Answered: 2. (a) Find out the modulation index of…

2. (a) Find out the modulation index of the following signal? $(t) = 19 cos 1000nt + 3cos10nt cos1000nt + 3sin10nt cos1000nt + 2 cos25ntcos1000nt What is the bandwidth of this modulated signal?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Use ONLY 1-to-4 demultiplexers to implement a 1-to-8 demultiplexer. Avoid any redundancy by clearly…

Q: Please assist with question 1 with details on how to do it.

A: Given: To do: Identify all the blocks of Digital communication system and describe their operation.

Q: Do the following binary subtraction: 111001110.11111- 010000000.01111 (The final answer must be…

Q: Electrical Compare continous and procedural assignment in Verilog code.

A: Verilog is Hardware Description language . The memory and array declaration in Verilog is static in…

Q: High speed I/o lines have. Option 1: programmable edge detection Option 2: All Option 3: software…

A: Here we have to explain the functions of High speed I/O lines.

Q: Question 2 Q. Calculate in binary 11111.11/11111.1*111.1

A: Given, 11111.11/11111.1*111.1 According to BODMAS, D means division and M means multiplication.…

Q: Show how the following decoders can be formed using decoder expansion.complete the decoder diagrams.…

Q: During the execution of an OUT instruction, the /0/M signal will Go low. Tristate. Not be used. Go…

A: Io/M is an active low signal means it can be activated by providing thr low input

Q: lo avold corruption during transmission, the code-word snould be Select one: O a. None of the…

A: The code-words should be far apart from one and another as possible So even when the vectors…

Q: In digital communication system, smaller the code rate, are the redundant bits. Select one: O a.…

A: Huffman coding Technique is adopted for constructing the source code with minimum redundancy.

Q: The frequency shift keying is based on a digital carrier. a sophisticated digital modulation…

A: Frequency shift keying (FSK) :- It is a technique of frequency modulation in which the frequency of…

Q: In your own words, explain why a good linearity is desired in most of the sensors and. Please be…

A: The following question is based on sensors. A sensor is a device that converts a signal from one…

Q: Hello, Not sure if this is possible but am i able to delete his answer from the system?

A: The solution is provided in the following section.

Q: Quèstion 20 Consider a binary code 8,4,-2,-1, The decimal equivalent to the 8,4,-2,-1, coded number…

Q: Multiply the following BINARY NUMBERS 10001.0001 X 101.11 (Note: The problem should be solved in…

A: First multiplying both the numbers without decimal and then adding the decimal.

Q: Answer it ASAP..

A: Two way multiplexer It is defined as 2n×1 mux Here n=1 that means one selected line with this MUX…

Q: Multiply the following BINARY NUMBERS 11001.0111 X 110.01 (Note : The problem should be solved in…

A: We need to multiply the given binary numbers.

Q: What is meant by CRT ?

A: In this question we need to answer What is meant by CRT .

Q: "Write a program to evaluate the following arithmetic statement X = [A (B + C) - D] / (E + F - G) i)…

A: The given arithmetic statement is, X = [A * (B + C)-D] / (E+ F - G)

Q: Variable name must start with: ONumber. OCharacter. O Function. OOne of above.

Q: 6. A digital signal is sent using a Hamming code for error detection and correction. The signal…

A: The parity code is checked as shown below.

Q: 2. If the values of the date select lines (control inputs) A and B are 0 and 1 respectively, and…

Q: d. refer to (b), when the frequency of the test tone is changed to 7 kHz and the percentage of…

A: We need to find out the carrier swing for given modulation .

Q: Draw and explain the working of BCD counter along with truth table and timing diagram.

A: We need to design a BCD counter which can count from 0 to 9 only. Now the truth table will be

Q: 6. Convert (-00101001.0011)2 to its equivalent octal and hexadecimal representation. Show all…

Q: Add the following BINARY NUMBERS 101110111.10111 + 10100000 1.110 10 (Note: The problem should be…

A: The binary number system is a base-2 number system. So the numbers are represented using 1's and…

Q: Data bus has communication type: O A. none of the options O B. Simplex C. Full Duplex O D.…

A: Data bus is bidirectional ( two way ) of communication. Simplex are generally known as the…

Q: If retransmission is not possible, is Automatic Repeat Request (ARQ) an effective correction…

A: Automatic Repeat Request (ARQ) is also known as Automatic Repeat Query. In a two-way communication…

Q: The signals shown in the following figures are orthonormal. 1 1/2 1/2 1 a. True O b. False

Q: QUESTION 27 During the execution of an OUT instruction, the IO/M* signal will O Tristate. Not be…

A: During the execution of out instruction ,

Q: B) Differentiate between Shot, Thermal and Flicker noise.

