2. In Figure, the battery voltage is V 65 velts, and the values of theresistances, in ohms, are 38, 17, and 27, as shown. Find:Total resistance seen by the battery,(b) Current measured by the ammeters shown in the figure,V-65 V17Q27Q

Answered: Image /qna-images/answer/d46de289-d184-4766-829f-8ff7cda61a30.jpg

2. In Figure, the battery voltage is V 65 volts, and the values of the resistances, in ohms, are 38, 17, and 27, as shown. Find (a) Total resistance seen by the battery, (b) Current measured by the ammeters shown in the figure,

2. In Figure, the battery voltage is V 65 volts, and the values of the resistances, in ohms, are 38, 17, and 27, as shown. Find (a) Total resistance seen by the battery, (b) Current measured by the ammeters shown in the figure,

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.8MCQ: An ac resistance is higher than a dc resistance. True False

See similar textbooks

Related questions

Q: Three resistors are connected in series across a 12-volt battery course. It has found to be that the…

A: Given, three resistors are connected in series across a 12-volt battery, Let, R1, R2 and R3 be…

Q: Estimate voltage E2 when E1=90sin2400t V, R1=R2=20 ohms, L1= L2=3mH and M=0.15mH

A: RMS value of E1, E1RMS=902=63.63 Volt, Frequency ω=2400 rad/s. Inductive reactances:…

Q: For the circuit below, determine the resistor voltage. The source is 6 volts, the Zener potential is…

Q: If we use 5000 µF, we can get a very low ripple voltage. But this is so bad and this a disadvantage,…

A: According to the given question we are using a 5000 micro farads capacitance , then there is a…

Q: In the figure the current in resistance 6 is ig=1.47 A and the resistances are R₁ = R₂=R3-2.470. R4…

A: The required emf can be calculated by using the total resistance of the circuit and the total…

Q: The question is how to produce hv about 150 kv. A) What if we have a dc battery with a voltage of 9…

Q: Two electrical elements are connected in series. What can you say about the currents through the…

A: Two electrical elements connected in series will connect between two similar nodes , Hence current…

Q: 1.2 An electrical load consists of three resistances connected in series-parallel. The series…

A: The value of the series resistor, The value of parallel resistors, The voltage provided by a…

Q: If a potential difference of 2.15 volts is applied to an unknown resistance and the measured current…

A: Given: Potential difference =2.15 V is applied across unknown resistance and current is also unknown…

Q: (b) A student sets up an electric circuit like the one shown in Figure Q1(b). i) Describe how a…

Q: Question 4) How would the I-V behaviour be of the following cases. Start by explaining what they…

A: When a metal and a semiconductor are joined together, a junction is formed. Depending on the work…

Q: b-Two aluminum and copper wire resistors consume 0.5 W when connected in parallel to 2 V DC supply.…

Q: 3. A resistor made of silver and another made of nickel, having temperature coefficients of…

Q: The peak value of sine wave is 100 V. Its rms value is calculated as O a. 63.7V O b. 70.7V O c. 100V…

A: To solve the above problem, one should know about different characteristics of sine wave:…

Q: ) Draw/ Illustrate the grouping of cells in series, parallel and combination of series-

Q: In the figure the current in resistance 6 is i6 = 1.33 A and the resistances are R₁ = R₂ = R3 = 1.56…

A: According to the question, for the given circuitWe need to find emf of the battery.

Q: Part II: The potential difference across different elements of a circuit resistance in series 1.…

A: Part 1 and 3 are experimental based hence we can not solved. We are solving for part 2 i) relation…

Q: A lead wire with a radius of 0.5 mm and a length of 20 cm is connected to a potential difference of…

A: Given diagram,

Q: Example (1) For the series-parallel arrangement shown in Figure below, find: a) The supply current.…

Q: A resistor consists of 5 colour bands as shown in Figure la. Find the value of the resistance. [2]…

A: Resistance Color coding is the special method to label the resistor with its value. The resistor is…

Q: How much is the eurrent, I, at each of the following points? a. Point A b. Point B c. Point C d.…

A: Since there is no other way...The current will flow through the given loop According to law of…

Q: Part1: Resistors connected in series to each other The circuit shown below was generated on MapleSIM…

Q: Three resistors A, B and Care connected in series to a 126-volt dc source. If the resistance at A is…

A: The solution can be achieved as follows.

