2. A theodolite is set up at one end of a level base line 150.0 m long. The line is marked by stakes at every 30.00 m and a stadia rod is held at each stake. The stadia intercept at each location of the rod is observed as follows: 0.302, 0.600, 0.899, 1.207 and 1.506 meters, respectively. Compute the stadia interval factor for each distance and also determine the averaevalue of K.

Q: Why is drainage clogging occur?

A: 1)Damaged Pipes-Another major cause of blocked drains is broken pipes. For water to flow freely, it…

Q: Write the ten main divisions of The Federal Highway Administration Standard Specifications?

A: The Federal Highway Administration (FHWA) is a division of the United States Department of…

Q: What is internal drainage and what can it result in?

A: Drainage is indeed the natural or artificially elimination of surplus water from the surface of the…

Q: Define the term Post Completion?

A: The term post-completion can be defined as the final stage of the project that comes after the…

Q: Describe the responsibilities of the inspector during construction.

A: Everyone wants a safe living and working place. For meeting these requirements of people, it is to…

Q: In detail describe what are standpipes.

A: This question is related to the Pipe system from Environmental engineering from Civil Engineering.…

Q: How does a plumbing contractor know what slope is required on sanitary piping installations?

A: The slope changes as the temperature changes in a sanitary installation.

Q: 134 438 124 295 408 139 What is the correct phasing design for the 87 318 163

A: Given a four-legged intersection as shown below Required: To choose correct phasing design from the…

Q: Building codes are concerned primarily with public safety, an provide maximum design and…

A: Solution; I want to tell you that public safety and other considerations are always in the building…

Q: How are curbs measured?

A: A curb is the edge where a raised sidewalk or road median meets a street or other roadway. Curb…

Q: A building has an area of 16656 ft2. What is the minimum number of roof drains required?

A: The area of the building = 16656 ft2 We need to calculate the minimum number of drains required.

Q: Describe the statement unforeseen underground conditions?

A: unforeseen underground conditions These usually refers to the conditions when the underground is not…

Q: Describe in detail a typical layout of an escalator systems

A:

Q: Describe the Sources of Groundwater Contamination.

A: Groundwater is defined as the water below the surface of water which is stored in the spaces . It is…

Q: Describe the Effects of Drainage.

A: The drainage can be defined as it is an artificial or a natural process of discharging surface and…

Introduction to Engineering Design

Students are often confused with engineering and design. The term engineering design has two words with different meanings, engineering, and design. The term engineering implies applications of laws and principles of science to design and analyze physical structures and components. In civil engineering, students apply the concept of physics and chemistry to design and build structures and buildings. In engineering disciplines, the term design means determining the dimensions, loads, and associated influences on the component due to the applied loads such as stresses and deformations. The estimation of such parameters is crucial to make the component or structure foolproof.