2.) One kilogram of steam is contained in a piston/cylinder device at 800kPa and 200°C. (a) If it undergoes a mechanically reversible, isothermal expansion to 150 kPa, how much heat does it absorb? (b) If it undergoes a reversible, adiabatic expansion to 150 kPa, what is its final temperature and how much work is done?

2.) One kilogram of steam is contained in a piston/cylinder device at 800kPa and 200°C. (a) If it undergoes a mechanically reversible, isothermal expansion to 150 kPa, how much heat does it absorb? (b) If it undergoes a reversible, adiabatic expansion to 150 kPa, what is its final temperature and how much work is done?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

p46,#17 with illustration and explanation
Oxygen (molar mass 32 k g / k m o l ) expands reversibly in a cylinder behind a piston at a constant pressure of 3.157 bar. The volume initially is 0.0111 m3 and finally is 0.0321 m3; the initial temperature is 17 0C. Calculate the work input during the expansion with the correct unit. Assume oxygen to be a perfect gas and take the specific heat at constant pressure as = 0 . 9 1 7 k J / k g K.
Ice at -10°C and water vapor at 130°C are brought together at atmospheric pressure in a perfectly insulated container whose heat capacity can be neglected. After thermal equilibrium is reached, the liquid phase at 50°C is present. Ignoring the equilibrium vapor pressure at 50°C, find the ratio of the mass of the steam to that of the ice (L, = 3.35×10°J/kg L, = 2.26x10° J / kg C = 2000J / kg - °C cm = 2020J / kg -°C)
Carbon dioxide (molar mass 44 kg/mol) expands reversibly in a perfectly thermally insulated cylinder from 3.7 bar, 220 degrees Celsius to a volume of 0,085 m³. If the initial volume occupied was 0,02 m³, calculate the gas constant, adiabatic index,final pressure and work input. Assume nitrogen to be a perfect gas and take cv=0,63 KJ/kgK
Q3: In a steam jacket cylinder, steam expands from 5 bar to 0.12 MPa according to a law pv1.05 = constant. Assuming that initial dryness fraction is 90%, calculate the work done and heat supplied for 0.5 kg of steam during the expansion.
CO2 needs to be compressed from p1=1bar, t1=300k to p2=40bar to transport it to remote sites for sequestration. what is the minimum energy requirement per kg of CO2 for the compressor? Should the compressor operate adiabatically or isothermally for the best energy efficiency? The environment is at Tenv=300k. Use accurate thermodynamic data for CO2 in this problem.
A well-insulated 4 × 4 × 5 m³ room, initially at 10 °C, is heated by the radiator of a steam heating system. The radiator has a fixed volume of 150 L and is initially filled with superheated water vapor at 200 kPa and 200 °C. After 30 minutes, the pressure of the steam is observed to drop to 100 kPa as a result of heat transfer to the room. Assume constant specific heats for air. (a) (b) (d) Sketch a thermodynamic diagram for the process of the steam. Determine the final temperature of the steam. Based on the final state you found, make any corrections needed to your diagram in (a). neglected. the air. Write the First Law for the air and steam, and indicate which terms can be Assuming the air has a uniform temperature, find the final temperature of