Answered: 2. A Torque of magnitude T = 900 N.m is… | bartleby

Related questions

Question

2. A Torque of magnitude T = 900 N.m is applied at D as shown. Knowing that the
diameter of shaft AB is is 60 mm and that the diameter of shaft CD is 45mm, determine
the maximum shearing stress in (a) shaft AB, (b) shaft CD.
A
որոշու
B
40 mm
100 mm
Figure 2
T = 900 N · m

Expert Solution

Step by step

Solved in 6 steps with 6 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

A sphere of copper has a radius of 8.00 cm and is compressed uniformly by a force of 5.00 × 108 N. The bulk modulus for copper is 140 x 10⁹ N/m². Calculate the sphere's change in volume AV after compression. Calculate the sphere's final radius R. AV = R = 3.81 x107 Incorrect 0.075 -7 Incorrect m³ m
The solid circular rod has a cross-sectional area of 410 mm². It is subjected to a uniform axial distributed loading along its length of w= 10 kN/m. Two concentrated loads also act on the rod: P = 3 kN and Q = 7 kN. Determine the normal stress in the rod at x = 0.7 m. Assume a = 0.7 m and b = 1.1 m. a Answer: 0 = i B b MPa Q
Example 2: the ankle joint therefore pushes upward on the bottom of the tibia with the force of 2800 N while the top end of the fibia must feel a net downward force of approximately 2800 N the fibia has a length of 0.40m. an average inner diameter of 1.3cm and average outer diameter of 2.5cm find the compressive stress in the tibia? 750 N 2030 N 25 cm Cros secion
1
1
1
2
Two wooden members, each having a width of b = 2.4 in. and a depth of d = 0.8 in., are joined by a simple glued scarf joint. Assume B = 47°. If the allowable shear stress for the glue used in the joint is 94 psi, what is the largest axial load P that may be applied? Answer: P = i ! Ib
1
Situation: A simply supported rectangular beam 400 mm wide having an effective depth of 550 mm carries a total factored load of 137 kN/m on a 6 m clear span. It is reinforced with 4914 mm² of tensile steel, which continues uninterrupted into the supports. Use f'c = 28 MPa. What is the factored shear at critical section? a. 616.50 kN b. 335.65 kN C. 541.15 kN d. 411.00 kN What is the Ultimate shear strength provided by concrete only? a. 148.4 kN b. 180.2 kN C. 178.1 kN d. 197.9 kN Throughout what part of the beam is web reinforcement is required? 3m 1.5 m c. 2.46 m d. 0.65 m a. b.
2
An electric power transmission pole is 12 m above ground level and embedded 2 m into the ground. The butt diameter is 450 mm and the tip diameter (the top of the pole) is 320 mm. The weight of the pole, cross arms, and wires is 33 kN. Assuming the pole transmits the load as a point load, find the change in vertical stress in kPa at 1 m depth. a.17.8 b.63.0 c.393.9 d.3.9

SEE MORE QUESTIONS