2. Based on the number of hosts in the topology, you need to calculate the NIDS and FHID,LHID, BID, CSNM(custom subnet mask). 172.16.0.0/16 *... so/0/0 So/0/0 FO/O FO/O FO/1 Administration Research 135 Hosts Deployment 63 Hosts 33 Hosts Marketing 75 Hosts Sales 255 Hosts No. of Hosts 255 135 75 63 33 2 Custom Subnet mask Network ID First Host ID Last Host ID Broadcast ID

Q: 2. Given a network address of 118.0.0.0, 126 needed subnets and 131,070 needed usable host per…

A: Given: Given a network address of 118.0.0.0. , 126 needed subnets and 131070 needed usable host per…

Q: Configuring Inter-VLAN Routing. Legacy inter-VLAN routing (or per-interface inter- VLAN routing)…

A: a. List the commands including command syntax and prompt to configure a router for router-on a-stick…

Q: First, determine the class of the address that you are working with. Then, dissect the subnet mask…

A: "As per guidelines, I can only 3 questions from multiple questions, but I'm doing first five…

Q: 2b AS 2 2a 20 AS 1 AS 3 AS 5 5d AS 4 5b

A: a)The answer is eBGP. Reason: in this case eBGP is inter-routing protocol.Through OSPF , AS3 is…

Q: ridges are empty. List all ports on which a packet will be forwarded by bridges B1 and B2 for the…

A: We have a connection of multiple nodes with bridges and hubs. Here we need to find the path of ports…

Q: A small business has five departments, Accounting, Sales, Purchasing, Production, and IT. The number…

A: We must set up 6 subnets. 1 for each of the two routers and 5 for departments. 15 hosts are needed…

Q: Within this Wireshark screenshot, what is the value in the upper layer protocol of the IP packet…

A: within this Wireshark the value in the upper layer protocol of the IP packet header is

Q: Consider the below topology and Implement the given Routing Protocols on the topology using Cisco…

A: Introduction about EIGRP Routing protocol: The Enhanced Interior Gateway Routing Protocol (EIGRP) is…

Q: we obtain the following information from one router. What kind of routing protocol does it use?…

A: Here use ony Routing information protocol. we can use it wiht local area network for small ranges.…

Q: Suppose there is exactly one packet switch between a sending host and a receiving host. The…

A: Hello studentGreetingsIn computer networking, understanding the end-to-end delay of data…

Q: A network layer payload that is 60 bytes long is intended to be sent over a 10BaseT Ethernet be…

A: Solution:   Given data : Network layer payload is 60 bytes.

Q: From the given IP address 220.134.78.92 with the following number of host required: 32, 64 , 8 and…

A: Given source IP address is 220.134.78.92 It is a class C network and in this 24 bits are network id…

Q: uestion, you have been given the network address 199.11.55.0/24 to subnet and provide the IP…

A: Here is the detailed and simplified answer to the above listed problem statement:

Q: A host-to-host connection might be carrying several packets. Please provide me with a breakdown of…

A: In this answer, we will discuss the time it takes to process a load of products in a host-to-host…

Q: Find the Network address, subnet mask and broadcast address of the network in figure 1 and 2.…

A: Answer Figure 1:- ==> The given network address 10.0.0.0/8 ==> Start the assigning of network…

Q: Refer to the exhibit. R1 19 Hosts 6 Hosts 2 Hosts

A: IP address: It is a required for a device to send any file over internet .The computer, mobile…

Q: Consider the below topology and Implement the given Routing Protocols on the topology using Cisco…

A: Introduction about EIGRP Routing protocol: The Enhanced Interior Gateway Routing Protocol (EIGRP) is…

Q: Configure the network based on the table below.  Notice we are using different subnet masks on the…

A: Step 1: Configure Router Interfaces For each router (R1, R2, R3):Access the router's configuration…

Q: The goal of this assignment is to explore the network packets associated with several typical online…

A: Wireshark is an open-source network protocol analyzer widely used for monitoring and analyzing data…

Q: Suppose you have the following network requirements, for Given an IP address and mask of 9.0.0.0/8,…

A: Given: Suppose you have the following network requirements, for Given an IP address and mask of…

Q: Given the following diagram. S1, S2, and S3 are layer-2 switches. R1 and R2 are network layer…

A: As per our company guidelines only three sub parts will be answered. First question contains 4…

Q: Using the following topology, write the three routers R1, R2 and R3 routing table based on dynamic…

A: By using the following topology ,the three routers R1,R2 and R3 routing table based on dynamic…

Q: As a designer of a link-state routing protocol, how can you decide on the Age's value (large value…

A: In link state protocol age is called "time to live" means how much time the packet live in the…

Q: 1. How do you compare TCP connections with circuits in circuit switching that we covered in Chapter…

A: The above question is solved in step 2 :-

Q: The connection between all the devices of the network In a mesh topology is multipoint False True…

A: The connection between all the devices of the network in a mesh topology is multipoint is false…

Q: Q2. One mobile game sends status update to the server once in 200 minisec. On average, this status…

A: The bit rate is defined as the number of bits transferred in a certain amount of time. It is usually…

Q: In wireless LAN communication, MACA is widely used. In this protocol, in order to avoid collision, a…

A: Answer:-

Q: Consider the below topology and Implement the given Routing Protocols on the topology using Cisco…

A: Introduction about EIGRP Routing protocol: The Enhanced Interior Gateway Routing Protocol (EIGRP) is…

Q: 1. Below are the first 60 bytes of a TCP/IP packet captured by using Wireshark on an Ethernet…

A: TCP/IP packets are used to transmit data over networks. They consist of a series of fields, each…

Q: You have to configure the following: 1- Static Routing Protocol. 2- RIP (Routing Information…

A: Stаtiс  rоuting  рrоtосоls  аre  used  when  аn  аdministrаtоr  mаnuаlly  аssigns  the  раth  frоm…

Q: Design a topology for Bonsai Ltd in Packet Tracer, given the following scenario: Four branches…

A: Explain the functions of PCs,Servers,Switches and Routers.

Q: Hat A (MUIRICANT Grup member) Host C 日 Router A SERVER Host D Host B (Multicast group member)

A: .The arrangements of different systems in given picture is known as bus topology. Where different…

Q: You need to make a topology to generate 4 subnets, each with 64 hosts. Which prefix mask would you…

A: To generate 4 subnets, each with 64 hosts, you can determine the appropriate prefix mask by…

Q: A host-to-host link may carry numerous packets. Give me a breakdown of goods load processing time.…

A: According to the information given:-We have to define a host-to-host link may carry numerous…

Q: Scenario You work for a small company that wants to separate the Sales, Research and Development…

A: Given requirements are 3 separate networks for Sales ,Research &Development and Management…

Q: The functions of dynamic routing protocols are: O determining the default gateway O determining the…

A: Dynamic routing is a networking technique that provides optimal data routing.…

Q: TCP/IP model

A: Given :- In the above given question, the statement is mention in the above given question   Need to…

Q: What is the size of the multicast address space? Suppose that two multicast groups randomly choose a…

A: Part(a) Given that, a total of 32-4=28 bits are available for the purpose of multicast address. The…

Q: Le smallest MTU of any li n two hosts. Assume we th used in the previous e TU for all the path segme…

A: Path MTU: MTU or the Maximum transmission unit is the largest protocol data unit that one layer can…