2. The roof truss shown in Figure is pinned at point A, and supported by a roller at point H. Determine the force in member DG and DF.Use method of sections D. 55 kN 45 kN MATHali 2.5 m 1.5 m 1.5 m MATHalino.com H. 2 m C 2 m 2 m 2 m 90 kN

Q: y 30 15 kN-m 3 kN B A 1.4 kN -1.2 m- 1.8 m 1.8 m

A:

Q: 000 2-46. Determine the x and y components of each force acting on the gusset plate of the bridge…

A:

Q: Use the method of sections to determine the forces in members AB, FG, AH, and GH. State whether the…

A: Solution Draw the diagram

Q: A 1.6-m-long cantilever beam supports a concentrated load of P = 7.2 kN. The beam is made of a…

A:

Q: 60 KN 40 kN 7m 3 m A₂ Ay -4 m- B Cy C -X

A: Find:  The member Forces

Q: The simple beam with overhang carries a uniform load, w=10kN/m and force P=20.38kN. a. determine the…

A: Answer  We know that the Maximum Compressive or Tension stress can be calculated using the Bending…

Q: STATICS-METHODS OF JOINTS 1. Determine the force in each member of the truss shown using the Method…

A: Given that:

Q: What is the level rod reading in feet at the main crosshair line shown in the figure? (enter only a…

A:

Q: Problem 4.- Determine the force in member BE of the loaded truss and whether the member is in…

A: Given:- Forces:- 6kN.5kN,4kNTo find:-Force in member BE

Q: Determine the forces in members BE and CE of the loaded truss. The forces are positive if in…

A:

Loads and Reactive Forces

Loads are the external influences that a beam experiences under its working conditions. For instance, a beam may be subjected to shear loads, twisting loads, bending moment, and axial loads during its working conditions. Engineers primarily deal with beams and trusses in the civil engineering domain. Due to the influence of loads, it is very crucial to determine the induced stresses and deformation values. These values give an insight into the critical area of the beam that needs to be worked upon to make it fail-safe.