free-body diagram, draw the…

Q: Question #2: Draw complete shear and bending moment diagrams. Neglect the beam weight. 10 kips 0.5…

A:

Q: Determine the bending moment acting at each of the following locations: (a)x= 10.5 ft (i.e., at…

A:

Q: Draw the shear and moment diagram?

A:

Q: 6 AN/m Draw the normal, shear and bending moment diagrams. 30m 3.0m 3.0m 9.0m

A: In this problem, it is asking the normal, shear and bending moment diagrams for beam BD.

Q: 8KN 2KN am 3m

A: given; w=2kN/m

Q: Problem 4: Shigley 3-34 (modified) Assume that the car is in the middle of the bridge span for…

A:

Q: a.Identify all the equations that describe the shear over any portion of the beam. Solve the problem…

A:

Q: Draw the shear force diagram and bending moment diagram using differential relationship between…

A: Given; uniform distributed load for distance a from open end of the cantilever=q Then point load in…

Q: In Problems 8-51 to 8-68, beams are loaded and supported as shown in the accompanying figures. Draw…

A: Consider the free body diagram as shown below for the given beam.

Q: Draw the shear diagram for the cantilevered beam. Click on "add discontinuity" to add discontinuity…

A: Given data

Q: Q3-Draw the shear force and bending moment diagrams for the beam shown in Figure (3). 10 kip 8 kip 2…

A: Explanation: The stepwise procedure to solve this problem is shown in the following attached image:

Q: 3' 10K 20K ↓ 4' 5' 2K/ft 12'

A:

Bending Moment

In general, we can define the bending moment as the reaction induced when a certain amount of load or force is applied to an element which makes it bend.