2. Liquid water at 200 KPa and 115°C
Q: 3. brine solutions, 131, B3, 133 are mixed. Bl is X2 of the total mixture. Brine I is 2.5% salt, B2…
A: Initial amount of B1 = 1736 lbmInitial amount of B2 = 13.47 lbmInitial amount of B3 = 1722.53…
Q: A 1.56-lb block of iron is at 212°F. What will be its final temperature if the block gives up 2000…
A:
Q: 4. You have 1 kg of water and you want to use that to melt 0.1 kg of ice. What is the minimum…
A: Given data: The mass of water is m=1 kg. The mass of ice is m'=0.1 kg.
Q: 2. How many grams of ice at 0 degrees Celsius must be added to a 385 g pineapple juice at 35 degrees…
A:
Q: 9. A quartz sphere is 14.0 cm in diameter. What will be its change in volume if it is heated from 64…
A: Given : diameter of quart sphere, d = 14 cm = 0.14 m increase in temperature, ΔT =…
Q: 3. The following graph describes the material's behavior under stable creep conditions at T-732 °C.…
A: The graph in the image describes the material's behavior under stable creep conditions at a…
Q: 3. An automobile tire has a volume 988 in and contains air at a gauge pressure of 24.2 lb/in (psi)…
A:
Q: The homogeneous 12 cm cube in the figure bellow is balanced by a 2 kg mass on the beam scale when…
A: Given data, Side of the cube = 12 cm Balanced mass = 2 Kg Density of ethanol = 789 kg/m3 Density of…
Q: 5. The density of water at 4°C is 1,000 kg/m³. What is the water's density at 94°C? (where ß = 207 x…
A:
Q: 10) An aluminum rod 17.400 cm long at 20°C is heated to 100°C. What is its new length? Aluminum has…
A: Solution:-
Q: What mass of water will change its temperature by 3 celcius when 525 J of heat is added to it? The…
A:
Q: A gas in a sealed container has a pressure of 125.0kPa at 30.0 °C. Determine thetemperature in the…
A: We know thatPV=nRTHereP=pressureV=Volumen=number of moleR=Gas constantT=temperature
Q: lled, the acetone cools and the flask warms pination of acetone and flask reaches a u ure of 32.0°C.…
A: We know that the formula of the change in volume of the acetone when its temperature changes T1 and…
Q: When 435 g of water at 95.2°C are mixed with 435 g of another liquid at 14.8°C, the final…
A: Heat gain = Heat lost
Q: 9. One kilogram of water at 45°C Is mixed with 1.5 kg of alcohol at 20°C. What is the final…
A:
Q: 3. A thin square sheet of metal sides of 0.5 m is heated from 25°C to 100°C. If the linear…
A:
Q: What volume is occupied by 1 mole of an ideal gas at pressure of 1 atm and temperature of 0°C
A: The volume is occupied by 1.00 mol of an ideal gas at 1.00 atm and 0.00C
Q: 4. A quartz cube has sides equal to 15.0 cm. What will be its change in volume if its temperature is…
A:
Q: 1. How much heat is required to change the temperature of lead from 15°c to 65°c?
A: The specific heat capacity of lead is 0.129 J/goC. The heat required to rise the temperature from…
Q: 8. A mass m = 0.046 kg of benzene vapor at its boiling point of 80.1 °C is to be condensed by mixing…
A:
Q: 7. A mass m = 0.060 kg of benzene vapor at its boiling point of 80.1 °C is to be condensed by mixing…
A: Heat from benzene vapor is absorbed by water to condense benzene vapor. Q=mblv Q=mwCw∆T Equate both…
Q: 1. A fan connected to a grain dryer will move 12,500 cfm of air. The dryer system has a heater that…
A: The rate at which groundwater moves through a specific well or aquifer cross-section is referred to…
Q: 3. A piece of metal with a mass of 15.3 grams has a temperature of 50.0 °C. When the metal is placed…
A:
Q: 1. A spray can is used until it is empty except for the propellant gas, which has a pressure of 1344…
A: We are authorized to answer one Question at a time, since you have not mentioned which question…
2. Liquid water at 200 KPa and 115°C
Step by step
Solved in 2 steps
- 7. A container can be made from steel [B = 36 × 10-“ (C®)-'] or lead IB = 87 × 10-° (C°)"]. A liquid is poured into the container, filling it to the brim. The liquid is either water [ß = 207 × 10-6 (C°) -'] or ethyl al- cohol [B = 1120 × 10-6 (C°)-']. When the full container is heated, some liquid spills out. To keep the overflow to a minimum, from what material should the container be made and what should the liquid be? (a) Lead, water (b) Steel, water (c) Lead, ethyl alcohol (d) Steel, ethyl alcohol16. Microscopic pockets of water continue to exist at (-18°C) and even much lower temperaturesul: A. True. B. False.8. A 1.50 X 10² g piece of brass (specific heat capacity 3.80 × 10² J/(kg•°C)) is submerged in 400.0 mL of water at 27.7 °C. What is the original temperature of the brass if the mixture has a temperature of 28.0 °C? K/U TAI