2. The circular shaft has fixed supports at both ends, points A and D. Determine the torque that occur at the fixed supports, A and D under the effect of torques acting on B and C. Determine the maximum shearing stresses that will occur at the cross- sections for the portions AB, BC and CD. Determine the angle of twist for the portion AC. (G=4500 MPa) T₁ A d₁ -B d₂ 1₂ C d₁ D

Q: I need help solving problems 7, 8, and 9 pertaining to the print attached below.

A: 7.In question no. 7 information is not enough to answer the question. As there are many circles in…

Q: D Question 2 Express the force TBC as a vector (in terms of i, j, k). Show all calculations on your…

A: Express the force TBC as a vector (in terms of i, j, k). Show all calculations on your paper and…

Q: 3.00- 1.25-

A:

Q: 0.2 m B 0.2 m 1.3 m 0.7 m A P Circular

A:

Q: Please walk me through finding how much force the women need to pull the force

A: Given data: Weight is W Need to determine the required force to pull the weight.

Q: 76°10' 0.500 DIA 45°00'- 1.125 DIA 1.000 0.875 Find length x in the accompanying figure.

A: Given figure can be redrawn as:

Q: A chemistry graduate student is designing a pressure vessel for an experiment. The vessel will…

A:

Q: Phi = 40 degrees Theta = 35 degrees F1 = 425 Newtons Alpha = 60 degrees Beta = 45 degrees F2 = 625…

A: Given,  ϕ=40°θ=35°F1=425Nα=60°β=45°F2=625N

Q: can you help me understand this better. I am going to reproduce this drawing by using Creo. And i…

A: Here's a breakdown of the GD&T symbols used in the image:Datum symbols: A datum is a…

Q: Compute the coordinates of the centroid (,) of the area shown. Hint: Use composite with shapes in…

A: Given : The value of The value of The value of The value of The free body diagram is,

Q: FA -X B FB Alpha = 34 degrees

A:

Q: For problems 1 and 2 below, using the Parallelogram method only (no other method will be accepted)…

A:

Q: Figure FR = Submit Part B 45° Express your answer with the appropriate units. Value a. B. Y= 1 .60⁰…

A:

Q: Determine the magnitude of F so that the resultant couple moment is 11.5 kN -m , counterclockwise.…

A:

Q: Build the following part. Report the volume in mm^3. Assume all dimensions are in mm. A=52 B=19 Your…

A: Given : To find : Volume of the body

Combined Loading

Any functioning component, such as machine parts, structural members, pressure vessels, and so on, are all under the influence of more than one force. When anybody is under the influence of more than one force such as shear forces, bending moments, axial forces, torsion, and so on, then such body is said to be under combined loading. A very practical example of combined loading is the crankshaft of an internal combustion engine (IC engine). The crankshaft of the IC engine is under high rpm, which is caused due to the torsional forces. Due to the presence of piston, counterbalances, and internal imbalances, the crankshaft experiences lateral forces and due to the rise in temperature, the crankshaft undergoes thermal expansion, which pulls the crankshaft along the axial direction and lateral direction. The presence of unbalanced loads along the periphery of the crankshaft also induces a bending moment.