2. If Start Push Button 1(PB1) is pressed the cylinder 1 will extend, then Roller Limit Switch (RLS1) is activated when cylinder 1 is at fully extend position. the piston must press the work pieces together for 20 seconds and then return to its initial position after 20 seconds. (Refer to fig.1). Roller Limit Switch (RLS1) Figure 1 Draw the pneumatic and electrical circuit diagram to solve the above problem. Label all the port designations.

2. If Start Push Button 1(PB1) is pressed the cylinder 1 will extend, then Roller Limit Switch (RLS1) is activated when cylinder 1 is at fully extend position. the piston must press the work pieces together for 20 seconds and then return to its initial position after 20 seconds. (Refer to fig.1). Roller Limit Switch (RLS1) Figure 1 Draw the pneumatic and electrical circuit diagram to solve the above problem. Label all the port designations.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Explain about P Control of the Heat Exchanger.
I need the answer as soon as possible
Q25) please correct answer fast need
Write by computer
Q3 A – The benefit for the following: Stroboscope, Tachometer, Prime mover, Torqometer. B – Discuss the difference between critical speed and critical resistance of D.C generator
None
(a) Figure 1 shows the image of a water heater in which it has two types of controllers, namely the Pump Control and the Temperature Control. Briefly describe the operation of each controller. Cont OFF OF Figure 1
Which of the following in a ceiling fan is having the lowest resistance? a. starting winding b. running winding c. regulator d. capacitor
In the drilling process shown in Figure 1, there are three cylinders in which cylinders A and B are used to clamp the work piece and Drill cylinder is used to lower and raise the drill. The sequence of operation are as follows: 1. Activate the lever of the 4/2 DCV to start the process 2. Cylinder A and Cylinder B clamps the workpiece at the same time 3. Activate the second DCV (4/2 DCV with spring return) to drill cylinder lowers the drill and raises afterwards (use the throttle valve and check valve to control the speed of the drill low). drill up is normal speed. 4. Once the drill is raised completely, operate the lever to retract cylinder A and cylinder B. Note: provide the following clearly 1. List of the components required 2. Hydraulic circuit with description to each component 3. state diagram should present the sequence of operation sensors Drill-high Drill Drill-Low Part / Material Cylinder A Cylinder B B+ sensors Figure 1: Drilling Process a) Design the Hydraulic Circuit with…
If the voltage across a DC motor is -105 V and is fed from a fully controlled rectifier supplied from a single-phase supply of 235 V, the mode of working of the machine is called
ENGINEERING UTILITIES (UPVOTE WILL BE GIVEN. PLEASE WRITE THE COMPLETE SOLUTIONS LEGIBLY. NO LONG EXPLANATION NEEDED. ANSWER IN 3 DECIMAL PLACES. BOX THE FINAL ANSWER.)
When the switch is in Position 1, calculate how long will it take the capacitor to fully charge. E. Also, Calculate how long will it take the capacitor to fully discharge when the switch is moved to Position 3. With the battery connected, move the switch to Position 1. After the time determined in Procedure 12, move the switch to Position 3. Describe what happened below. Ensure you include the terms “charge” and “discharge” in your answer.