2. Find the gain of the circuit and the lower and upper cutoff. frequencies. (Rs=1 kN, R¡=40 kN, R;=10 kN, R=6 kM, RE= 7 kQ, R1=2.2 kN, Cs=10 µF, C=1 µF, Cɛ=20 µF, Cbe=20 pF, Cbe=22 pF, Vr=26mV, ß=100, ro=infinite Vcc Re Ce oVo C, Vs

Q: QUESTION 1 Assume Vcc = 15 V, ß =150, V3e = 0.7 V, RE = 1 k2, Rc = 4.7 kQ, R1 = 47 k2, R2 = 10 k2,…

A:

Q: polar forms of Vab, Vbc and Vca rent Ina B Al b C I1 = 100 amp. I2 = 100 amp. I3 = = 100 amp. Vna =…

A:

Q: Find the following: 1. Total Impedance and Total Current in Polar Form 2. The total active power of…

A:

Q: For the circuit shown in the following figure. The output voltage is equal to--. 5 kn 5 kn -1 Vo 5…

A:

Q: Determine S' = O a. O b. S' ~ 0 0 c. O d. O e. alc OV BE when ß-100, VBE(on)=0.7V and VĎ(on)=0.7V.…

A:

Q: When VGSQ=7V, C1=96nF C2=44nF What is the low cut-off frequency of the system? Note : rd will be…

A: It is given that:  VGSQ=7V,C1=96nF,C2=44nF

Q: 9. Using hybrid model, find the Zo of the whole circuit if Vo = -200. 20 V hfe = 140 hie = 0.86kohms…

A: Hybrid parameters hib=input impedance with output short circuit hrb=Reverse voltage ratio input open…

Q: . Determine R1, Vcc, and ΔV. Vce = 5.334V, re´ = 12.34Ω, β = 98, Re = 3.3k.

A: Dc model will be

Q: Assuming even parity, find the parity bit for each of the following data units. a. 1001010 b.…

A: (a) Write the given sequence. 1001010 Since the number of 1’s in the given sequence is 3, that is…

Q: C; C2 C3 Vo Select one: O A. 48.07 O B. 108.15 OC. 36.05 O D. 24.03 E. 66.33

A: From the given circuit diagram we can conclude that there are three capacitors  . C2 and C3…

Q: Using the Re model, find the input and output impedance of such circuit.

A: The given circuit is common emitter type amplifier. Here used transistor is PNP transistor. To find…

Q: Given Vcc=100V, R₁-2002, ß-100, VBB-5V, flip the switch to close, 3. and Ic=0.4A, 1) Determine IB.…

A: Given that  Vcc =100 v RL = 200 ohms Beta = 100 VBB = 5 v Ic = 0.4 A

Q: If whole number ratio in Lissajous pattern is Nx:Ny=2:3 and fx=1kHz, then fy= 666.667 Hz O 1.5 kHz…

A:

Q: For the given circuit and input waveform determine the output waveform. a. b. C. V₁ 15 20 -10 d. -5…

A: As per Bartleby guidelines we are supposed to answer only one question at a time, so please post…

Q: Use RL = 330 Q, and connect another 22 µF capacitor in addition to C1 in paralle with RL. Copy the…

A: C1=22μFRL=1.2kohmVs=9sin2π50tV

Q: R I k.r loo mH Vin a5 v

A: The inductance of the inductor does not depend on the supply frequency but the reactance of the…

Q: Consider the following circuit. The frequency of oscillation is:

A: The given circuit is a Colpitts oscillator and the frequency of oscillation is based on the feedback…

Q: For the opamp circuit shown below figure, calculate the followings by assuming Ap=0o, Please mark…

A:

Q: Q1 (a) Based on electrical DC circuit as depicted in Figure Q1(a), (i) Determine the mesh currents…

A:

Q: Calculate the output impedance for the circuit shown in figure. Assume V A = 00. Calculate the…

A:

Q: om above diagram: a) Find the unknown currents marked in figure (a) b) Determine the value of EMF in…

A:

Q: 29) 555-MMV with R=10 Khom, C=0.1 microF has T= ?: 1.098 us 1.098 ms 0.1098 ms 30) opamp-AMV with…

A: (i)555-MMV with R=10KΩ;  C=0.1μF; T=???? (ii) op amp -AMV with time constant=0.1ms; β=0.6; frequency…

Q: Consider the circuit given below a) Identify the circuit with details b) Find the Q-point O Find…

A:

Q: 110v R₁ 105 R4 152 R3 15-2 R2 103 RS wwww 154 RC 15 Ra Ra wwww 205 R8 wwwwww 25-4 Rio 201

A:

Q: A resistor of resistance R=1000 Q is maintained at 17 °C and it shunted by 100 ul inductor.…

A:

Q: What is the lower cutoff frequency due to C,,C2 and C3 for circuit in figure 1? Assume re' = 4.5 ohm…

A: The lower cutoff frequency can be obtained by considering the RC network.

