Answered: 2. In an air conditioning system, if…

2. In an air conditioning system, if the recirculated air is three times the outside air and the mass of supply air is zokg/s, what is the mass of the outside air? Ans. 5 kg/s

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Liquid ammonia at a temperature of 26 degree celcius is available at the expansion valve . The…

Q: Water at a temperature of 400oF has a quality of 0.7. The internal energy of the water is ________…

A: given temperature ofwater , T=400oF=204.444oCquality, x=0.7

Q: Exactly 10 kg of steam entered a heat exchanger at 100 bar and 560o C. At the exit the Steam was at…

A: Given data,

Q: When Refrigerant Liquid evaporates, it Question 1 options: Releases heat Increases its…

Q: has a voluime of 33.9L at -11.68°C and 178.94 kPag. If the pressure and temperature are increased to…

Q: 2) A heat pump with the amount of heat of liquid refrigerant (mix) when it will enter the expansion…

A: Answer: The coefficient of performance of the heat pump is 0.575.

Q: Two refrigerators A and B operate in series. Both refrigerators absorb energy at same rate of 1.5…

Q: Lets see how the conditions of AIR change from HEATING: Starting Conditions: DB 70F and 40% RH Final…

A: For Heating:

Q: What is the mass of air in a 4mx5mx3m room that is at 300K and 101 kPa? A. 70.4 kg B. 95.3 kg C. 145…

Q: Find the heat that must be removed to a ton of apples from 80 to 32 deg F. Neglect respiration load…

A: The initial temperature of the apple (Ti)=80oF The final temperature of the apple (Tf)=32oF The mass…

Q: Refrigerant 134a inside an insulated piston-cylinder assembly initially occupies 0.017 m at 0.6 MPa,…

Q: A mass of water of 1 kg enters a tank, the mass leaving the tank is 500 gm, then the change of mass…

Q: A liquid enters a pump and saturates at 10 psia, and leaves at a pressure of 500 psia. If the…

A: State 1: P1= 10 psia and saturated liquid State 2: P2= 500 psia Isentropic efficiency of the pump,…

Q: differentiate between Open Feedwater Heaters and Closed Feedwater Heater with given 1 application on…

Q: what power in kw is required to drive it?

A: Given,Initial pressure = P1 = Atmoshpheric pressure = 101.325 kPaFinal pressure = P2 = 652.75…

Q: A closed system receives 60 KỊ heat but its internal energy decreases by 30 KJ. Then the work done…

A: This problem is related to the basics thermodynamics. First law of thermodynamics

Q: 3) If the measurement parameters of a refrigeration machine are known, the amount of heat for liquid…

Q: The figure below provides steady-state operating data for an ideal vapor-compression refrigeration…

Q: What is the Kelvin equivalent of 70 0F.

A: Given data: The temperature is TF = 70 oF.

Q: 1. The design conditio sign condition. gn condition... ible heat... nt heat..

Q: 1. Heat added to a 0.51m³ of air at constant pressure which results to a temperature increase of…

A: Note: kindly post different questions seperately, we experts can solve one question at a time,…

Q: In a heat engine as temperature of heat source increases, the Carnot efficiency will O a. Decrease O…

A: Let T1 =Heat source temperature T2 =Sink temperature As we know that efficiency of Carnot cycle is…

Q: a rigid 3ft ^3 vessel contains R-134 a originally at -20 F and 27.7 percent quality. The refrigerant…

A: Given Data Initial temperature is: T1=-20°F Final temperature is : T2=100°F Dryness fraction is :…

Q: have decided now that quarantine is about over to take a trip to Hawaii. You decide to rent a small…

A: Given length and width of the windows l×b=9×14number of windows…

Q: A 3 m3 air tank has an initial pressure of 120 kpa and 35oC. The heat is added until its pressure…

Q: aturated R-410A at a pressure of 95 psig will change at a temperature of A. 295 F B. 29 F C. 95 F D.…

