2. An FM signal is defined as 12 sin(6 x 108 πt + 5 sin 1250 π t). The signal has a total power of 14 W, operating across a 90 2 load. Find a. The RMS signal voltage V₁ b. The RMS voltage at the carrier and each of the first four sets of sidebands c. For the first four sidebands, calculate the frequency of each sideband

2. An FM signal is defined as 12 sin(6 x 108 πt + 5 sin 1250 π t). The signal has a total power of 14 W, operating across a 90 2 load. Find a. The RMS signal voltage V₁ b. The RMS voltage at the carrier and each of the first four sets of sidebands c. For the first four sidebands, calculate the frequency of each sideband

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.1MCQ: The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax

See similar textbooks

Similar questions

choose the correct option for ac circuit
For the current waveform that shown in Figure below Find:- 1). Average value 2). R.M.S value 3). Form factor Current (A) ha 8 10 12 1-2
Channel 1 and Channel 2 Time (ms) Phase problem. In the above figure the time base is 1 ms/div, what is the period of the signal from Channel 1 in ms? What is the phase difference (in degrees) between the signals in Channel 1 and Channel 2? ms, _degrees Voltage (arbitrary units)
ASAP 20 minutes left
Please help. I need the answer for #2 thank you
A voltage wave of 250 kHz has a Vmax-5 V and Vmin=-35 V. The duty cycle of this wave is 0.875. This voltage waveform has been applied across a 2.5 µH inductor for a very long time so that steady state has been achieved. Diagrams of the wave parameters and circuit are shown in this figure: L What is the average voltage of this wave? Average voltage = 35 V Voltage (arb, unit) 1.25 Minimum current: -3.5€ Amps 1 0.75 0.5 0.25 0 4.25 05 Have you integrated the wave over full cycle? 4.75 4 -1.25 Vmax 0.5 Vmin What is the average current flowing through the inductor? Average current = 3.56 A 15 Period/s On average, there is no power consumed by the inductor. Have you considered this? What are the maximum and minimum currents that flow through the inductor? Maximum current: 0.50 Amps D= 25 TH TH Have you used the relationship for current and voltage in an inductor? Have you considered the slope of the current wave?
For the following waveforms, determine the average, effective, peak factor and form factor.D.)A square wave having a positive maximum value of Em and a negative maximum value of −Em.
In an experiment, the function generator is adjusted to generate a square voltage at a certain frequency. This voltage is displayed on an oscilloscope and the reading is 10 V peak-to-peak. The rms value of this voltage is .What will be the rms value of this voltage if the frequency is reduced to the half value? 3.536 Vrms . 3.536 Vrms O 5 Vrms . 1.7677 Vrms O 3.536 Vrms. 1.7677 Vrms O 5 Vrms . 5 Vrms ...... O 10 Vrms . 10 Vrms ......
In an experiment, the function generator is adjusted to generate a square voltage at a certain frequency. This voltage is displayed on an oscilloscope and the reading is 16 V peak-to-peak. The rms value of this voltage is .What will be the rms value of this voltage if the frequency is doubled? Select one: O 16 Vrms 32 Vrms O 8 Vrms . 8 Vrms ..... O 5.657 Vrms 5.657 Vrms ....... O 8 Vrms . 16 Vrms O 16 Vrms 8 Vrms ......
For the following waveforms, determine the average, effective, peak factor and form factor.G.)A semi – circular wave having a positive maximum value of Em and a negative maximum value of −Em.
For the below sinusoidal voltage trace displayed by the CRO, the time/cm switch is on 0.2ms/cm and the volt/cm switch is on 1 V/cm. a) the frequency will be Hz b) the r.m.s value will be In CRO the beam can also be shifted vertically by applving a suitable DC voltage to the
For the following waveforms, determine the average, effective, peak factor and form factor.E.)A triangular wave having a positive maximum value of Em and a negative maximum value of −Em.