2. A wave winding must go at least ..... around the armature before it closes back where it started. (a) once (b) twice (c) thrice (d) four times

Q: Three generators connected in parallel are rated as follows: Generator 1: 100 MVA, 33 kV, reactance…

A: Given    Generator 1:Sbase old=100 MVAVbase old=33 kvReactance Zold=10 %New base quantitiesSbase…

Q: 4. A 107.6 MHz carrier is frequency modulate by a 7-KHz sine wave. The resultant FM signal has a…

A: We need to analyse the given frequency modulated signal .

Q: 1. A 5-KHz audio tone is used to modulate a 50-MHZ carrier causing a frequency deviation of 20 KHz.…

A:

Q: Example 26.23. A 10 kW, 250 V, d.c., 6-pole shunt generator runs at 1000 r.p.m. when delivering…

A:

Q: 4. For making coil span equal to a pole pitch in the armature winding of a d.c. generator, the back…

A:

Q: Figure P6.1-1 shows Fourier spectra of signals gi(t) and g2 (1). Determine the Nyquist interval and…

A:

Q: In a 12-pole triplex lap-wound d.c. armature,

A: option(d) 3600A

Q: 5. In the circuit shown below, if Ro is given, what value must R₁ have in order than the input…

A: The circuit diagram,The input resistance between the terminal is ,

Q: he equation of an angle-modulated voltage is = 10 sin (10%+3 sin 10%). What form of angle modula on…

A: Note: The frequencies  of the given equation are little blur in the image. So the question is solved…

Q: d. refer to (b), when the frequency of the test tone is changed to 7 kHz and the percentage of…

A: We need to find out the carrier swing for given modulation .

Q: 3. An FM transmitter delivers, to a 750 antenna, a signal of v = 1000 sin (10° t + 4 sin 10° t).…

A:

Q: 6. An eight-pole wound rotor induction motor op- erating on 60 Hz supply is driven at 1800 r.p.m. by…

A:

Q: 7. The substrate of MOSFET is normally connected to the Drain terminal. 8. In the actual…

A: Given  True or false question based on FET devices.  Please find the answer below.

Q: Determine the Nyquist sampling rate for the following signals: (a) 4 sinc(420πt); (b) 5 sinc²…

A: As per Bartleby guidelines, as more than 3 subparts are present in the question, only the first 3…

Q: 15. A factory takes a load of 2,400 kva at 0.6 lagging power factor. A synchronous motor having an…

A:

Q: E2.33 If the power supplied by the 3-A current source in Fig. E2.33 is 12 W, find Vs and the power…

A:

Q: DEGREE: ELECTRICAL ENGINEERING  SUBJECT/COURSE: AC CIRCUITS   NOTE: Please solve in this way.  1.…

A: In this question ,balanced delta connected load phase current is given...We have to find out line…

Q: A two-beam interferometer is illuminated with light of irradiance lo, assuming perfect splitting…

A: According to the question, a two-beam interferometer is illuminated with light of irradiance lo,…

Q: 5. A frequency-modulated signal, which is modulated by a 3-KHz sine wave, reaches a maximum…

A: We need to analyse the given frequency modulated signal .

Q: 1. The basic requirement of a d.c. armature wind- ing is that it must be (a) a closed one (b) a lap…

A: This is a problem of dc machines. The explanation is given in the next step

Q: 8. An AM transmitter has a 1-kW carrier and is modulated by three different sine waves having equal…

A:

Q: Vo 2R Io R 3R 4R by 2R 3R R Consider the network above, with I = 6A, Vo = 280V, and R = 22. a.…

A:

Q: 2. When the modulating frequency in an FM system is 400 Hz and the modulating voltage is 2.4 V. the…

A:

Q: 14. In a d.c. generator, directly proportional to the the generated e.m.f. is (a) field current (b)…

A: The given question is a MCQ and we have to choose the correct option.

Q: Example 26.28. A long-shunt compound-wound generator gives 240 volts at F.L. output of 100 A. The…

A: In this question,  We need to determine the efficiency of the long shunt DC compound generator.  We…

Q: 3. Now suppose that an inductor L and a capacitor C are connected such that the dV I take the C'…

A: An inductor is a passive element used for storing energy in a magnetic field. The capacitor is also…

Q: A 400V, 3 - phase, 4 wire, star - connected system supplies three resistive loads of 15kW, 20kW and…

A: In this question,  3 phase 4 wire system is given.  If each phase power is given for only resistive…

Q: Voltage-Multiplier Circuits 47. Determine the voltage available from the voltage doubler of Fig. 123…

A: By analyzing the figure 123 Diode D1 = forwrd biased Diode D2=reverse biased The circuit for the…

Q: 1. Calculate the bandwidth of an FM system (using Bessel The Table) when the maximum deviation (o)…

A:

Q: Voltage-Multiplier Circuits 1. Determine the voltage available from the voltage doubler of Fig. 123…

A: Since, it has been only asked to solve problem 47 in this given question,  thus solving the relevant…

Q: 1. To safeguard the MOSFETS, an electronic device called Zener diode is 2. The channel of MESFET…

A: In this question we will answers question related to MOSFET.... Note :- as per our guideline , I am…

Q: 9. A 1-MHz, 40-V peak carrier is modulated by a 5-kHz intelligence signal so that m = 0.7. This AM…

A: We need to find out the power for different components of modulated signal .

Q: 3. The d.c. armature winding in which coil sides are a pole pitch apart is…

A:

Q: 16. The commercial efficiency of a shunt gen- erator is maximum when its variable loss equals…

A: The given problem is a shunt generator problem. The explanation is given in the next step.

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.