Q: What is the p.d. across a resistance dissipating 50 W of power while the strength of current is 5 A?…

A: Given values are - P=50WI=5A

Q: A voltmeter indicates that the value of a voltage crossing a load resistance is 5.00 V, this…

A: Volatge across the load resistance is 5.00V The Voltage can be written as ,

Q: three type of electric device A, B, and C are connected in series across a 115 volt AC source, and…

A: We will write three voltages in phasor form. We will use fact that source voltage is the phasor sum…

Q: In the figure the current in resistance 6 is ig = 1.38A and the resistances are R1 = R2 = R3 = 2.01…

A: In this question we will find battery emf E ...

Q: b. A piece of pencil lead is connected in series with an ammeter and a power supply. The power…

A: Dear student as per our guidelines we are supposed to solve only one question.kindly repost other…

Q: What is the value of VR

Q: What is the greatest voltage that can be applied across a -W, 2.7-MN resistor without causing it to…

A: Given values are - P=18WattResistanceR=2.7Mega Ohm=2.7×106Ohm

Q: a) size and b) direction (up or down) of i, and the c) size and d) direction of iz?

A: Power Absorbed and Power Delivered In a circuit, the total power delivered is equal to the total…

Q: 50 mH inductance is connected in series with 20 ohm resistor. If the voltage is 220 volts. What…

Q: In the figure the current in resistance 6 is ig = 1.40 A and the resistances are R1 = R2 = R3 = 1.56…

Q: If PMMC meter have internal resistance of 1002 and full-scale range of 1mA. Assume we wish to…

A: Here, Rm=10 Ohm Full Scale range of , Im=1mAIncreased range of, I=2Aso, We have to connect Rsh for…

Q: Question: If simplified, the next figure shall be: - (a) A and the series of three resistors. -…

A: Consider the given circuit,

Q: three type of electric device A, B, and C are connected in series across a 115 volt AC source, and…

A: In this question we need to find a voltage of device A , B , C

Question

2. In Figure, the battery voltage is V 65 velts, and the values of the
resistances, in ohms, are 38, 17, and 27, as shown. Find:
Total resistance seen by the battery,
(b) Current measured by the ammeters shown in the figure,
V-65 V
17Q
27Q

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An ammeter has been designed by indirect method with current ranges 1A, and 5A, if PMMC meter have internal resistance of 50 (2 and half scale current of 0.5 mA. Ra and Rb will be --- ohm Ra= 0.05005 , Rb=0.01001 Ra = 0.04004 , Rb = 0.01001 Ra= 0.05005 Rb= 0.04004
The conductance of a 9230 resistance is a) 1.08 * 10-3 mho b) 1.08 * 10-4 mho c) 1.02 * 10-3 mho d) 1.02 * 104 mho
Coverage: Series and Parallel Combinations, and Ohm's Law Question: If simplified, the next figure shall be: - (a) A and the series of three resistors. - (b) A and the parallel of three resistors
Calculate the value of RB in ohms. at VE=3V, RE=252 ohm, IB=20uA, RC=2637ohm and VCE=9V
Using multism
The color code of the following is Red-Black-Red-Gold. Solve for a) Resistance nominal value b) Measured Current c) Measured voltage. The multi-tester readings are shown below.
Answer the questions in the attached photo, Thannk you
If PMMC meter have internal resistance of 1002 and full-scale range of 1mA. Assume we wish to increase the meter range to 2A. the value of shunt resistor will be: OR_sh=0.00500 OR_sh= 0.00010 OR_sh=0.11111 0
If we use 5000 µF, we can get a very low ripple voltage. But this is so bad and this a disadvantage, why?
The color code of the following is Orange-Brown-Red-Gold. Solve for a) Resistance nominal value b) Measured Current c) Measured voltage. The multi-tester readings are shown below.
Determine the a) Resistance nominal value b) Measured Current c) Measured voltage. The multi-tester readings are shown below. Note: the color code of the following is Yellow-Green-Red-Gold.
A Certain winding made up of copper has a resistance of 100 2 at room temperature. If resistance temperature coefficient of copper at 0 Co is 0.00428 1/C°. Calculate the winding resistance if temperature is increased to 50 C°. Assume room temperature as 25 C°.