Answered: 2. Frame-El is Constant 20 kN- 3.00m…

Engineering

Civil Engineering

2. Frame-El is Constant 20 kN- 3.00m 3.00m O EI 2.00m 10 KN D ΕΙ 2.00m ET 5 kN/m ΕΙ 4.00m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A university is considering two alternative types of bleachers for a new gymnasium. One of the two…

Q: Analyze the structure shown in the accompanying figure and draw the shear and bending moment…

A: To determine:-Support reactions-BMD and SFD

Q: Determine the gage pressure are point (1) in the manometer above. "Hg" is 20 degree C mercury. h₁ is…

A: Manometer fluid Hg at 20 °C The specific gravity, S of Hg at 20 °C is 13.546 h1 = 1.9 m h2 = 0.4 m…

Q: The table below displays the data obtained from a one-hour in-out car parking survey of 100 bays.…

Q: Equation

Q: A four-meter intermediate floor beam is made of ASTM A992 steel (Fy = 350 MPa; F = 450 MPa) rolled…

A: Answer (a) Local stability of beam Flexure sections are classified as compact when limiting width…

Q: Group the provided 8 approaches into four phases. There are total of four possible phase groupings.…

A: A phase is a green interval plus the change and clearance intervals that follow it. So, during the…

Q: 1-42. Determine the the truss. A horizontal Each pin has a diamet shear.

Q: 5. The mass of the homogeneous pulley is m, and the mass of the blocks are m₁ and m₂, m₁>m₂. The…

A: Answer Let us draw free body diagram of each object as shown below. Since the pulley is fixed we…

Q: The table below displays the data obtained from a one-hour in-out car parking survey of 50 bays. The…

A: Given:- The data obtained from a one-hour in-out car parking survey is given The total number of…

Q: 4. Sand cone equipment is used to perform a field density test on a compacted earth fill. Soil…

A: Given, Wfield = 20.60 lb Wd,field = 17.92 lb ρsand = 15.74 kN/m3

Q: QUESTION 12 60 10 15-min Volumes 40 Lane Configurations Consider the left turn movement from main…

A: Potential Capacity: The potential capacity is the capacity of a roadway or a movement on a roadway…

Q: Calculate travel time it takes a dump truck hauling and returning to a dump site 3 miles away with a…

A: Answer We know that the cycle time for a haul unit is a combination of fixed time and Variable time.…

Q: What is the brake reaction distance (ft) when the design speed is 55 mph, assuming the AASHTO…

A: Given data : Speed V = 55 mph (miles per hour) AASTHO recommends perception reaction time = 2.5…

Q: The average bay turnover is approximately ……………….. .

Q: Speed (mph) A car starts from rest an of 60 mph in 20 seconds during this period is con 20 minutes,…

A: The given figure can be divided into three parts as shown below. Time is given in seconds so speed…

Q: The table below shows the number of vehicles observed on a corridor over each 15-minutes during the…

A: Given:Required:Peak hour factor

Q: A given movement at signalized intersection receives 28-seconds green time, 3.5 seconds of yellow…

Q: How many doors will be needed to the entrance of the transit center if the hourly passenger volume…

Q: A three-zone city has the following characteristics: Zone 1 Zone 2 Zone 3 Initial travel time…

Q: A +2% grade intersects with a -1% grade at station (535+24.25) at an elevation of 300 ft. If the…

Q: 1. Renatta Gass is out with her friends. Misfortune occurs and Renatta and her friends find…

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: Q3- For the traffic signal data below; 1- Fill the table with Data. 2 - calculate optimum cycle…

A: Phases Yellow Time (sec) All Red time (sec) Lost time (s) Geff (sec) Green time (sec) Red time (sec)…

Q: How much time (in seconds) does a person traveling on a grade of 4% at a speed of 69 mph have to hit…

A: Grade = 4%(0.04) , Initial Speed , Vi = 69mph = 69 x 1.467 = 101.22 ft/sec Distance up to the…

Q: Estimate the maximum number of cars in a single lane of traffic that would pass a check-point in one…

A: Average speed of car=50mph Spacing of vehicle is 1 car length per 10mph

Q: Using Enumeration Method - list all paths and total duration. Activity Predecessor Normal time…

Q: Question (1) Traffic Volume on a four lane freeway (two lanes in each direction) were counted…

A: a) The peak hour factor for each direction and each lane. Finding peak hour factor for lane 1 From…

Q: How many doors will be needed to the entrance of the transit center if the hourly passenger volume…

Q: What is the intersection sight distance (m) needed at a stop controlled intersection for a passenger…

Q: The spot speed data on the corridor was collected as shown in the Table below. Spot speed (mph)…

A: Spot speed of vehicle 1, Spot speed of vehicle 2, Spot speed of vehicle 3, Spot speed of vehicle 4,…

Q: For data in table below; Find Pace. speed group (mph) 10-15 15-20 20-25 25-30 30-35 35-40 40-45…

A: Given:- The frequency for different speed group are given To determine:- The value of Pace

Q: - 1 attachment 1. Situation: You are to determine the duration of the yellow light at a highway…

Q: Moment Area Method 1. Estimate the deflection at point C and the rotation at point B. EI is…

A: Given data: k is kilo pounds. E=4000 ksi I= 2000 in4.

