2. A lighting load of 1500 kW and a motor load of 2200 kW at a p.f. of 0-707 lagging is supplied by two alternators running in parallel. One machine supplies 2000 kW at a p.f. of 0-8 lagging. Find the load and p.f. of the second machine. [1700 kW; 0-924 lagging]

2. A lighting load of 1500 kW and a motor load of 2200 kW at a p.f. of 0-707 lagging is supplied by two alternators running in parallel. One machine supplies 2000 kW at a p.f. of 0-8 lagging. Find the load and p.f. of the second machine. [1700 kW; 0-924 lagging]

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

If the load is connected to the generator thgrough an inductive line and the voltage at the load side is the same as the voltage at the terminals of the generator, which of the following must be true? O A. The reactive power is flowing from the generator to the load and from load to the generator at the same time. O B. The load is disconnected, and no power is delivered to the load. O C. The load has a poor power factor and it's absorbing too much reactive power. O D. None of the other choices are correct O E. The generator is unable to produce reactive power; therefore, the reactive power is flowing from the load to the generator.
Please i want the answer son as possible
4. Two 3300 V star-connected alternators running in parallel supply the following loads : 800 kW at unity p.f.; 600 kW at p.f. 0-8 lagging; 400 kW at p.f. 0-707 lagging The armature current of one machine is 150 A at p.f. 0-85 lagging. What is the armature current, output and p.f. of the other machine? [200 A; 1071 kW; 0-937 lagging]
The maximum efficiency of 10Kw D.C generator is 98% and occurs at 80% of full load. Find the total copper losses at rated load
A three-phase star-connected alternator delivers at rated load a current I = 200 A under a voltage of 5 kV-50 Hz (between phases). The load is inductive of power factor equal to 0.87, the resistance of each stator winding is 0.292 and the speed of the rotor is n = 750 r.p.m. The sum of the constants losses and the stator Joule's losses and the rotor Joule's losses is 55 kW. The no load test, at rated frequency, gave: E-4200 V (between phases) for an excitation current lexc = 40 A. The short-circuit test, for an excitation current lexc = 40 A, gave a short-circuit current in the stator windings Ise =2.5 kA. 1- Calculate the numbers of poles of the alternator. 2- Calculate the synchronous reactance (X). 3- Calculate the electromotive force of the alternator (E) between phases for the same excitation current. 4- Calculate the power absorbed by the alternator (Pa).
The shaft of a three-phase synchronous generator is rotating at 3000 RPM. This generator is inducing a torque of 100.0 N.m under a certain load. If the copper losses are neglected, and the sum Praw + Pcore + Pstray = 7854 Watt, find the efficiency of the generator under those conditions. Answer: The % efficiency is:
QI/ Caleulate the voltage per phase for a 3-phase 1500 rpm, 4-pole alternator having a 16 conductors per slot connected in two layers. The slots per pole per phase are 8 and the coil span is 20 slots. The phase spread is 60° and the flux per pole is 25-8 x 1o weber.
e = 0 Q1: What does happen if we change two currents? a. Q2: What does happen if we have a three-phase four poles machine? Q3: What does happen if we have a two-phase two poles machine? e = 0 Q4: What does happen if we apply a capacitance in phase b and then use same voltage for both phase. Dr. Ali Ki. pw --
What is the average Power at maximum resistance? Why? What is the effect to the voltage and current when increasing the load resistance?
Please quick solution
Calculate the voltage per phase for a 1500 rpm, 4 pole alternator having a double layer winding with 16 turns per coil. The slots per pole phase are 8 and the coil span is 20 slots. The phase spread is 60o and the flux per pole is 25.8 milli webers.
A 2MVA, 2.3kV 3-phase Y-connected alternator operates at rated kVA at a power factor of 80%. The DC armature winding resistance between terminals is 0.08 ohm. The field takes 70A at 125V from an exciter equipment. Friction and windage loss are 20kW, iron losses 36kW and stray load losses are 2kW. Calculate the efficiency of the alternator. Assume the effective armature winding resistance is 120% of the DC resistance.