2. Air enters a 16-cm-diameter pipe steadily at 200 kPa and 20 °C with a velocity of 5 m/s. The air is heated as it flows, and leaves the pipe at 180 kPa and 40 °C. Q Air 200 kPa 20°C 5 m/s 180 kPa T°C a) Determine the volume flow rate of air at the inlet. b) Determine the mass flow rate of air at the inlet and outlet. c) Determine the volume flow rate of air at the outlet. d) Determine the velocity at the outlet.

Q: Given the multiview projection of the solid, draw the isometric view.

A: Given:To find:Draw the isometric view.

Q: What type of scale is 1:20? O Full Scale O Enlargement Scale O Reduction Scale O O O

A:

Q: Draw the orthographic views of the following isometric figure.

A:

Q: GIVEN THE ORTHOGRAPHIC VIEWS, CREATE AN ISOMETRIC SKETCH OF THE FOLLOWING OBJECT.

A: Find Create an isometric sketch of the given object on isometric paper.

Q: Draw the isometric and orthographic sketch of the given figure (in catia V5 ;no hand drawing );

A: isometric view

Q: 3. For the objects shown in isometric below, sketch the top, front, and right side views in the…

A:

Q: Sketch the isometric view Sketch the first angle orthographic view Note:use creo parametric to…

A:

Q: 1

A:

Q: The part below has a variety of features that are labeled as datum features. Assume all are primary…

A: A moment of inertia is a mass of the body when a body is rotating on an axis. The moment of inertia…

Q: For the given multiview projection, draw the corresponding isometric drawing. ME DA

A: For the given multi view projection, draw the corresponding isometric drawing.

Q: Given the multiview projection of the solid, draw the isometric view. HRP FRP F DA FRP PRP

A: Given the multiview projection of the solid, draw the isometric view.

Q: Circle the letter corresponding to the correctly aligned set of orthographic views. 1. 2. A 6:6 A E…

A: according to the drawing data we need to find, the right option. that represent the three…

Q: Please use the isometric graph paper in my picture to draw it to scale!

A: According o the given data Three orthographic views of the object are given  We need to draw The…

Q: Sketch a isometric drawing for each of the three sets of orthographic drawings

A: Given: A set of orthographic projections.

Q: sketch the orthographic view of the given figure below

A:

Q: Generate isometric drawing from multiviews using drawing tools or free - hand. Use approximate…

A: Isometric projection Isometric projection is a method for representing three-dimensional objects…

Q: Vega is a star that is 25 lightyears away. A spaceship is to travel to Vega at a speed of 0.625c. a.…

A:

Q: L. Sketch the objects shown using isometric, oblique, and one- or two-point perspective.

A: It is asked to draw isometric, oblique and one point perspective views

Q: The part below has a variety of features that are labeled as datum features. Assume all are primary…

A: A moment of inertia is a mass of the body when a body is rotating on an axis. The moment of inertia…

Q: Given the top and front views, sketch the right face.

A: According to the details provided in the question. Top view and front view is given we need to draw…

Q: 6 Using the drawing callout shown in Figure 5 below, which part(s) shown in Figure 4 would now…

A: According to the given dimensional tolerance for the part, the maximum and minimum allowable…

Q: State any three rules of orthographic parallel projection.

A: Orthographic parallel projection is a method of representing 3D objects normally by three 2D…