A: The unwanted part of signal is called noise. Noise is equal to standard deviation of signal.…

Q: Suppose you wish to increase the maximum clock frequency of the following circuit (without…

A: Given circuit A pipelined computer usually has "pipeline registers" after each stage. These store…

Q: 12V You To=3 P= ? re si I= ? P= ?

Q: The data recording space on magnetic tape between the blank intervals is known as a/ an: Block…

A: Magnetic tape- The magnetic tape is coated with a material (iron Oxide or Chromium diode) that…

Q: QUESTION 19 The program which handles an interrupt is called the: O BIOS Int ox ISR IRQ QUESTION 20…

A: Dear student as per guidelines we are allowed to answer only first 3 MCQ, but for you I have…

Q: Do the following binary subtraction: 110011010.00011- 001001011.00110 (The final answer must be…

Q: The frequency shift keying is based on a digital carrier. a sophisticated digital modulation…

A: The frequency shift keying is the technique for modulation in which the carrier signal is modulated…

Q: 3. Design an 8:1 multiplexer using two 4:1 multiplexer.

A: An 8 : 1 multiplexer, has 8 inputs (i.e I0, I1... I7) and only one output i.e F. To implement 8 :…

Q: _______________________ register can be used to store base address. a. IP b. SS c. BP d. SP

A: The explanation is as follows.

Q: 1) Convert the 8,4,-2,-1 sequence (01101011)84-2-1 to decimal

A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions…

Q: The signal shown in the following figure is a basis function. -T- 1/2 1 -1 -2 -3 O a. True O b.…

A: To check the given function is basis or not we find the energy of the given signal if it energy is…

Question

I will upvote for correct answer, please answer fast.

2. (a) Find out the modulation index of the following signal?
$( t) = 19 cos 1000nt + 3cos10nt cos1000nt
+ 3sin10nt cos1000nt + 2 cos 5atcos1000nt
What is the bandwidth of this modulated signal?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Digital Modulation Scheme (Amplitude-Shift Keying [ASK], Phase-Shift Keying [PSK], Frequency-Shift Keying [FSK])

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Please do all parts and fast and correctly
Question 2
29#1 I am trying to understand how to think these problems through and how to do them. Please write step by step explanations so I can follow with the thought process! Thank you! :)
design a two-way traffic light system with prototype using 4-bit down counter circuit. use 7-segment as an output to represent the timer.i need help.. pls make a circuit diagram for this. i will do this on the breadboardand also explain how u did it. thank youthe photo attached is how i will do it
Q29) The line encoder that uses three levels is---- a. None of the mentioned b. On-off c. Unipolar RZ d. RZ-AMI This multiple choice question from DIGITAL COMMUNICATIONS course.just write for me the final answer.
This multiple choice question from DIGITAL COMMUNICATIONS course.just write for me the final answer. 12)If the sampling frequency is 1 KHz, then the number of samples in 5 minutes is equal to a. 300000 b. 5000 c. 1000 d. none of the mentioned
tal Laser Based Interferometers are used to measure air velocity and pressure. O a. False O b. True The ratio of output to input of a system is known as Transfer function. Select one: O True O False Select the simple system from the following. O a. Lamp with on/off switch O b. Air conditioner O. Closed loop room heating system O d. Speed control of Motor
Alert dont submit AI generated answer.
please include full solutions and provide explanation. will give thumbs up for complete answer
Please give the answer to this question correctly. Please give full solution with correct answer and make it very detailed.
Multiply the following BINARY NUMBERS 10011.01 11 X 100.01 (Note : The problem should be solved in separate paper with steps and scanned copy should be submitted along with other answers The final answer must also be entered in the boxes below. Enter only one bit in a box and fill the unused boxes if any, with zeros) Answer - Integer part = Answer - Fractional part=
i need the answer quickly