Q: What is the intersection sight distance (m) needed at a stop controlled intersection for a passenger…

Q: During one hour, 1800 pedestrians passed by the observation point on the pedestrian walkway. The…

Q: The total lost time of a signal is 13 seconds. If the sum of the critical flow ratios, Yc, is 0.834,…

Concept explainers

Braced cuts

The braced cut is a method of providing lateral support to the soil in foundation trenches, to prevent the trenches from deformation by the caving in of soil and resisting it from moving laterally. During shallow excavation in firm soil, generally, slopes are provided to resist the caving in of soil. During shallow excavation in soft soil and deep excavation, the chances of caving in of soil increase. Hence, it becomes necessary to make a provision to resist the deformation of trenches due to caving in of soil. The braced cut is the method used for such conditions. The excavation using braced cuts is a bit uneconomical as compared to the traditional open-cut excavation method but provides better safety than the cut excavation method.

Question

*USE FORCE METHOD OF ANALYSIS

*PLEASE WRITE THE SOLUTION

*THE ANSWERS MUST BE IN 4TH DECIMAL PLACE

Need in 30mins at most 1hr....

2. Frame - El is Constant
20 kN
3.00m
3.00m
O
B
EI
2.00m
10 KN
E
ΕΙ
2.00m
E
5 kN/m
ΕΙ
4.00m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

2. [-/8 Points] For a peak hour volume of 840 vehicles, within which the peak 15-minute volume is 244 vehicles, the PHF is: 0.86 0.29 3.44 O 1.00 DETAILS 1.13 MY NOTES ASK YOUR TEACHER
I neeeed a clear answer very fast in 15 min| dybala
How would the following conditions affect the minimum stopping sight distance requirement? i. A drunk driver ii. A slippery road surface
Convert 55 mph to ft/sec, and then, to meters/sec. Show all work below.
a) In on-site time study of mechanically loaded, stationary-container system (SCS), the time it takes to empty all locations in a collection route is 240 minutes. The average driving time between containers location is 0.92 hours. If there are 8 containers, calculate: i. Time to pick up and load,p ii. The average between collection-point driving time per collection point,d₁
Calculate the average flow rate when transporting a liquid at 10 [m3 / h] using a 3in schedule number 40 standard steel pipe. If the specific gravity of the liquid is 0.9, what is the mass-based flow rate?
Table 1 Speed and Delay Information. Street Name: 29 North Weather: Clear Cross Streets Ivy Road Massie Road Arlington Blvd. Wise Street Barracks Road Angus Road Hydraulic Road Seminole Court Greenbrier Drive Premier Court Fashion Square I Fashion Square II Rio Road Totals Distance (ft) Date: July 7, 1994 Non-peak Time: 2:00 3:00 p.m. Ideal Travel Segment Stop Time Reason Speed Travel Segment Net for Limi Time Delay Speed (mi/h) (sec) Stoppage (mi/h Speed Time (sec) (sec) (sec) (mi/h) 0 0.0 1584 42.6 1320 27.7 792 19.7 27.4 1320 32.1 28.0 2244 49.8 30.7 1584 24.4 44.3 1584 42.6 25.4 1848 41.5 30.4 1320 37.4 24.1 1584 23.6 45.8 1056 19.7 36.5 1056 20.2 35.6 17292 381.3 30.9 119.5 0.0 20.1 0.0 8.9 15.4 Signal 9.2 0.0 19.5 15.6 11.8 4.9 0.0 14.1 Signal 45 25.4 32.5 How calculate ? Help me please Signal Signal Signal Signal Signal Signal Signal 40 40 40 40 40 45 45 45 45 45 45 0.0 27.0 22.5 13.5 22.5 38.3 24.0 24.0 28.0 20.0 24.0 16.0 16.0 275.8 0.0 15.6 5.2 6.2 9.6 11.5 0.4 18.6 13.5 17.4…
Question- Topic: Traffic Studies on Flow, Speed, Travel Time, Volume and Capacity The lost time due to starting delay on a traffic signal approach is noted to be 3 sec, the actual time is 20sec and the amber time is 3sec. How much is the effective green time? green
and report the A driver with 20/20 vision can read a given sign at a distance of 100 ft from the sign. At what distance would another driver read the same sign with 20/30 vision ● 20/40 vision 20/X vision (Give your answer with respect to X)
If you can help me with part b id greatly appreciate it, answer is not 10.77,10.72, 12.08, or 0.05. Thanks, will rate if answered within next couple hours.
Through the Walla Walla Road to the entrance of the E-1 parking lot at the University of Washington, vehicles begin to arrive from 7:40 A.M. at a uniform deterministic rate of 480 vph until 8:20 A.M. and from then on at 120 vph. It takes 10 seconds for a vehicle to go through the paying process at the gate. If the parking lot is open at 8:00 A.M., determine (a) when the queue will dissipate, (b) the total delay, (c) the average delay, (d) the maximum queue length (in vehicles), and (e) the longest vehicle delay under FIFO. Show your results graphically. [Hint: D/D/1 analysis]