2. A simple-ideal Brayton cycle using air as the working fluid has a pressure ratio of 8. The minimum and maximum air temperatures in the cycle are 300 and 1500 K respectively. Assume constant specific heat of air at 1005 (J/kg.K) throughout the cycle, determine: a. The net work output. b. The thermal efficiency. c. The second-law efficiency of the cycle if the heat is added at 1800 K.

2. A simple-ideal Brayton cycle using air as the working fluid has a pressure ratio of 8. The minimum and maximum air temperatures in the cycle are 300 and 1500 K respectively. Assume constant specific heat of air at 1005 (J/kg.K) throughout the cycle, determine: a. The net work output. b. The thermal efficiency. c. The second-law efficiency of the cycle if the heat is added at 1800 K.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Solidworks
Each cylinder of six cylinder internal combustion engine has a diameter of 60 mm and a stroke length of 400 mm. What is the engine capacity in litres? Give your answer to 2 decimal places.
SHOW YOUR COMPLETE SOLUTION
A5C) Concurrent forces.. O a. act on the same line O b. act on the same plane O c. pass through same point O d. None of the these a hp
resolve, results not similar to given solutions
1. Round off to FOUR DECIMAL PLACES for all calculations made.
A ball with mass 0.65 kg is thrown upward with initial velocity 5 m/s from the roof of a building 100 m high. Assume there is a force due to |v| air resistance of magnitude directed opposite to the velocity, where the velocity v is measured in m/s. 30 NOTE: Use g=9.8 m/s² as the acceleration due to gravity. Round your answers to 2 decimal places. a) Find the maximum height above the ground that the ball reaches. Height: m b) Find the time that the ball hits the ground. Time: seconds c) Use a graphing utility to plot the graphs of velocity and position versus time.
Show the complete solution and use whole decimal places in solving.
Fluid Force. A swimming pool is filled with fresh water to a depth of 7 feet measured at the deep end. There is not enough water in the pool to reach the shallow end. Assume that the pool is constucted using right angles, except where the bottom of the pool meets the end walls. Use Ah for the height of a typical strip across the face of the wall. 6. The weight density of water is 62.4 lb/ Your anwers should have units: pounds. 4 ft 18 ft 24 ft Declare your variable(s) here. Show your reasoning below: a) find the force on the typical horizontal strip (red) ? b) write an integral for the total force on the (left) wall of the pool
Please solve part B only
c) the diameter of the tank in mm 671.8 O 725 714
Fast plzz