2. Three steel cable jointly support a load of 12kN. The diameter of the middle bar is 18mm and the diameter of each outer cable is 12mm, The tension in the cable are adjusted so that each cable carrries. one third of the total load(4kN). Later it was increased by 9kN to a total of 21 kN. a. What percent of the total load is now carried by the middle cable? b. Determine the stress of the middle cable c. Determine the stress of outer cable..

2. Three steel cable jointly support a load of 12kN. The diameter of the middle bar is 18mm and the diameter of each outer cable is 12mm, The tension in the cable are adjusted so that each cable carrries. one third of the total load(4kN). Later it was increased by 9kN to a total of 21 kN. a. What percent of the total load is now carried by the middle cable? b. Determine the stress of the middle cable c. Determine the stress of outer cable..

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The load P applied to the pin-con- nected frame shown stretches cable CD 2.5 mm. 2-19. The area of the cable is 150 mm² and E = 210 000 MN/m². Determine P. Ans: 39.4 kN. P E 3 m D 3 m 2 m 2 m PROB. 2 – 19 2-20. Two wires are connected to a rigid bar
Determine the max. and min. tension in cable for the suspension bridge.
The equivalent uniform distributed load acting on the suspended cable with three hinged stiffening girder is 5 kN/m. The span of the cable is 10 mand sag of the cable is 1 m. The maximum tension acting on the cable is
The cable supports the three loads shown. Determine the magnitude of P₁ if P2=3KN and yв =0.8m. Find also the sag yo Ув 1.4 m H B 0.4 m 1.2 m 2 m Ans. P₁-6.58 KN, VD-0.644m P. -1.5 m- 1.2 m Peacock E
The water supply pipe is suspended from a cable using a series of closed and equally spaced hangers. The length of the pipe supported by the cable is 60 m. The total weight of the pipe filled with water is 6.5 kN/m. a. Determine the maximum sag at the lowest point of the cable which occurs at the mid length of the allowable tensile load in the cable is 3000 kN. b. If the sag of the cable at mid length is 3m. If the allowable tensile load in the cable is 2000 kN, how much additional load can the cable carry? c. Determine the legth of the cable when the sag of the cable at mid length is 3 m. Please provide a briefly explained solution, thank you!
*3-36. Cable ABC has a length of 5 m. Determine the positi on x and the tension developed in ABC'required for equilibrium of the 100-kg sack. Neglect the size of the pulley at B. 3.5m- 0.75 m Рrob. 3-36
4. A post-tensioned prestressed beam of span-length of 10 m has a rectangular section 300 mm wide 800 mm deep. The beam is prestressed by a parabolic cable concentric at the supports and with an eccentricity of 250 mm at the centre of span. The cross-sectional area of high-tensile wires in the cable is 500 mm². The wires are stressed by using a jack at the left end so that the initial force in the cable at the right end is 250 kN. Using the following data, calculate (a) the total loss of stress in the wires, (b) The jacking force required at the left end: Coefficient of friction for curvature effect = 0.55 Friction coefficient for wave-effect = 0.003/m Anchorage slip at the jacking end = 3 mm
Complete sol. ty
In the cable structure below, when the maximum moment of column BF Mmax =1500KN-m and P1 =2P2, calculate the maximum value of P1. = 2m E! P2 C hp 6m 3m D A 5m 5m 5m
The cable AB carries a uniformly varying load. It isconnected to a wall at A and is held in equilibrium by a1340 N horizontal force at B. Determine the loadintensity (W) at A. SHOW COMPLETE FBD
SOLVES STEP BY STEP, USE TABLE IF NECESSARY
Please answer these questions.