Q: Find the equivalent impedance for the circuit below: Given: L1-L2-1H, R₁-20, R₂-40, C-0.01F, RC-50,…

A: Given, The given circuit diagram,

Q: 4. R=100.051 MQ + 20.25 KQ + 30 Q is equal to * O 120.106 MO O 100.071MQ O 100.710MO O No one above

A: 4. From the picture it has only shown properly so I am solving it below: R=100.051 MΩ+20.25 KΩ+30 Ω

Q: Required information A series audio circuit is shown in the given figure, where ZL = 36 and R=130 2.…

A: here we have to find the impedance of the circuit and what is the new impedance when frequency is…

Q: A series RL circuit with R=10 N and if I_=5 A and V.-100 volt, with f=60 Hz then L will be Select…

A: Given: A series RL circuit with, R=10 ΩIs=5 AVs=100 Vf=60 Hz

Q: 12-2 (a) Determine the ms nolse vollage produced by a 120-kS2 resistance in an 80-KHz bandwidih al…

A: The solution is given below

Q: Assume the input frequency (fin) is 4.16 KHz. The output frequency (fou) will be a. 16 Hz b. 1 kHz…

A: We need to find out the frequency of output of counter 2.

Q: 0.1la ka Vo vi 5V うV -lov

A:

Q: Determine the impedance of the circuit in Figure 3 at the given frequency. 10 kHz Rw 20 (2 ++ 4.7 ΚΩ…

A: laplace  transfer of capacitor, C→1cs laplace  transfer of  inductor, L→Ls So that Rw and L are in a…

Q: Practice on the following circuits: Sketch the output waveform. Show your complete analysis. 1. ERSI

A: Since you have posted the multiple questions so we are supposed to answer the 1st one.

Q: R Vin L Vout +

A:

Q: RT .. R2 R3 V1 V2 R4 V3 Determine the output peak voltage, Vo 1310868 ohms, R2-8684ohms,R3=8283…

A: A summing amplifier is an operational amplifier that adds the received input voltages and gives a…

Q: 2 for the resonate at all frequencies. www R2 4 mB LOMF7 * below which will make the cir

A:

Q: alculate the output impedance for the circuit shown in figure. Assume VA = ∞.

A:

Q: x(t)=3cos 50.Tt +10sin 300.rr +3cos100.zr 1. Find sampling frequeney and 2. Find Nyquest rate

A:

Q: 5:1 A A3 100Vrms Re Det a) Airdg b) Azrdg c) Agrdy d) Ayrdy e) Virdy f) Va rdg g. Piave

A:

Q: Explain this schematic

A: In above circuit we have connector connection with which they have connected with each other. The…

Q: Find transler fumction for Separatelu excited DC Mator

A:

Q: If the initial state for LFSR shown below [Q3 Q2 Q1 Q0] = [1010], what is the state after five clock…

A:

Q: A series RL circuit with R=10 2 and if 1=5 A and V=100 volt, with f=60 Hz then power factor will be…

A: For RL circuit, Impedance(Z) =voltage/current  Power factor = resistance/impedance.

Q: Zin Zin14.9-j13.5 Zin0.04+0.03 Zin 28.6+7.2 Zin-16-512 -j12.80 HH 13.6 0 o W Select the correct the…

A:

Filter

A filter is a device or process which removes some of the unwanted features or components like frequencies from a signal in signal processing. The feature of filters is the complete or partial suppression of some part of the signal, and filtering is a class of signal processing. This most often means removing some frequency bands or some frequencies. In the frequency domain, the filters do not exclusively act, especially in the image processing field many other targets for filtering exist. Without having to act in the frequency domain, the correlations can be removed for certain frequency components and not for others. The filters are widely used in electronics and telecommunication, in television, radio, radar, audio recording, music synthesis, control systems, computer graphics, and image processing.