2. An air-conditioning system requires air flow at the main supply duct at a rate of 180 m³/min. The average velocity of air in the circular duct is not to exceed 10 m/s to avoid excessive vibration and pressure drops. Assuming the fan converts 70 percent of the electrical energy it consumes into kinetic energy of air, determine the size of the electric motor needed to drive the fan and the diameter of the main duct Take the density of air to be 1.20 kg/m?. Note that Air Power of the fan is give by: AP = Qy Ah Where: Q = volume flow rate of air m'/s, y = specific weight of air, kN/m², Ah = pressure head, m %3D %3D %3D Ans: 618 mm

2. An air-conditioning system requires air flow at the main supply duct at a rate of 180 m³/min. The average velocity of air in the circular duct is not to exceed 10 m/s to avoid excessive vibration and pressure drops. Assuming the fan converts 70 percent of the electrical energy it consumes into kinetic energy of air, determine the size of the electric motor needed to drive the fan and the diameter of the main duct Take the density of air to be 1.20 kg/m?. Note that Air Power of the fan is give by: AP = Qy Ah Where: Q = volume flow rate of air m'/s, y = specific weight of air, kN/m², Ah = pressure head, m %3D %3D %3D Ans: 618 mm

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

In terms of the CAD and CAM ,computer aided .......and ......are respectively referred to
Compare and contrast various input devices in cad/cam sections.
How classification of separators is done? Explain in detail about 2 phase horizontal separator?
Differentiate the types of manipulator joint used for translational motion and rotary motion of a robot.
Direction: Analyze the given problems and provide the following: 1. Design the equivalent pneumatic and electrical circuit with complete labels. 2. Explain how the electrical circuit operates. Problem 1: It must be possible to operate the punching device from three sides. A notch is to punched in the workpiece by a pneumatic cylinder. The workpiece may be fed from any one of three work stations. The punching operation is to be triggered when 2 sensors emit a signal. The signaling elements a, b and c are installed for sensing. The cylinder returns to its retracted position when the part is pulled out of the device Positional Sketch: Cylinder
Identify the control system areas of the BMS.
Discuss the effect of atmospheric air entry in VCRS?
In GC with FID, three different parts of the machine have to have temperature control. Identify these and discuss their temperature requirements
What three simultaneous conditions must be satisfied for SCC?
Answer and draw what is ask.
Work #6: MISO DIGITAL SYSTEMS Drill Problems: (Energy Saving?) Do the sketch for an escalator system is designed to be turned ON if a person to enter is detected 1 meter from the entry and will turn OFF as soon as the last person on the escalator passes 1 meter from the exit.
Describe the operating principles of a knock sensor?