2. Suppose your thermometer consistently read a temperature 1.2o higher than the correct temperature throughout the experiment. How would this have affected the molar mass of the unknown you calculated (too high, too low, no affect)? Explain. 3. If the freezing point of the solution had been incorrectly read 0.3 C higher than the true freezing point, would the cal culated molar mass of the solute be too high, too low or not be affected? Explain.

2. Suppose your thermometer consistently read a temperature 1.2o higher than the correct temperature throughout the experiment. How would this have affected the molar mass of the unknown you calculated (too high, too low, no affect)? Explain. 3. If the freezing point of the solution had been incorrectly read 0.3 C higher than the true freezing point, would the cal culated molar mass of the solute be too high, too low or not be affected? Explain.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Please solve
Name Time M T W R F The freezing point of pure benzene (CH,) is 5.50°C. The freezing point of a solution containing 5.00 g of an unknown non-dissociating solute in 444 g of benzene is 5.07°C. K, of benzene = 4.90°C/m. Show complete calculations for each question below. 1. What is the freezing point depression for this solution?
a.) Calculate the freezing point and boiling point of the solution when you add 1.00 kg of ethylene glycol (C2H6O2) antifreeze to 4450 g of water in your car’s radiator. Kb = 0.512C°/m; Kf = 1.86C°/mb.) Calculate the freezing point of a solution containing 50.0 g of NaCl in 5000 mL of water. Kf for water is 1.86 C˚/m c.) Calculate the molar mass of sucrose in a solution prepared by dissolving 4.27 grams glucose in 50.0 grams water. The solution boils at 100.13 °C which is above the normal boiling point of pure water. Kb = 0.512C°/m
3. 2 g of NacI is dissolved in 500 g of water at 35°C. Determine the ff: PNacI • 2.16 cm a. Boiling point elevation b. Freezing point depression C. Vapor pressure of the solution d. Osmotic pre ssure
I don’t know how to do this question
mm.32.
Match the following. Drag the terms on the left to the appropriate blanks on the right. Reset Help 0.020 MNH4 Cl solution that is most strongly dependent upon pressure 1. 0.0050 MCO2 2. - highest boiling point 0.050 MC6H12O6 (aqueous) 3. - solution of ionic compound with highest freezing point 0.010 mAl(NO3)3 0.050 mNaCi 4. - solution with AT, 0.026° C 5. - largest van't Hoff factor
Given the following mixture of two compounds 45.00 mL of X (MW =53.00 g/mol)(density 1.186 g/mL) and 830.00 mL of Y (71.00 g/mol)(density 1.041 g/mL). The freezing point of pure Y is 71.00 degrees C. The molal freezing constant is 4.609 degrees C/m. What is the freezing point of the solution.
4-6: A solution contains 45.0 g of methanol, CH;OH, dissolved in sufficient water to give a total mass of 210.6 g. 4. Compute for the number of moles of the solute present in the given solution. 5. What is the mass (in kg) of water used to dissolve the solute from the given problem? 6. Determine the molal concentration of the said solution.
Why does heating increase the speed at which a solid dissolves??
EJ0.939 M What is the vapor pressure of a 45.0 % solution of glucose, CH,,06, at a particular temperature, 12 6' given that the vapor pressure of pure water at that temperature is 486 mm Hg? 186 m m Ha
Please answer.