A: The refrigerant is R-410A.The pressure is

Q: What is the net work done on the gas as it goes from point C to D and then to E on the Pressure vs…

Q: 1 MT/h CH4 (liq) is heated to 44.85 deg C from 31.85 deg C, 400 kPa. What is the duty of the heater…

Q: If the work done during adiabatic process is 5 kl, then its change in internal energy is O A. 256 kJ…

A: We have to determine change in internal energy

Q: O O O Question No. 15 A 1000 W heater is used for 1 hr every day for 30 days. Find the cost of…

Q: A piston-cylinder system contains an ideal gas. The initial conditions are T₁, P, and V. The system…

Q: A gas compressor draws in 600 m³/min at 27°C and 120 KPa. What would be the mass flow rate of gas if…

A: Given data: The volume is, v=600 m3/min. The pressure is, p=120 kPa. The gas constant is, R=300…

Q: 360 kJ of heat is transferred from a hot reservoir of 600 K to a cold reservoir of 250 K. If the…

Q: ou want to make sure your incubator is operating at the correct temperature of 37.0C; so you place a…

Q: How much heat must be removed to cool 50 m³/min of air at 29°C & 21°C wb to 16°C db & 14℃ wb, How…

Q: Heat added to a 0.51m^3 of air of air at constant pressure which results to a temperature increase…

Q: Find the density for air at 230 kPa and 500 K. A. 0.624 kg/m3 B. 1.60 kg/m3 C. 2.45 kg/m3 D. 12.8…

A: Given, Air pressure = 230KPa Air temperature = 500K to determine: density

Q: Referring to the reversible heat pump cycle shown in the figure, p₁ = 14.7 lb/in², P4 = 57.4 lb/in²,…

Question

2. In an air conditioning system, if the
recirculated
air is three times the outside
air and the mass of supply air is zokg/s,
what is the mass of the outside air?
Ans. 5kg/s

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

None
How much energy (in Joules) is required to fully melt 20g of ice taken from the freezer at - 5 degree C (negative 5 C), put on a stove and gently heated until fully molten?
A conference hall is to be i at 24 C dry bulb and 60 %RH. The estimated cooling loads are 75 tons and 25 tons sensible loads and latent loads, respectively. If cooled air from Air Handling Unit (AHU) is supplied to the hall at 15 C, determine the following below & plot the process on the Psychrometric chart. a) room sensible heat factor (RSHF) b) Bypass Factor (BPF) of the cooling coil c) the cubic per minute (CFM) needed to maintain the hall at its comfortable state at 24 C dry bulb and 60 %RH?
7
Use 4 decimal places
How much heat in Btu must be transferred to 42lb of air to increase the temperature by 2500F at constant pressure?a. 2517.7057Btu b. 2215.5810Btu c. 2397.8149Btu d. 2110.0771Btu
The thermodynamic work done by the system on the surrounding is considered as ? Choose the correct option a. positive b. negative c. neutral d. none of the above
Need ASAP
40 - A 1.7 m³ constant volume container initially contains air at a pressure of 98 kPa and a temperature of 21ºC. From a tank with a pressure of 610 kPa, air is provided to flow into the container through a valve. The valve is closed when the vessel pressure is equal to the tank pressure. If the temperature inside the container is 85°C, which of the following is the mass of the air entering the container? a) 11.5kg B) 9.2kg NS) 10.2kg D) 11.1 kg TO) 8.1 kg
pr and temperature decrease while the volume increase Which of the following does not help in collecting results in the mechanical heat pump? Select one: O a. Pressure gage O b. Flowmeter O c. Wattmeter O d. Receiver
A fan moves air at a CFM of 867. It's motor has a 16:1 ratio. How many BTU/hr are given off by the fan? Please explain.
1. Outside air of an air conditioning system is 25% of recirculated air. Determine the mass of outside air if mass of supply air is 15kg/s?